weight RENAULT TWINGO 2012 2.G Owners Manual

1.34
ENG_UD24497_2
Sécurité enfants : installation du siège enfant (X44 - Renault\
)
ENG_NU_952-4_X44_Renault_1
Jaune NoirNoir texte
Type of child seat Weight of
the child seat size
IsOFIX passenger front
seat (1) (2) Rear side seats
right left
Carrycot fitted across the vehi- cle
Group 0 < 10 kg
F XU - IL (4) U (4)
shell seat/rear-facing seat
Groups 0, 0 + or 1 < 13 kg and
9 kg to 18 kg D, E
U - IL U - IL (5) U (5)
Rear-facing seat
Groups 0 + and 1 < 13 kg and
9 kg to 18 kg C
U - IL U (3)U (3)
Forward-facing seat
Group 1 9 kg to 18 kg
A, B, B1 IL - IUFU - IUF - IL (6) U (6)
Booster cushion
Group 2 or 3 15 kg to 36 kg
–X U (6)U (6)
(1) RIsK OF DEATh OR sERIOUs INJURY: before installing a rear-facing child seat on the front passenger seat,
check that the air bag has been deactivated (refer to Section 1 “Child safety: deactivating/activating the front passen -
ger air bag”).
Forward facing harness seats are only permitted if they are installed us\
ing an ISOFIX fitting and without a seat belt.
ChILD sAFETY : Fitting a child seat (3/4)
The table below summarises the information already shown on the diagram on the previous page, to ensure the regula-
tions in force are respected.

headlight beam adjustment ................................... (current page)
electric beam height adjustment ............................ (current page)
1.61
ENG_UD26566_4
Réglages électriques de la hauteur des faisceaux (X44 - Renault)\
ENG_NU_952-4_X44_Renault_1
Examples of positions for adjusting
control A according to the load
All versions except
commercial vehicles Commercial vehicles
Driver only 0_
Driver alone or with front
passenger 0
_
Driver with one front
passenger and two rear
passengers 1
–
Driver with three
passengers with luggage 2
–
Driver with luggage or load
reaching the maximum
authorised load weight 3
3
Headlight beam adjustment
ELECTRIC BEAM hEIGhT ADJUsTMENT
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
Turn control A downwards to lower the
headlights and upwards to raise them.
A
If driving on the left in a left-hand
drive vehicle (or vice versa), drivers
must have the lights adjusted by an
authorised dealer for the duration of
the trip.

rear seatsfunctions ......................................... (up to the end of the DU)
adjusting the seats ................................ (up to the end of the DU)
rear seats .............................................. (up to the end of the DU)
3.31
ENG_UD24499_5
Sièges arrière : fonctionnalités (X44 - Renault)
ENG_NU_952-4_X44_Renault_3
Rear seats: functions
REAR SEATS: functions
To fold down the rear seatsThe seats can be folded down in order
to transport large objects:
From the front, lower the headrest.
From the rear, lift handle 2 to fold down
the seatback, lower bar 1 of the seat
concerned and move it forwards fully.
Lift the controls 3 located either side
of the seat and lift the seat against the
front seats. Tension wheels
4 located under each
of the rear seats are used to keep the
seats folded down.
Unhook the tension wheel from ring 5
and hook it to the rods on the headrest
in front.
To return the seats
Unhook retainer 4 from the headrest
rods, and stow it by hooking it into
ring 5. Lower the seat until it is approxi -
mately 10 cm from the floor then re -
lease it. The seat positions itself under
its own weight. Raise the seatback and
ensure the seat is correctly locked.
When moving the rear
seats, ensure that nothing
obstructs the anchorage
points (passenger’s arm or
leg, a pet, gravel, cloth, toys, etc.).
When tilting the seats, be
careful not to lock the seat
belts. If this happens, tilt
the seat again. Pull the belt
strap, reposition the seat and re -
lease the strap.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
When refitting the seat -
back , make sure it is cor -
rectly locked in place.
If seat covers are fitted ,
make sure these do not prevent the
seatback latch from locking in.
Make sure that the seat belts are
positioned correctly.
Reposition the headrests.
3
2
1
4
5

towingtowing equipment ............................................. (current page)
3.38
ENG_UD28738_4
Remorquage : attelage (X44 - Renault)
ENG_NU_952-4_X44_Renault_3
A = 600 mm.
T oWINg: towing equipment
Permissible nose weight, maxi -
mum permissible towing weight
braked and unbraked:
Refer to the information on “Weights”
in Section 6.
Refer to the manufacturer’s instruc-
tions for information on how to fit
and operate the towing equipment.
Please keep these instructions with
the rest of the vehicle documenta -
tion.
A
If the towbar ball obscures the reg-
istration plate or the rear lights, it
should be removed when not in use.
In all cases, comply with local leg -
islation.

roof bars ............................................... (up to the end of the DU)
roof rack roof bars .......................................... (up to the end of the DU)
3.39
ENG_UD24696_3
Barres de toit (X44 - Renault)
ENG_NU_952-4_X44_Renault_3
Roof bars
RooF BARS
Accessing the mounting
points
Open the doors. Behind seal 2 are
blanking bolts 1 which protect the
mounting bolt locations.
When fitting roof bars, at the front of the
vehicle, replace the blanking bolts with
the mounting bolts supplied with the
roof bars. Behind seal 3 , position the
roof bars in the reinforced area 4 pro -
vided.
Never remove blanking
bolts 1 without plugging the
holes afterwards.
Once they are secured on
to the vehicle, the mount -
ing bolts should never be
removed (risk of damaging
the vehicle).
If original roof bars, approved by our
Technical Department, are supplied
with screws, only use these screws
for attaching the roof bars to the ve-
hicle.
13
For information on the range of
equipment adapted to your vehi -
cle, we advise you to consult an ap-
proved Dealer.
Refer to the fitting instructions for in-
formation on how to fit roof bars and
conditions of use.
Please keep these instructions with
the rest of the vehicle documenta -
tion.
Maximum permissible load on
roof rack: refer to the information
on “Weights” in Section 6.
24

JauneNoirNoir texte
4.3
ENG_UD24707_5
Capot moteur (X44 - Renault)
ENG_NU_952-4_X44_Renault_4
BONNET (2/2)
Opening the bonnet
Lift the bonnet and release stay 4 from
its holder 5 . For your own safety, it is
very important to fix the stay into re -
tainer 3 in the bonnet.
Closing the bonnet
Before closing the bonnet, check to
make sure that nothing has been left in
the engine compartment.
To close the bonnet, replace stay 4 in
holder 5. Hold the middle of the bonnet
and guide it down to 20 cm above the
closed position, then release. It will latch
automatically under its own weight.
In the event of even a slight
impact involving the radia -
tor grille or bonnet, have
the bonnet lock checked by
an approved dealer as soon as pos-
sible.Ensure that the bonnet is
properly locked.
Check that nothing is pre -
venting the catch from lock-
ing (gravel, cloth, etc.).
5
3
4
Make sure nothing is left
in the engine compartment
(cloth, tools, etc.).
These may damage the
engine or cause a fire.

JauneNoirNoir texte
4.11
ENG_UD29222_2
Pression de gonflage des pneumatiques (X44 - Renault)
ENG_NU_952-4_X44_Renault_4
TyRE pRESSURE (2/2)
Tyre safety and use of snow
chains
Refer to the information on “Tyres”
in Section 5 for the servicing con -
ditions and, depending on the ver -
sion, the use of chains.
Special note
For vehicles used fully laden
( m a x i m u m p e r m i s s i b l e a l l - u p
weight) and towing a trailer. The
maximum speed must be limited
to 60 mph (100 km/h) and the tyre
pressure increased by 0.2 bar.
Refer to the information on “Weights”
in Section 6.
When they need to be re -
placed, only tyres of the
same make, size, type and
profile should be used.
Tyres fitted to the vehicle should
either be identical to those fitted
originally or conform to those
recommended by your approved
dealer.

towingbreakdown ...................................... (up to the end of the DU)
towing towing equipment ............................ (up to the end of the DU)
towing hitch ........................................... (up to the end of the DU)
towing a caravan .................................. (up to the end of the DU)
5.30
ENG_UD24739_3
Remorquage : dépannage (X44 - Renault)
ENG_NU_952-4_X44_Renault_5
Jaune NoirNoir texte
Towing (breakdown – attachments)
tOWIng: breakdown
the steering wheel must be un -
locked and the ignition key must be
in the “Ignition on” position to pro -
vide signals (brake lights and direc-
tion indicators) on the towed vehi -
cle. At night the vehicle must have
its lights on.
You must observe the towing regu -
lations which apply in the country in
which you are driving: do not exceed
the towing weight for your vehicle.
Contact your RENAULT Dealer. u
se only the towing points at the
front 2 and rear 5 (never use the drive
shafts). These towing points may only
be used for pulling the vehicle, never
for lifting it either directly or indirectly.Access to front towing
point 2
Unclip cover 4.
Screw in towing hitch 3 fully: firstly
by hand, then finish by tightening it with
the wheelbrace.
The towing hitch 3 and wheelbrace are
located in the tool kit 1.
W h e n t h e e n g i n e i s
stopped, steering and brak-
ing assistance are not op -
erational.
1
Do not leave the tools unse-
cured inside the vehicle as
they may come loose under
braking.
3
2
45

6.1
ENG_UD30798_17
Sommaire 6 (X44 - Renault)
ENG_NU_952-4_X44_Renault_6
Section 6: Technical specifications
Vehicle identification plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.2
Engine specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.4
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5
Weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.6
Replacement parts and repairs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.7
Service sheets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.8
Anti-corrosion check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.14

technical specifications ......................... (up to the end of the DU)
paintwork reference ......................................... (up to the end of the DU)
vehicle identification plates ................... (up to the end of the DU)
vehicle identification ............................. (up to the end of the DU)
6.2
ENG_UD29237_7
Plaques d identification (X44 - Renault)
ENG_NU_952-4_X44_Renault_6
Jaune NoirNoir texte
Vehicle identification plates
VEHICLE IDENTIFICATION PLATES (1/2)
A
B
A
10
The information shown on the ve -
hicle identification plate should be
quoted on all correspondence or
orders.
The presence and location of the in-
formation depends on the vehicle.
Vehicle identification plate A
1 Manufacturer name.
2 EC design number or approval
number.
3 Identification number.
Depending on the vehicle, this
information is also given on
marking B.
4 MAM (Maximum Authorised Mass)
for front axle.
5 GTW (Gross train weight: vehicle
fully loaded, with trailer).
6 MPAW (Maximim Permissible
Weight) for front axle.
7 MPAW on rear axle.
8 Reserved for related or additional
entries.
9 Diesel exhaust emissions.
10 Paint reference (colour code).
9
8
7
6
5
4
3
2
1