Peugeot 407 C 2006 Owner's Manual

Practical information106 -
Fitting a wheel
 Position the wheel.
 Tighten the bolts by hand.
 Partly tighten the bolts using the
wheelbrace.
 Fold the jack and remove it.
 Fully tighten the bolts using the
wheelbrace.
 For vehicles with alloy wheels, re-
fit the trim covers.
 Put the tool holder back in posi-
tion. This helps to keep the boot
floor in its correct position, to pre-
vent any deformation of the floor
when loaded.
 Tighten the spare wheel securing
strap to prevent noise and for your
safety in the event of impact. Punctured tyre warning
light
Information on the instrument
panel:
Reminder:
for your safety, always
change a wheel:
- on level, stable, non-slippery ground,
- with the handbrake applied,
- with first or reverse gear engaged (position P for the automatic gear-
box),
- never go underneath a vehicle which is supported only by a jack.
Tyre under-inflation
detection system
warning light
These original wheels are fitted with
a pressure sensor (see paragraph
"Tyre under-inflation detection"). The
alarm which detects the removal or
absence of a wheel fitted with the
indicator sensor signals the anom-
aly. Have the wheel repaired and
checked by a PEUGEOT dealer.
After changing the wheel:
- have the tightening of the bolts and
the tyre pressure of the spare wheel
checked as soon as possible.
- have the punctured wheel repaired and refit it to the vehicle as soon as
possible.
- have the spare wheel checked and replace it in its boot recess.
Tools available
The following tools are located in
the holder in the centre of the spare
wheel:
1 -
Wheelbrace.
2 - Wheelbrace extension.
3 - Jack.
4 - Removable towing eye.
5 - Alloy wheel trim cover tool.
6 - Centring guide.
Removal
 For vehicles with alloy wheels, re-
move the trim covers using tool 5.
 Loosen the wheel bolts.
 Place the jack 3 in one of the four
locations underneath the vehicle
(the nearest one to the wheel to
be changed).
 Extend the jack using the wheel-
brace 1 and the extension 2. 
Remove one upper wheel bolt
and install the centring guide 6 in
its place.
 Unscrew the other bolts and re-
move the wheel.

107Practical information-
Bolt covers
Alloy wheel bolts are covered by
chrome trims.
Use the yellow tool 5 to remove the
trims before slackening the bolts.
Fitting the spare wheel
If your vehicle is fitted with a steel
spare wheel, when fitting it, it is nor-
mal when tightening the bolts to no-
tice that the washers do not come
into contact with the rim. The spare
wheel is secured by the cone shape
of each bolt.
PARTIAL REMOVABLE
CLOSER*
The partial removable closer is a cov-
er which is fixed onto the air intake
grille to prevent the accumulation of
snow due to direct splashes.
Once it has been fitted on your vehi-
cle, it is imperative that it is removed
when the ambient temperature con-
ditions rise above 10 °C again.
Contact a PEUGEOT dealer.
* According to country.
Special features of alloy
wheels Anti-theft bolts
Your wheels are fitted with anti-theft
bolts (one per wheel), placed under
chrome trims which must be removed
using tool
5, before the bolts are un-
screwed using the anti-theft socket
and the wheel brace 1.
Fitting snow tyres
If you fit snow tyres mounted on steel
wheels onto your vehicle, it is es-
sential to use special bolts available
from your PEUGEOT dealer. Note:
the anti-theft socket
was given to you on delivery
of your vehicle with the dupli-
cate keys and the confiden-
tial card. Make a careful note of the
code number engraved on the head
of the anti-theft socket. This will en-
able you to obtain a duplicate anti-
theft socket from a PEUGEOT dealer.
You are advised to do the same for
the duplicate keys and not to leave
the confidential card in the vehicle.

107Practical information-
Bolt covers
Alloy wheel bolts are covered by
chrome trims.
Use the yellow tool 5 to remove the
trims before slackening the bolts.
Fitting the spare wheel
If your vehicle is fitted with a steel
spare wheel, when fitting it, it is nor-
mal when tightening the bolts to no-
tice that the washers do not come
into contact with the rim. The spare
wheel is secured by the cone shape
of each bolt.
PARTIAL REMOVABLE
CLOSER*
The partial removable closer is a cov-
er which is fixed onto the air intake
grille to prevent the accumulation of
snow due to direct splashes.
Once it has been fitted on your vehi-
cle, it is imperative that it is removed
when the ambient temperature con-
ditions rise above 10 °C again.
Contact a PEUGEOT dealer.
* According to country.
Special features of alloy
wheels Anti-theft bolts
Your wheels are fitted with anti-theft
bolts (one per wheel), placed under
chrome trims which must be removed
using tool
5, before the bolts are un-
screwed using the anti-theft socket
and the wheel brace 1.
Fitting snow tyres
If you fit snow tyres mounted on steel
wheels onto your vehicle, it is es-
sential to use special bolts available
from your PEUGEOT dealer. Note:
the anti-theft socket
was given to you on delivery
of your vehicle with the dupli-
cate keys and the confiden-
tial card. Make a careful note of the
code number engraved on the head
of the anti-theft socket. This will en-
able you to obtain a duplicate anti-
theft socket from a PEUGEOT dealer.
You are advised to do the same for
the duplicate keys and not to leave
the confidential card in the vehicle.

Practical information108 -
CHANGING A FRONT BULB
Handle the bulbs with a dry cloth.2 - Side lights:
W 5 W (COOL BLUE ).
 Turn the access cap a quarter
turn, remove the bulb and change
it.
3 - Direction indicators:
PY 21 W (DIADEM ).
 Turn the access cap a quarter
turn,
 Remove the bulb holder.
 Change the bulb.
4 - Front fog lamps: H11-55 W.
The headlamps are fitted with poly-
carbonate glass with a protective
coating. Do not clean them with a dry
or abrasive cloth, nor with a deter-
gent or solvent product.
Ensure that the liquid used to fill the
wash-wipe and headlamp wash res-
ervoir is of good quality. Integrated direction indicator side
repeaters

Push the repeater forwards or
backwards and release it.
 Unclip the repeater and change it.
Repeaters can be obtained from a
PEUGEOT dealer.
Front lights
In the engine compartment, remove
the cover secured by one or two but-
terfly screws, a plastic retainer clip
and two quarter turn screws.
1 - Dipped beam and main beam headlamps:
D1S-35 W xenon bulb.
WARNING: RISK OF
ELECTROCUTION Coloured bulbs (side lights
and direction indicators)
must be replaced with bulbs
of identical specification and
colour.
In certain climatic conditions
(low temperature, humidity),
condensation on the inside
surface of the headlamp
glass is normal; it disappears a few
minutes after the lights are switched
on.
Xenon bulbs must be replaced by a
PEUGEOT dealer.

109Practical information-
CHANGING A REAR BULB
1 - Direction indicators: W 16 W.
2 - Fog lamps: P 21 W.
3 - Reversing lights: P 21 W.
4 - Brake lights/side lights:
P 21/5 W. 
Fold down the panel to gain
access to the light.
 Unscrew the 2 light fixing nuts
inside the boot.
 Disconnect the connector.
 Pull the light towards the outside.
 Unscrew the bulb holder sleeve a
quarter of a turn.
 Unscrew the faulty bulb and
change it.
 Screw in the bulb holder sleeve a
quarter of a turn.
 Put the light back in place from
the outside.
 Reconnect the connector.
 Screw on the 2 light fixing nuts
inside the boot. When refitting,
ensure that the light is positioned
and fixed correctly. Number plate lights:
W 5 W.
 Remove the transparent cover
using a screwdriver.
 Change the faulty bulb.
Third brake light: diodes.
Contact a PEUGEOT dealer for
replacement.

Practical information110 -
CHANGING A FUSE
The fuse boxes are placed in the
glovebox (passenger side), in the
engine compartment (left-hand side)
and in the left boot trim.
Fascia fuses
To access the fuses, open the cover
of the storage compartment on the
driver’s side. Tilt the fuse box down-
wards.
Replacing a fuse
Before replacing a fuse, the cause of
the incident must be found and recti-
fied. The fuse numbers are indicated
on the fuse box.Always replace a faulty fuse
with a fuse of the same rat-
ing (same colour). Use the special pliers located on the
support next to the fuse box, this
support also contains the replace-
ment fuses.
Fuse N° Rating FunctionsG29 - Not used.
G30 5 A Heated rear screen.
G31 5 A Tyre under-inflation detection, CD changer.
G32 - Not used.
G33 5 A Power steering electropump unit, dual-function
brake switch.
G34 5 A Dual-function brake switch, automatic gearbox
relay.
G35 5 A
Steering wheel angle sensor and ESP gyrometer senso r.
G36 25 AHi-Fi amplifier.
G37 15 A Automatic gearbox.
G38 20 A Heated seats.
G39 30 A Passenger seat memory unit.
G40 30 A Driver's seat memory unit.

Practical information112 -
Engine compartment fuses
To access the fuses located in the
engine compartment (next to the bat-
tery), remove the battery cover and
unclip the fuse box cover.
Close the fuse box cover carefully
and refit the battery cover when you
have finished.Fuse N° Rating Functions
1 20 A Engine control unit, fan assembly relay supply.
2 15 A Horn.
3 10 A Wash-wipe pump.
4 20 A Headlamp wash pump.
5 15 A Fuel pump, engine management actuators
(air flow sensor, solenoid valves, ...).
6 10 A ESP control unit, engine coolant level sensor.
7 10 A Automatic headlamp adjustment.
8 20 A Starter coil.

113Practical information-
Fuse N° RatingFonctions
9 10 A Directional headlamps control unit, additional heating swi
tching and protection control unit,
clutch switch.
10 30 A Engine management actuators (ignition coil, injectors, thermostat
s, solenoid valves, oxygen
sensors), diesel additive pump, fuel pump, engine control unit , Blow-by heater.
11 40 A Air conditioning blower.
12 30 A Windscreen wipers.
13 40 A Built-in systems interface supply (ignition positive).
14 30 A Not used.
The electrical system of your
vehicle is designed to oper-
ate with standard or optional
equipment.
Before installing other elec-
trical equipment or accessories on
your vehicle, contact a PEUGEOT
dealer. PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installa-
tion of accessories not supplied and
not recommended by PEUGEOT
and not installed in accordance with
its instructions, in particular where
the equipment in question consumes
more than 10 milliamperes.The maxi-fuses provide additional
protection for the electrical systems.
All work must be carried out by a
PEUGEOT dealer.

Practical information110 -
CHANGING A FUSE
The fuse boxes are placed in the
glovebox (passenger side), in the
engine compartment (left-hand side)
and in the left boot trim.
Fascia fuses
To access the fuses, open the cover
of the storage compartment on the
driver’s side. Tilt the fuse box down-
wards.
Replacing a fuse
Before replacing a fuse, the cause of
the incident must be found and recti-
fied. The fuse numbers are indicated
on the fuse box.Always replace a faulty fuse
with a fuse of the same rat-
ing (same colour). Use the special pliers located on the
support next to the fuse box, this
support also contains the replace-
ment fuses.
Fuse N° Rating FunctionsG29 - Not used.
G30 5 A Heated rear screen.
G31 5 A Tyre under-inflation detection, CD changer.
G32 - Not used.
G33 5 A Power steering electropump unit, dual-function
brake switch.
G34 5 A Dual-function brake switch, automatic gearbox
relay.
G35 5 A
Steering wheel angle sensor and ESP gyrometer senso r.
G36 25 AHi-Fi amplifier.
G37 15 A Automatic gearbox.
G38 20 A Heated seats.
G39 30 A Passenger seat memory unit.
G40 30 A Driver's seat memory unit.

111Practical information-
Fuse N° RatingFunctions
F1 15 A Not used.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners control unit.
F4 10 A Automatic gearbox switch, diagnostic socket, electrochromatic mirror.
F5 30 A Driver and passenger electric windows.
F6 30 A Sunroof.
F7 5 A Glove box light, map reading lights, courtesy lights, courtesy mirro rs.
F8 20 A Multifunction display, audio equipment, top-of-column, trail
er fuse box (accessory), alarm,
alarm siren.
F9 30 A Front lighter, 12 V rear socket, glove box light, map reading
lights, courtesy lights, courtesy
mirrors.
F10 15 A Tyre under-inflation detection, CD changer.
F11 15 A Diagnostic socket, ignition switch.
F12 15 A Trailer fuse box (accessory), parking assistance control unit supply, pa
ssenger seat memory
unit, rain and brightness sensor, alarm.
F13 5 A Windscreen wipers relay control, engine fuse box 2.
F14 15 A Driver's seat memory unit, instrument panel, air bags and pre-tensio
ners control unit, air
conditioning control panel, seat belt fastening management control unit, steering wheel ad-
justment switch, hands-free kit.
F15 30 A Locking and deadlocking.
F16 - PARC shunt.