AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual

AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual A4 1999 B5 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/962/w960_962-0.png AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual

Page 21 of 26

AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual 13-34
 
    
Note:  
Before installing the transmission, check that the dowel sleeves for 
locating engine/transmission are fitted in the engine flange.  
 Repair Manual, 5 Spd. Automatic Transmission

Page 22 of 26

AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual 13-35
      
Needle bearing in dual-mass flywheel, 
removing and installing
 
    
-  Pull out with puller, such as KUKKO 21/2 and KUKKO 22-1.
-  Drive in with drift 3264. 
Pa
ge 22 of 26 C
ylinder bl

Page 23 of 26

AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual 13-36
      
Pistons and piston rings, installing
 
     
Pistons  
    
Position: arrow on piston crown must always face in direction of travel.   
Note:  
Do not use a center-punch or similar, as pi

Page 24 of 26

AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual 13-37
 
    
Ring-to-groove clearance  Clearance when new  
Wear limit  
0.02 ... 0.08 mm   0.10 mm  
    
Checking piston ring gap  
-  Push ring in squarely to a position approx. 15 mm from bottom e

Page 25 of 26

AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual 13-38
      
Cylinder bores, checking
 
    
Piston and cylinder dimensions  
Note:  
Replacement pistons are only available with basic dimension.  -  Measure bores at three points in both directions:

Page 26 of 26

AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual 13-39
      
Connecting rods and connecting rod 
bearings, installing
 
     
Note:  
     
Only replace complete sets of connecting 
rods 
     Do not interchange connecting rod bearings.
    
Checki
Page:   < prev 1-10 11-20 21-30