ECU BMW MOTORRAD K 1200 LT 2002 Rider's Manual (in English)

33
General information and controls
1B
A
1Front seat
Adjusting the front seat:Open the seat (b 32)
Swivel adjusting bracket 1
into desired position (arrow)
and make sure it engages
with an audible click
–The front seat can be moved
to 2 positions:
–A = highB = low
Locking the front seat
e Caution:
When closing the front seat:
–Fold in handwheel for adjust-
ing spring strut.
–Check that front seat is firmly
secured.
Swing front seat toward rear
until latch engages with an
audible click
Lock left case (
b 30)
10LTbkg4.bk Seite 33 Dienstag, 27. August 2002 8:28 08

34
General information and controls
1
Rear seat
Adjusting backrest:
L Note:
The backrest can be adjusted
by moving the topcase by one
setting.
It is advisable to have this
adjustment performed by your
BMW motorcycle dealer.
Place the motorcycle on its
main (centre) stand
–Make sure the ground is
level and firm.
Open the seat (
b 32)Remove screws1 securing
rear seat
Raise rear seat slightly and
disconnect plug2 for seat
heating
OE
Carefully pull rear seat for-
ward
Remove connectors3 and4
for loudspeakers from their
holders and disconnect by
turning counter-clockwise
Remove connector cables3
and4 from their holders
2(Optional extra
2
1
34
10LTbkg4.bk Seite 34 Dienstag, 27. August 2002 8:28 08

35
General information and controls
1
Rear seat
Open the topcase (b 31)
Slacken knurled screw5
Hold topcase lid
Carefully disconnect retaining
strap6
e Caution:
To avoid damaging the topcase
lid hinges and the loudspeak-
ers, hold the topcase lid in po-
sition or fit suitable supports
beneath it.Carefully raise topcase lid
Unfasten inner Velcro fas-
tener strip at pointA
Press back retaining clips at
pointsB andC using a small
screwdriver
Carefully lift the inner shell out
of the topcase
Remove 4 securing screws7
from topcase
Carefully remove topcase
5B
6
A
BC
7
10LTbkg4.bk Seite 35 Dienstag, 27. August 2002 8:28 08

36
General information and controls
1
Rear seat
Reposition retaining screws8
(short) in the retaining plate
(arrow)
e Caution:
The retaining screws on the
topcase and retaining plate
have different lengths. Do not
interchange them.
–Backrest can be adjusted one
settingCarefully fit the topcase
Tighten four retaining
screws7 (long) in topcase to
correct tightening torque
From this point on, installation
is the reverse of the removal
procedure
X Tightening torque:
Securing screws for
topcase........................... 9 Nm
retaining plate ................. 9 Nm
rear seat ......................... 9 Nm
8
8
8
8
10LTbkg4.bk Seite 36 Dienstag, 27. August 2002 8:28 08