ignition TOYOTA LAND CRUISER 2020 Owners Manual (in English)

5
Low fuel level warning
Parking brake indicatorShift position and range indicators
Low Tire Pressure Warning1
Malfunction/Check Engine indicator1
Master warning1,2
Second start indicator (Automatic
Transmission)
Power mode indicator
Slip indicator1,3
Low speed four-wheel drive indicatorMulti-terrain select indicator
ECO driving indicator1
Turn assist function indicator
TRAC OFF indicator1
Turn signal indicator
Fog light indicator
Open door warning Pre-Collision System (PCS)
warning
1,2
Lane Departure Alert (LDA) indicator
Headlight low/high beam
indicator
Vehicle Stability Control (VSC) OFF
indicator1
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURESDynamic Radar Cruise Control
(DRCC) indicator/DRCC SET
indicator
Driver seat belt reminder
(alarm will sound when the engine switch
is IGNITION ON mode)
Front passenger seat belt reminder
(alarm will sound if the seat belt is not
fastened)
1
If the indicator does not turn off within a few seconds of starting the \
engine, there may be a
malfunction. Have the vehicle inspected by your Toyota dealer.
2 If the indicator flashes, there may be a malfunction. Refer to the Owner\
’s Manual.3 If the indicator flashes, it indicates that the system is operating.4 If equipped.

19
Moonroof
Automatic mode
Open
Tilt
CloseClose
Recommended open position to minimize
wind noise.
Push once to open partway;
again to open completely.
The engine switch must be in the “ACCESSORY” or “IGNITION ON”\
mode for use.
Linked mirror function when reversing
The outside rearview mirrors automatically
angle downwards when vehicle is in reverse. Will only operate when switc\
h is in “L”
or “R” position.
SLIDING OPERATION TILTING OPERATION
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Push once to open completely.
Lightly press either side of the moonroof switch while opening/tilting i\
s in progress,
the moonroof stops partway.
Rear view mirror-Outside

23
REAR AIR CONDITIONING
FRONT SEATS
SECOND SEATS
Press or to cycle through.
Note: Auto setting changes according to
climate control temperature.
Blows air from the seat
Temperature selector (left side)
Automatic climate control ONClimate control OFF
Fan speedAirflow vent
Temperature selector (right side)
Turns the seat heater on
Automatically adjusts tocabin temperature
Off
AutoHiMidLo
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
The engine switch must be in the “IGNITION ON” mode for use.
Seat heaters/ventilators
Left
second seatRight
second seat

24
FEATURES & OPERATIONSMulti-Information Display (MID)
Select: To select an
item/change pagesPress: Enter, moves to next
screen and functions on/off
Up and down: Switches
screens and moves the cursor
Menu/Display: Switch
the top screenReturn: To previous
screen
Push “Multi-Information switches” to view or change information in\
the following:
Drive information
7ehicMe information disQMay if eRuiQQed

Navigation system-linked display
Audio system linked display
%riving assist system information if eRuiQQed

Warning messages
Settings display
The engine switch must be in the “IGNITION ON” mode.
Steering wheel-Heater

27
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Multi-terrain Select
Multi-terrain Monitor
Press “” switch while the engine switch is in IGNITION ON mode to check
vehicle surroundings.
Note: The amount of time that the screen is displayed changes according to
the vehicle speed at the time the VIEW switch was pressed. Speeds exceeding
approximately 7 mph (12 km/h) will cancel monitor viewing.
Refer to the Owner’s Manual for limitations and more details on this \
system before
attempting to use it.
Multi-terrain Select mode
select switch
MUD & SANDROCK
MOGULLOOSE ROCKROCK & DIRT
Multi-terrain Select mode
Multi-terrain Select is a system that helps drivability in off-road situ\
ations.
When the Crawl Control is turned off, a mode which matches the road cond\
itions
can be selected from among the following 5 modes.
MUD & SAND - Muddy roads, sandy roads, snow-covered roads, dirt trails and
other slippery or dirty conditions
LOOSE ROCK - Slippery conditions consisting of mixtures of earth and loose rock
MOGUL - Wide range of off-road conditions, particularly very bumpy conditions\
ROCK & DIRT - Very bumpy road conditions, such as mogul or rocky roads.
ROCK - Rocky terrain
Refer to the Owner’s Manual for limitations and more details on this \
system before
attempting to use it.

31
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Power outlets-12V DC
The engine switch must be in “ACCESSORY” or “IGNITION ON” mo\
de for use.
FrontRear
Power outlet-120V AC
The engine switch must be in “IGNITION ON” mode for use.

32
Qi Wireless charger
Parking brake
FEATURES & OPERATIONS
(2) Push
SetRelease
(1) Pull slightly
(3) Lower
Pull
A mobile device can be charged wirelessly on the tray. After press the l\
id to open,
(1) Press the wireless charger power switch and the green operation indicat\
or
light turns on. (2) Place a compatible mobile device on the tray as shown in the
illustration. An amber indicator illuminates while charging is in progre\
ss. When
charging is complete, the indicator illuminates green. Some phones, case\
s or cover
type wireless chargers may not cause the green indicator to illuminate e\
ven though
it is fully charged.
The engine switch must be in “ACCESSORY” or “IGNITION ON” mo\
de for use.
Refer to the Owner’s Manual for limitations and more details on this \
system before
attempting to use it.
Power switch
Charge area
Operation indicator
light
Press
When the engine is turned off, the last state (ON/
OFF) of the charger is memorized.
Place device nearest the center of charging area for
best results. Moving device may result in stopping
or restarting the charging process.
Place
(1)
(2)

37
%I4A#-I/( 13&$0--I4I0/ 4:45&. 1$4

To disable the system
Press the PCS switch for 3 seconds or more.
The PCS warning light will turn on and a message will be displayed on th\
e Multi-
Information %isQMay .I%
.
To enable the system
Press the PCS switch again.
The system is enabled each time the engine switch is turned to IGNITION \
ON mode.
Lane Departure Alert (LDA)
TURNING THE LDA SYSTEM ON/OFF
Press the LDA switch to turn the LDA system on. Depress again to turn it\
off.
Note: The system will continue in the last state it was in (ON or OFF) when the
engine is started again.
Refer to the Owner’s Manual for limitations and more details on this \
system before
attempting to use it.
LDA in TSS-P uses an in-vehicle camera designed to detect visible white \
and
yellow lane markers in front of the vehicle and the vehicle’s positio\
n on the road.
If the system determines that the vehicle is starting to unintentionally\
deviate from
its lane, the system alerts the driver with an audio and visual alert. W\
hen the alerts
occur, the driver must check the surrounding road situation and carefull\
y operate
the steering wheel to move the vehicle back to the center part of their \
lane.
-%A is designed to function at sQeeds of aQQroYimateMy  mQh  Lmh
or higher
on relatively straight roadways.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES

39
ADJUSTING LDA ALERT SENSITIVITY
SWAY WARNING SYSTEM
The sway warning function can detect swaying based on the vehicle locati\
on in the
lane and the driver’s steering wheel operation. To help prevent swayi\
ng, the system
alerts the driver using a buzzer sound and a warning displays in the MID\
.
Continuous lane deviations from
swaying.
Gentle swaying from driver’s
inattentiveness.
Acute steering wheel operation after the
number of operations decrease due to driver’s
inattentiveness.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
5he driver can adKust the sensitivity of the -%A warning
function from the
.uMtiInformation %isQMay .I%
customi[ation screen.
High - Is designed to warn approximately before the front
tire crosses the lane marker.
Normal - Is designed to warn approximately when the front
tire crosses the lane marker.

1ress i
” switches and select from the .uMtiInformation %isQMay .I%
.

6se i
” switches and select “LDA” and then press “”.

6se i
” switches and select “Alert sensitivity” and then press “” to
select the desired setting.

1ress “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.

40
TOYOTA SAFETY SENSE™
DISABLING LDA SWAY WARNING SYSTEM
ADJUSTING SWAY ALERT SENSITIVITY

1ress i” switches and select from the .uMtiInformation %isQMay .I%
.

6se i
” switches and select “LDA” and then press “”.

6se i
” switches and select “Vehicle sway warning sensitivity” and th\
en
press “
” to select the desired setting.

1ress “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.

1ress i
” switches and select from the .uMtiInformation %isQMay .I%
.

6se i
” switches and select “LDA” and then press “”.

6se i
” switches and select “Vehicle sway warning” and then press “\
”
to select the desired setting.

1ress “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.