front fender SUZUKI GRAND VITARA 2000 2.G Service User Guide

YH4
GRAND
VITARA
ªaº: 30 mm (1.18 in.)
ªbº: 100 mm (3.94 in.)
ªAº: Apply undercoating (PVC, 400
m or more)
ªBº: Additional applying of under coating
ªBº: (for 5 door vehicle without splush guard)
ªCº: Apply PVC chip resistant material (200
m or more)1. Side body outer
2. Side sill inner
3. Main floor
4. Front fender
5. Front wheel housing
6. Frame
7. Dash panel
8. Center floor
9. Rear floor
Vehicle produced in IWATA
VIEW: Z
9-52 BODY SERVICE

YH4
GRAND
VITARA
ªaº: 30 mm (1.18 in.)
ªbº: 100 mm (3.94 in.)
ªAº: Apply undercoating (PVC, 400
m or more)
ªBº: Additional applying of under coating
ªBº: (for 5 door vehicle without splush guard)
ªCº: Apply PVC chip resistant material (200
m or more)1. Side body outer
2. Side sill inner
3. Main floor
4. Front fender
5. Front wheel housing
6. Frame
7. Dash panel
8. Center floor
9. Rear floor
Vehicle produced in CAMI
VIEW : Z
BODY SERVICE 9-53

YH4
GRAND
VITARA
9-56 BODY SERVICE
BADC
ªaº: 30 mm (1.18 in.)
ªbº: 100 mm (3.93 in.)
ªAº: Apply undercoating (PVC, 400
m or more)
ªBº: Additional applying of under coating
ªBº: (for 5 door vehicle without splush guard)
ªCº: Apply PVC chip resistant material (200
m or more)1. Side body outer
2. Side sill inner
3. Main floor
4. Front fender
5. Front wheel housing
6. Frame
7. Dash panel
8. Center floor
9. Rear floorB ± B
A ± A
C ± C
VIEW : Z

YH4
GRAND
VITARA
BODY SERVICE 9-77
1. Front door molding
2. Rear door molding
3. Front fender molding
SIDE MOLDINGS (IF EQUIPPED)
INSTALLATION
1) Bonding surfaces should be cleaned thoroughly.
2) Install molding by aligning it to clip holes and pulling it to the rear
so that fender or door will not interfere with it when door is
opened.
3) If adequate adhesive force is not available, use urethane adhe-
sive.

YH4
GRAND
VITARA
9-78 BODY SERVICE
1. Fender splash guard
2. Front door splash guard
3. Rear door splash guard
4. Rear splash guard
5. Side sill splash guard
6. Rear door guard holder
SPLASH GUARD (IF EQUIPPED)