headlights TOYOTA COROLLA HATCHBACK 2020 Owners Manual (in English)

2
OVERVIEW
Instrument panel
Steering wheel controls
Windshield wiper and washer control
Tilt and telescopic steering
lock release lever (below the
steering wheel)
Audio volume control
switches2
Audio control switches2
Meter control switches
Instrument panel
light control dial
“ENGINE START STOP” switch
Hood lock release lever
Meters/Multi-Information Display (MID)
Automatic High Beam
(AHB) switchPaddle shifters
1
Telephone switch2
Voice command switch2
&ULL
3PEED2ANGE$YNAMIC2ADAR
Cruise Control/Dynamic Radar
Cruise Control vehicle-to-vehicle
distance switch
LTA (Lane Tracing Assist)
1/Lane Departure
Alert with Steering Assist (LDA w/SA) switch
Full-Speed Range
Dynamic Radar Cruise
Control/Dynamic Radar
Cruise Control switch
Headlights/turn signals/fog lights1 control

13
Lights & turn signals
Headlights
AUTO
OFF Parking lights
HEADLIGHTS
FRONT FOG LIGHTS (IF EQUIPPED)
TURN SIGNAL
TurnLow beam
(Original position)
Daytime Running Light system (DRL) Automatically turns on under certain
conditions to make vehicle more visible to other drivers. Not for use at night.
Automatic light cut off system Automatically turns lights off after 30 second
delay, or lock switch on remote is pushed after locking.
Automatic High Beam (AHB) system Automatically switches between high
and low beams as appropriate to enhance vision at night.
Refer to Toyota Safety Sense™ 2.0 (TSS 2.0) in this guide or the Owner’s Manual
for more details on the Automatic High Beam feature.
* Operating conditions must be met. Refer to the Owner’s Manual for details.
High beam flasher
(Pull)
or High beam (Push)Automatic High Beam*
Right turn
Lane change
1
Lane change2
Left turn
1
The right hand signals will flash three times.
2
The left hand signals will flash three times.
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Front fog lights come on only when the headlights are on low beam.

39
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Automatic High Beams (AHB)
ACTIVATING THE AHB SYSTEM
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
When all of these conditions are met, high beams will be automatically turned on
(after approximately 1 second):
.=LOPJSLZWLLKPZHIV]LHWWYV_PTH[LS`TWORTO
.;OLHYLHHOLHKVM[OL]LOPJSLPZKHYR
.;OLYLHYLUVVUJVTPUNVYWYLJLKPUN]LOPJSLZ^P[OOLHKSPNO[ZVY[HPSSPNO[Z[\YULK
VU
.;OLYLHYLML^Z[YLL[SPNO[ZVU[OLYVHKHOLHK
If any of these conditions occur, high beams will be automatically turned off:
.=LOPJSLZWLLKKYVWZILSV^HWWYV_PTH[LS`TWORTO
.;OLHYLHHOLHKVM[OL]LOPJSLPZUV[KHYR
.6UJVTPUNVYWYLJLKPUN]LOPJSLZOH]LOLHKSPNO[ZVY[HPSSPNO[Z[\YULKVU
.;OLYLHYLTHU`Z[YLL[SPNO[ZVU[OLYVHKHOLHK AHB is a safety system designed to help drivers see more of what’s ahead at nighttime
while reducing glare for oncoming drivers, AHB uses an in-vehicle camera to help
detect the headlights of oncoming vehicles and tail lights of preceding vehicles,
then automatically switches between high and low beams as appropriate to provide
the most light possible and enhance forward visibility. By using high beams more
frequently, the system may allow earlier detection of pedestrians and obstacles.
Refer to the Toyota Owner’s Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.
(2) (1)
(1) Push lever away from you with the headlight switch is in the “
” or “AUTO”
position.
(2) Press the “
” switch.
The AHB indicator will come on when the headlights are turned on automatically
to indicate that the system is active.
Note: Pull the lever back toward you or press the AHB switch to turn the AHB
system off.
The AHB indicator will turn off. To turn switch to “
” position and the manual
high beam indicator “
” turns on.