TPMS TESLA MODEL 3 2018 Owner's Manual

Replacing Tires and Wheels
Tires degrade over time due to the
effects of
ultraviolet light, extreme temperatures, high
loads, and environmental conditions. It is
recommended that tires are replaced every six
years, or sooner if required.
Wheel and tires are matched to suit thehandling characteristics of the vehicle.
Replacement tires must comply with the
original
specification. If tires other than thosespecified are used, ensure that the load and
speed ratings marked on the tire (see Understanding Tire Markings on page 139)
equal or exceed those of the original
specification.
Ideally, you should replace all four tires at the same time. If this is not possible, replace the
tires in pairs, placing the new tires on the rear.
Always balance the wheel after replacing a
tire.
If you replace a wheel, the TPMS (Tire Pressure
Monitoring System) sensors need to be reset to ensure they provide accurate warnings
when tires are under- or
over-inflated (see
Automatic Resetting of TPMS Sensors on
page 117).
For the
specification of the original wheels
and tires installed on Model 3, see Wheels and
Tires on page 138.
Warning:
For your safety, use only tires
and wheels that match the original
specification. Tires that do not match the
original specification can affect the
operation of the TPMS.
Warning: Never exceed the speed rating
of your vehicle

driven 15 mph (25 km/h) for longer than 10
minutes.
Replacing a Tire Sensor
If the Tire Pressure warning indicator displays frequently, contact Tesla to determine if a tire
sensor needs to be replaced. If a non-Tesla Service Center repairs or replaces a tire, the
tire sensor may not work until Tesla performs
the setup procedure.
TPMS Malfunction
Model 3 has also been equipped with a TPMS
malfunction indicator to indicate when the
system is not operating properly.The TPMS malfunction indicator is
combined with the tire pressure
indicator light. When the system
detects a malfunction, the indicator
flashes for approximately one minute
after Model 3 powers on, and then
remains continuously lit. This
sequence continues upon
subsequent vehicle start-ups as long
as the malfunction exists. When the
TPMS malfunction indicator is on,
the system might not be able to
detect or signal under- and
over-
inflated tires as intended.
TPMS malfunctions can occur for a variety of
reasons, including installing replacement or
alternate tires or wheels that prevent the
TPMS from functioning properly. Always check
the TPMS malfunction indicator light after replacing one or more tires or wheels on yourvehicle to ensure that the replacement tires or
wheels allow the TPMS to continue to function
properly.
Note: If a tire has been replaced or repaired
using a
different tire sealant than the one
available from Tesla, and a low tire pressure is
detected, it is possible that the tire sensor has been damaged. Contact Tesla to have the fault
repaired as soon as possible.
Tire Care and Maintenance
118Model 3 Owner

tires (continued)balancing 114
chains 117
inspecting and maintaining 114
pressures, how to check 113
quality grading 141
replacing 115
replacing a tire sensor 118
rotation 114
specification 138
summer 116
temperature grades 141
tire markings 139
traction grade 141
treadwear grade 141
winter 116
toll system transponders, attaching 127
touch up body 120
touchscreenclean mode 120
cleaning 120
overview 4
restarting 36
software updates 104
tow eye, locating 147
towing a trailer 132
towing instructions 146
TPMSFCC certification 156
overview of 117
Tracking Disabled 95
traction control 51
trademarks 151
Traffic-Aware Cruise Control 61
trailer hitches 132
transmission
specifications 136
transponders, attaching 127
Transport Canada, contacting 154
Transport Mode 146
transporting 146
Trip Planner 97
trunk, front 14
trunk, rear 12
TuneIn radio 91
turn signals 46
U ultrasonic sensors 58
uniform tire quality grading 141
Unlock On Park 10
unlocking 9
USB devicesconnecting 16
playing audio files from 92
USB ports 16
V
Valet mode 34
vehicle
certification label 131
Vehicle Hold 54
Vehicle
Identification Number (VIN) 130
vehicle loading 131
ventilation 88
VIN (Vehicle
Identification Number) 130
volume control 4
volume control (media) 90
W Walk Away Lock 10
Wall Connector 106
warning
flashers 47
washer fluid, topping up 125
washer jets, cleaning 122
washers, using 48
weight
specifications 135
wheel chocks 147
wheelsaero covers, removing and installing 115
alignment 114
lug nut covers, removing and installing
116
replacing 115
specifications 138
torque 138
Wi-Fi, connecting to 103
windshield washer fluid, topping up 125
winter tires 116
wiper blades, replacing 122
wipers, using 48
Work location 98
Index
162Model 3 Owner