manual transmission AUDI A4 1998 B5 / 1.G Engine Oil Level Checking Workshop Manual

36

Manual transmission/final drive oil level,
checking


5-speed manual transmission 012/01W

Special tools and equipment

Key 3357, or
Hex key socket attachment, 17 mm AF

Note:
The vehicle must be absolutely horizontal when
checking transmission oil level. This work is
best performed over an inspection pit or using a
four column lifting platform.
The prescribed oil level is to be adhered to
exactly; the transmission reacts very sensitively
to over-filling.
The oil filter plug is on the left of the
transmission below the speedometer sender; it
may be concealed by the heat shield for the
drive shaft.

Depending on the version installed, use either special tool 3357 or a
17 mm hex socket key to loosen the oil filter plug.
Pa
ge 31 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6

38

6-spd. manual transmission 01E all wheel
drive

Note:

For checking oil level the vehicle must be
stationary and on a level surface (e.g engine
off, standing on an alignment lift).
The oil level must be kept at the specified level.
The transmission may be damaged by over-
filling.

CAUTION!
If the oil level is too low, the transmission must be checked for leaks
and repaired. It is not sufficient to just top off oil.
CAUTION!
Part numbers are for reference only. Always check with your Parts
Dept. for the latest parts information. - Remove filler plug -B-, on differential cover, in front of drive axle flange.
- Check oil level using tool such as angled wire.
Specification: level 1 mm below bottom of oil filler hole.
- If there are no leaks, top up with gear oil: SAE 75 W 90 (synthetic oil),
part number G 052 145 S2 (1 liter).
Pa
ge 33 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6