oil change AUDI A4 1998 B5 / 1.G AFC Engine Lock Carrier Removing For Service Workshop Manual

- Disconnect harness connector at oil pressure sensor and at oil
pressure switch.
- Disconnect harness connector at the Camshaft Position (CMP) sensor
housing.
- Disconnect vacuum pipe at intake manifold changeover valve (blue)
and also at EGR valve (brown).
Pa
ge 10 of 35 Lock carrier, removin
g for service
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.15.4

15-22

Hydraulic valve lifters, checking


Note:

Irregular valve noise during cranking is
normal.
Do not interchange hydraulic lifters. If
necessary mark them when they are being
removed.
Place lifters that have been removed on a clean
surface with the contact surface (camshaft end)
facing downward.
Hydraulic lifters cannot be repaired or adjusted.
Faulty lifters must be replaced.

- Start and run engine until warm-until radiator
coolant fan has come on at least once.

- Increase engine speed to approx. 2500 RPM for
2 minutes
If the irregular valve noise stops and then re-
occurs again each time vehicle is used in stop
and go traffic:

-
Replace the oil check valves Repair Group
Pa
ge 22 of 35 Lock carrier, removin
g for service
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.15.4