bulb Peugeot 407 C 2010.5 Owner's Manual

1010
113
CHANGING A FRONT BULB
Handle the bulbs with a dry cloth.
2 - Sidelamps :
W 5 W (COOL BLUE ®
).

 Turn the access cap a quarter turn,
remove the bulb and change it.

3 - Direction indicators :
PY 21 W (DIADEM ®
).

 Turn the access cap a quarter turn.

 Remove the bulb holder.

 Change the bulb.

4 - Front foglamps :
H11 - 55 W.
The headlamps are fi tted with polycarbon-
ate glass with a protective coating. Do not
clean them with a dry or abrasive cloth, nor
with a detergent or solvent product.
Ensure that the liquid used to fi ll the
screenwash and headlamp wash res-
ervoir is of good quality. Integrated direction indicator side
repeaters

 Push the repeater forwards or
backwards and release it.

 Unclip the repeater and change it.
Repeaters can be obtained from a
PEUGEOT dealer.
Front lamps
In the engine compartment, remove
the cover secured by one or two but-
terfl y screws, a plastic retainer clip and
two quarter turn screws.

1 - Dipped and main beam headlamps :
D1S-35W xenon bulb.

WARNING: RISK OF
ELECTROCUTION Coloured bulbs (sidelamps
and direction indicators) must
be replaced with bulbs of iden-
tical specifi cation and colour.
Xenon bulbs must be replaced by a
PEUGEOT dealer.
High pressure washing :
when using a high pressure
washer on stubborn dirt, do
not persist on the headlamps,
other lamps and their edges to avoid
damaging their coating and seals.
In certain climatic conditions (low tem-
perature, humidity), condensation on
the inside surface of the headlamp
glass and rear lamp lens is normal;
it disappears a few minutes after the
lighting is switched on.

1010
114
CHANGING A REAR BULB

1. Direction indicators: W 16W.

2. Foglamps: P 21 W.

3. Reversing lamps: P 21W.

4. Brake lamps/sidelamps: P 21/5 W.
 Fold down the panel to gain ac-
cess to the lamp unit.

 Unscrew the 2 lamp unit fi xing nuts
inside the boot.

 Disconnect the connector.

 Pull the lamp unit towards the out-
side.


 Unscrew the bulb holder sleeve a
quarter of a turn.

 Unscrew the faulty bulb and
change it.

 Screw in the bulb holder sleeve a
quarter of a turn.

 Put the lamp unit back in place
from the outside.

 Reconnect the connector.

 Screw on the 2 lamp unit fi xing
nuts inside the boot. When refi t-
ting, ensure that the lamp unit is
positioned and fi xed correctly.
Number plate lamps: W 5 W.

 Remove the transparent cover using
a screwdriver.

 Change the faulty bulb.

Third brake lamp: LEDs.
Contact a PEUGEOT dealer for re-
placement.
In some weather conditions
(e.g. low temperature or hu-
midity), the presence of misting
on the internal surface of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.