fog light TOYOTA C-HR 2023 Owner's Manual

5535-1. Using the air conditioning system and defogger
C-HR_HEV_OM_Europe_OM10764E
5
Interior features
■nanoe™ *1 (if equipped)
This vehicle incorporates a biocidal product.
Ionised air generated by a device incorporated in the vehicle p urifies the air in
the cabin by suppressing bacteria.
Active substance: Free radicals generated in situ from ambient air or water
The air conditioning system adopts nanoe™ technology. This help s to fill the
cabin with refreshing air by emitting slightly acidic nanoe™ co ated with water
particles through the passenger’s side vent*2.
● When the fan is turned on, nanoe™ system is activated.
● When the fan is operated in the following conditions, system performance
will be maximized. If the following conditions are not met, nan oe™ may not
operate at full capacity.
• The upper body, the upper body and feet or the feet air outlet s are being
used. ( P. 547)
• The passenger’s side vent is open.
● When nanoe™ is generated, a small amount of ozone is emitted and may
be faintly smelled in some situations. However, this is approxi mately the
same as the amount that already exists in nature, such as in fo rests, and it
has no affect on the human body.
● A slight noise may be heard during operation. This is not a malfunction.
*1: nanoe™ and the nanoe™ mark are trademarks of Panasonic Corporation.
*2: According to temperature and humidity conditions, fan speed and direction
of the air flow, nanoe™ may not operate at full capacity.
■ Air conditioning filter
 P. 635
■ Customization
Settings (e.g. air conditioning setting) can be changed.
(Customizable features: P. 779)

5565-1. Using the air conditioning system and defogger
C-HR_HEV_OM_Europe_OM10764E
Turns the heated steering wheel on/off
The indicator light comes on when the heated steering wheel is operating.
■Operating condition
The heated steering wheel can be used when the power switch is in ON
mode.
Each time the switch is pressed,
the operation condition changes
as follows.
Hi (3 segments lit)  Mid (2 seg-
ments lit)  Lo (1 segment lit) 
Off
The level indicator (amber) lights
up during operation.
■ Operating condition
The seat heaters can be used when the power switch is in ON mod e.
Heated steering wheel
Left-hand drive vehiclesRight-hand drive vehicles
Seat heaters

5876-1. Maintenance and care
6
Maintenance and care
C-HR_HEV_OM_Europe_OM10764E
NOTICE
■Preventing damage to leather surfaces
Observe the following precautions to avoid damage to and deteri oration of
leather surfaces:
● Remove any dust or dirt from leather surfaces immediately.
● Do not expose the vehicle to direct sunlight for extended periods of time.
Park the vehicle in the shade, especially during summer.
● Do not place items made of vinyl, plastic, or containing wax on the uphol-
stery, as they may stick to the leather surface if the vehicle interior heats
up significantly.
■ Water on the floor
Do not wash the vehicle floor with water.
Vehicle systems such as the audio system may be damaged if wate r comes
into contact with electrical components such as the audio syste m above or
under the floor of the vehicle. Water may also cause the body t o rust.
■ When cleaning the inside of the windshield (vehicles with Toyota
Safety Sense)
Do not allow glass cleaner to contact the lens. Also, do not to uch the lens.
( P. 355)
■ Cleaning the inside of the rear window
● Do not use a glass cleaner to clean the rear window, as this may cause
damage to the rear window defogger heater wires. Use a cloth da mpened
with lukewarm water to gently wipe the window clean. Wipe the w indow in
strokes running parallel to the heater wires.
● Be careful not to scratch or damage the heater wires.

6516-3. Do-it-yourself maintenance
C-HR_HEV_OM_Europe_OM10764E
6
Maintenance and care
Light bulbs
Check the wattage of the light bulb to be replaced. (P. 776)
■Front
You may replace the following bulbs by yourself. The difficulty
level of replacement varies depending on the bulb. As there is a
danger that components may be damaged, we recommend that
replacement is carried out by any authorized Toyota retailer or
Toyota authorized repairer, or any reliable repairer.
Preparing for light bulb replacement
Bulb locations
Front turn signal lights (bulb type)
Front fog lights (if equipped on bulb type)
Side turn signal lights

6526-3. Do-it-yourself maintenance
C-HR_HEV_OM_Europe_OM10764E
■Rear
Rear turn signal lights (bulb type)
Stop/tail lights (bulb type)
Back-up lights (bulb type)
License plate lights
Rear fog light (bulb type)

6536-3. Do-it-yourself maintenance
C-HR_HEV_OM_Europe_OM10764E
6
Maintenance and care
■Front fog lights (if equipped on bulb type)
Remove the 2 screws and
clip, and partly remove the
fender liner.
Unplug the connector while
pressing the lock release.
Turn the bulb base counter-
clockwise and remove it.
Replacing light bulbs
1
2
3

6546-3. Do-it-yourself maintenance
C-HR_HEV_OM_Europe_OM10764E
Install a new light bulb.
Align the 3 tabs on the light bulb
with the mounting and insert.
Turn clockwise and secure the
bulb base.
Install the connector.
Shake the bulb base gently to
check that it is not loose, turn
the front fog lights on once and
visually confirm that no light is
leaking through the mounting.
Reinstall the fender liner and
install the 2 screws and clip.
Make sure that the fender liner
is attached to the inside of the
bumper.
4
5
6

6606-3. Do-it-yourself maintenance
C-HR_HEV_OM_Europe_OM10764E
■Rear fog light (bulb type)
Turn the bulb base counter-
clockwise.
Remove the light bulb.
When installing, reverse the steps listed.
1
2
3

6646-3. Do-it-yourself maintenance
C-HR_HEV_OM_Europe_OM10764E
Attach the cover claws span-
ning over the entire perime-
ter.
Finally, confirm that the outside
claw is securely fitted.
■Replacing the following bulbs
If any of the lights listed below has burnt out, have it replac ed by
any authorized Toyota retailer or Toyota authorized repairer, o r any
reliable repairer.
● Headlights
● Front position lights/daytime running lights
● Front turn signal lights (vehicles with LED type)
● Front fog lights (vehicles with LED type)
● Stop/tail lights (vehicles with LED type)
● Rear turn signal lights (vehicles with LED type)
● Back-up lights (vehicles with LED type)
● Rear fog light (vehicles with LED type)
● High mounted stoplight
● Outer mirror illumination (if equipped)
11

6656-3. Do-it-yourself maintenance
C-HR_HEV_OM_Europe_OM10764E
6
Maintenance and care
■LED light bulbs
The following lights consist of a number of LEDs. If any of the LEDs burn out,
take your vehicle to any authorized Toyota retailer or Toyota a uthorized
repairer, or any r eliable repairer.
● Headlights
● Front position lights/daytime running lights
● Front turn signal lights (vehicles with LED type)
● Front fog lights (vehicles with LED type)
● Stop/tail lights (vehicles with LED type)
● Rear turn signal lights (vehicles with LED type)
● Back-up lights (vehicles with LED type)
● Rear fog light (vehicles with LED type)
● High mounted stoplight
● Outer mirror illumination (if equipped)
■ Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction.
Contact any authorized Toyota retailer or Toyota authorized rep airer, or any
reliable repairer for more information in the following situati ons:
● Large drops of water have built up on the inside of the lens.
● Water has built up inside the headlight.
■ When replacing light bulbs
 P. 650