check engine light PEUGEOT 607 2007 Owners Manual

Page 12 of 187

FAMILIARISATION
Instrument panel and warning
lights Controls bar

A. When the ignition is on, the fuel
gauge needle should rise.

B. When the engine is running, its
associated low level warning light
should switch off.

C. When the ignition is on, the display
should indicate "CHECK OIL",
"OIL OK", "PRESSURE OK" for a
few seconds.
If the messages are not correct, refer to
the corresponding section.
When the ignition is on, the orange and
red warning lights come on.
When the engine is running, these
warning lights should be off.
If warning lights remain on, refer to the
page concerned. Lighting of the indicator light indicates
the status of the corresponding function.

 19
 91

A. Selection of the electronically
controlled suspension.

B. Deactivation of the visual and
audible rear and/or front parking
assistance

C. Sunroof control.

D. Rear blind control.
 95

 70

 78
Energy Economy Mode

 113
After the engine has been switched off,
certain electrical functions can only be
used for a limited combined duration, to
prevent discharging of the battery.
Once this period has elapsed, the active
functions are put on standby.
In order to exit the Energy Economy
Mode and resume the use of these
functions immediately, the engine must
be started and left running for a few
minutes.
If the engine has been running for at
least 10 minutes, the functions are
active for 30 minutes.
If the engine has been running for
less than 10 minutes, this duration is
5 minutes before the return to Energy
Economy Mode.
Several door or boot opening
manoeuvres and triggering of the alarm
may result in activation of the Energy
Economy Mode.

Page 19 of 187

1
22
Seat belt not fastened/
unfastened warning light
With the vehicle stationary,
when the ignition is switched
on, the warning light comes
on if the driver and/or the front
passenger has not fastened his seat belt.
From approximately 12 mph (20 km/h)
and for two minutes, the warning light
l ashes accompanied by an increas-
ingly loud audible signal. Once these
two minutes have elapsed, the warn-
ing light remains on until the driver or
front passenger fastens his seat belt.
When the vehicle is moving, the warn-
ing light comes on if the driver or one
of the front or rear passengers unfas-
tens his seat belt.
Diesel engine pre-heating
warning light
If the temperature is sufi -
cient, the warning light does
not come on and you can
start without waiting.
If the warning light comes on, wait
until it goes out before operating the
starter.
If no malfunction has been
detected: the CHECK OK
indicator light comes on af-
ter two seconds (following a
black screen), in the absence
of indicator lights showing the status
of vehicle functions. If these indicator
lights are present, the CHECK OK in-
dicator light will come on after these.

You may start your vehicle.

If a "minor" malfunction has been
detected: the warning light for the
faulty function comes on. Certain in-
dicator lights showing the status of
vehicle functions may also come on,
followed by the CHECK OK indicator
light.

You can start your vehicle; however,
contact a PEUGEOT dealer as soon
as possible.

If a "major" malfunction has been
detected: the corresponding warning
light comes on. Certain indicator lights
showing the status of vehicle functions
may also come on. The CHECK OK
indicator light does not come on.

Do not start your vehicle.
Contact a PEUGEOT dealer. Following this, the following
information appears on the
instrument panel display:
The engine oil level appears for ap-
proximately 7 seconds; at the same
time, the service indicator appears on
the display located in the speedometer
dial for approximately 7 seconds.
Then, the status of the tyre pressures is
indicated for approximately 5 seconds.
With the ignition on, the vehicle
carries out an automatic
test which appears on the
instrument panel display:

Page 20 of 187

1
23
Manual test of the vehicle Entering CHECK mode
indicator light
This comes on following
pressing of the
"CHECK"
button.
Exiting CHECK mode
indicator light
This comes on at the end of
the CHECK mode. With the engine running
and the vehicle moving, the
instrument panel display
temporarily shows:
- warning lights, when a fault occurs,
- vehicle function status indicator
lights, when a change occurs.

The display of certain warning lights
may be accompanied by an audible
signal and a message on the multi-
function display.

 Press the "CHECK" button on the
instrument panel.
You can start a test of the vehicle man-
ually, at any time, with the ignition on,
engine running or vehicle moving.
This enables you to know:
- the warnings present,
- the status of the functions which can be activated or deactivated (au-
tomatic wipers, automatic switching
on of the lights, ESP, ...).
The associated warning lights are
displayed in succession on the instru-
ment panel display.
If a warning or a change of status oc-
curs during the CHECK mode, the
corresponding warning light(s) are
displayed during this mode and the

CHECK will cease .