service indicator Peugeot 607 Dag 2009 Owner's Manual

Page 30 of 182

1
31
SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule.
The point at which the service is due is
calculated from the last indicator zero
reset. It is determined by two param-
eters:
- the distance travelled,
- the time elapsed since the last service.

Note: the distance remaining before
the next service is due may be weight-
ed by the time factor.
The service information appears on
the display, located in the speedo-me-
ter dial, at the same time as the en-
gine oil level on the instrument panel
display.
Operation
As soon as the ignition is switched on
and for 7 seconds, the spanner sym-
bolising the servicing operations is lit.
The trip recorder display shows the
distance remaining (in round fi gures)
before the next service.

Example: 4,800 miles/km remain be-
fore the next service is due. When the
ignition comes on and for 7 seconds
the display indicates:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the display
shows the total and trip distances.
The distance remaining before the
next service is less than 500 miles
(1,000 km).
Each time the ignition is switched on
and for 7 seconds, the spanner and
the distance fl ash.

Example: 900 miles/km remain before
the next service is due.
When switching on the ignition and for
7 seconds, the display shows:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the spanner re-
mains lit.
This indicates that a service should be
carried out shortly. The display shows
the total and trip distances.

Page 31 of 182

1
32
Trip recorder zero reset button
Lighting rheostat button
With the ignition on, press the button
until the zeros appear.
With the headlamps on, press button B to
increase the brightness of the lighting of
the instruments and controls or button A to
reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the spanner re-
mains lit. The display shows the total
and trip distances.

Note: the spanner may also be lit if the
two-year interval has been exceeded.
Service indicator zero re-set
The service is overdue.
Each time the ignition is switched on
and for 7 seconds, the spanner and
the excess distance fl ash.

Example: the service is overdue by
300 miles/km. The service should be
carried out very shortly.
When the ignition is switched on and
for 7 seconds, the display shows:
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as fol-
lows:

 Switch off the ignition,

 Press and hold the trip recorder re-
set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , release
the button; the spanner disappears.
After this operation, if you wish
to disconnect the battery, lock
the vehicle and wait for at least
fi ve minutes, otherwise the zero
re-set will not be registered.

Page 32 of 182

1
32
Trip recorder zero reset button
Lighting rheostat button
With the ignition on, press the button
until the zeros appear.
With the headlamps on, press button B to
increase the brightness of the lighting of
the instruments and controls or button A to
reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the spanner re-
mains lit. The display shows the total
and trip distances.

Note: the spanner may also be lit if the
two-year interval has been exceeded.
Service indicator zero re-set
The service is overdue.
Each time the ignition is switched on
and for 7 seconds, the spanner and
the excess distance fl ash.

Example: the service is overdue by
300 miles/km. The service should be
carried out very shortly.
When the ignition is switched on and
for 7 seconds, the display shows:
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as fol-
lows:

 Switch off the ignition,

 Press and hold the trip recorder re-
set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , release
the button; the spanner disappears.
After this operation, if you wish
to disconnect the battery, lock
the vehicle and wait for at least
fi ve minutes, otherwise the zero
re-set will not be registered.