lock SUBARU FORESTER 2003 SG / 2.G Owners Manual

Page 7 of 420

4
ual. This symbol means “Do not”, “Do not do this”, or
“Do not let this happen”, depending upon the context.Vehicle symbols
There are some of the symbols you may see on your vehicle.Mark Name CAUTION
Power door lock and unlock
Passenger’s windows lock and unlock Fuel
Front fog lights
Parking lights
Hazard warning flasher
Cigarette lighter

Page 11 of 420

8
Always lock the passenger

Page 17 of 420

14
Illustrated index Exterior
12 3 4 5
6
7
8
9
10
11
HSF020BB
1) Engine hood (page 11-5)
2) Headlight switch (page 3-17)
3) Replacing bulbs (page 11-54)
4) Wiper switch (page 3-23)
5) Roof rails (page 8-17)
6) Door locks (page 2-3)
7) Tire pressure (page 11-38)
8) Flat tires (page 9-3)
9) Tire chains (page 8-13)
10) Front fog light switch (page 3-
21)
11) Tie-down/Towing hooks (page
9-13)

Page 18 of 420

15

CONTINUED –
1
23
4
5
HSF021BB
1) Rear window defogger switch
(page 3-27)
2) Fuel filler lid and cap (page 7-4)
3) Child safety locks (page 2-20)
4) Tie-down/Towing hook (page 9-
13)
5) Rear gate (page 2-24)

Page 21 of 420

18

Instrument panel
12 3 4 5 67
8
9
10
11
12
14
15
16 13
HSF024BB
1) Door locks (page 2-3)
2) Outside mirror switch (page 3-
31)
3) Light control lever (page 3-17)
4) Combination meter (page 3-5)
5) Wiper control lever (page 3-22)
6) Hazard warning flasher switch
(page 3-5)
7) Audio (page 5-2)
8) Gear shift lever (MT) (page 7-
11)/Selector lever (AT) (page 7-
14)
9) Climate control (page 4-2)
10) Cruise control (page 7-31)
11) Horn (page 3-34)
12) SRS airbag (page 1-39)
13) Tilt steering (page 3-33)
14) Fuse (page 11-50)/Coin tray
(page 6-7)
15) Hood lock release (page 11-5)
16) Power window (page 2-21)

Page 31 of 420

1-4
Seat, seatbelt and SRS airbags

Reclining the seatback
Pull the reclining lever up and adjust the seatback to
the desired position. Then release the lever and make
sure the seatback is securely locked into place.
The seatback placed in a reclined position can spring
back upward with force when released. When operat-
ing the reclining lever to return the seatback, hold it
lightly so that it may be raised back gradually.
To prevent the passenger from sliding under
the seatbelt in the event of a collision, always
put the seatback in the upright position while
the vehicle is in motion. Also, do not place ob-
jects such as cushions between the passenger
and the seatback. If you do so, the risk of slid-
ing under the lap belt and of the lap belt sliding
up over the abdomen will increase, and both
can result in serious internal injury or death.
HS1036BA
HS1037BA

Page 39 of 420

1-12
Seat, seatbelt and SRS airbags
1. Lower the headrests.
2. Unlock the seatback by pulling the release knob
and then fold the seatback down.
To return the seatback to its original position, raise the
seatback until it locks into place and make sure that it
is securely locked.

After returning the rear seatback to its origi-
nal position, make certain that the shoulder
belts are fully visible. Never allow passengers to ride on the folded
rear seatback or in the cargo area. Doing so
may result in serious injury or death. Secure lengthy items properly to prevent
them from shooting forward and causing seri-
ous injury during a sudden stop.
Seatbelts Seatbelt safety tips
All persons in the vehicle should fasten their
seatbelts BEFORE the vehicle starts to move.
Otherwise, the possibility of serious injury be-
comes greater in the event of a sudden stop or
accident. All belts should fit snugly in order to provide
full restraint. Loose fitting belts are not as ef-
fective in preventing or reducing injury. Each seatbelt is designed to support only
one person. Never use a single belt for two or
more persons — even children. Otherwise, in
an accident, serious injury or death could re-
sult. Replace all seatbelt assemblies including re-
tractors and attaching hardware worn by occu-
pants of a vehicle that has been in a serious
accident. The entire assembly should be re-
placed even if damage is not obvious. Put children aged 12 and under in the rear
seat properly restrained at all times. The SRS
airbag deploys with considerable speed and

Page 41 of 420

1-14
Seat, seatbelt and SRS airbags

Expectant mothers
Expectant mothers also need to use the seatbelts.
They should consult their doctor for specific recom-
mendations. The lap belt should be worn securely and
as low as possible over the hips, not over the waist. Emergency Locking Retractor (ELR)
The driver’s seatbelt has an Emergency Locking Re-
tractor (ELR).
The emergency locking retractor allows normal body
movement but the retractor locks automatically during
a sudden stop, impact or if you pull the belt very quick-
ly out of the retractor.
Automatic/Emergency Locking Retrac-
tor (A/ELR)
Each passenger’s seatbelt has an Automatic/Emer-
gency Locking Retractor (A/ELR). The Automatic/
Emergency Locking Retractor normally functions as
an Emergency Locking Retractor (ELR). The A/ELR
has an additional locking mode “Automatic Locking
Retractor (ALR) mode” intended to secure a child re-
straint system. When the seatbelt is once drawn out
completely and is then retracted even slightly, the re-
tractor locks the seatbelt in that position and the seat-
belt cannot be extended. As the belt is rewinding,
clicks will be heard which indicate the retractor func-
tions as an ALR. When the seatbelt is retracted fully,
the ALR mode is released.
When securing a child restraint system on the rear
seats by the use of the seatbelt, the seatbelt must be
changed over to the Automatic Locking Retractor
(ALR) mode.
When the child restraint system is removed, make
sure that the seatbelt retracts fully and the retractor re-
turned to the Emergency Locking Retractor (ELR) mode.
For instructions on how to convert the retractor to the
ALR mode and restore it to the ELR mode, see the
“Child restraint systems” section in this chapter.
HS1107AA

Page 44 of 420

1-17
Seat, seatbelt and SRS airbags
–CONTINUED –
5. To make the lap part tight, pull up on the shoulder
belt.
6. Place the lap belt as low as possible on your hips,
not on your waist.
Adjusting the front seat shoulder belt anchor
height
The shoulder belt anchor height should be adjusted to
the position best suited for you.
To lower the anchor height, push the release button
and slide the anchor down.
To raise the anchor height, slide the anchor up. Pull
down on the anchor to make sure that it is locked in
place.
Always adjust the anchor height so that the shoulder
belt passes over the middle of the shoulder without
touching the neck.
5
6
HS1051BB
HS1052BA

Page 45 of 420

1-18
Seat, seatbelt and SRS airbags
When wearing the seatbelts, make sure the
shoulder portion of the webbing does not pass
over your neck. If it does, adjust the seatbelt an-
chor to a lower position. Placing the shoulder
belt over the neck may result in neck injury dur-
ing sudden braking or in a collision.
Unfastening the seatbelt
Push the button on the buckle.
Before closing the door, make sure that the belts are
retracted properly to avoid catching the belt webbing in the door.
Rear seatbelts (except rear center seatbelt)
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the belt out slowly.
Do not let it get twisted. If the belt stops before reach-
ing the buckle, return the belt slightly and pull it out
more slowly. If the belt still cannot be unlocked, let the
belt retract slightly after giving a strong pull on it, then
pull it out slowly again.
3. Insert the tongue plate into the buckle until you
hear a click.
HS1053BA
HS1050BA

Page:   1-10 11-20 21-30 31-40 41-50 ... 110 next >