tps TOYOTA RAV4 2006 Service Repair Manual

PS–12POWER STEERING – ELECTRONIC POWER STEERING SYSTEM
PS
(3) Read and write down any DTCs indicated by the
P/S warning light on the combination meter.
Refer to the chart below for examples of a
normal code and DTCs 21 and 22.
HINT:
• If the P/S warning light does not blink to
display any DTCs set or the normal code,
inspect the circuit shown in the table below.
• If two or more malfunctions are detected
simultaneously, DTCs will be displayed in
ascending numerical order.
(4) Refer to the Diagnostic Trouble Code Chart (See
page PS-16) for DTC information.
2. CLEAR DTC
(a) When using intelligent tester:
(1) Connect the intelligent tester (with CAN VIM) to
the DLC3.
(2) Turn the ignition switch ON and press the
intelligent tester main switch ON.
(3) Clear the DTCs by following the prompts on the
intelligent tester.
(4) Turn the ignition switch OFF.
(5) Disconnect the intelligent tester from the DLC3.
B128060E02
Trouble Area See Page
EPS warning light circuitPS-37