ignition AUDI A8 1999 D2 / 1.G 01V Transmission Read Measuring Value Block E 17 Workshop Manual

01-187


Read Measuring Value Block
(scan tool function 08) for
transmissions with hydraulic
control -E17-

Note:
For transmissions with hydraulic control -E18/2-,
"Read Measuring Value Block" page 01
-228


WARNING!

To avoid accidents during measuring and test
drives, observe safety precautions page
01
-34
.

Procedure

- Connect VAS 5051 tester or V.A.G 1551 Scan
Tool (ST) and select Transmission Control
Module (TCM) using "address word" 02 page
01
-36
. Ignition must remain switched on.
Rapid data transfer
HELP
Select function XX

Indicated on display
- Press PRINT button to turn on ST printer. Indicator lamp in button must
light up.
- Press buttons -0- and -8- to select "Read Measuring Value Block" and
press -Q- button to confirm input.
Pa
ge 1 of 49 Read Measurin
g Value Block
(scan tool function 08
) for transmissions with h
ydraulic control -E17-
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.13

01-207
Only for transmission with hydraulic control -E17-
Display
group
number Display
field Description
Test
requirements Spec. value on
V.A.G 1551
display Corrective actions
004

without
CAN-bus 4 Engine
intervention
(ignition
intervention) While driving
1)
Engine speed
signal OK
- See DTC table, DTC 00545, 18192
and 18193 page 01
-45


is
switched on

Engine interv. - Perform electrical test page 01
-273
- Check wire connection to Engine
Control Module (ECM)

is
switched off -
- Only replace Transmission Control
Module (TCM) -J217- if necessary
page 01
-11

1) While driving, a second mechanic is required to read specifications.
Notes for display field 4 of display group number 004 are on the next page:
Pa
ge 27 of 49 Read Measurin
g Value Block
(scan tool function 08
) for transmissions with h
ydraulic control -E17-
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.13

01-224
Notes for display group number 009;

This display group number 009 is only valid for vehicles without CAN-bus, refer to previous display group number 009 for
vehicles with CAN-bus. A)
For vehicles with motronic injection and ignition systems, engine torque is transmitted by the Engine Control Module
(ECM). For these vehicles, the fuel consumption display is omitted or always indicates "00ms".
A) There is a distinction made between vehicles with and without CAN-bus. For information on which vehicles are equipped
with CAN-bus
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00, engine codes, aggregate allocation, ratios,
equipment

Pa
ge 46 of 49 Read Measurin
g Value Block
(scan tool function 08
) for transmissions with h
ydraulic control -E17-
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.13