buttons BMW SPORT WAGON 2001 User Guide

122n
BMW Universal Transmitter
*
Programming1 Channel buttons
2 Indicator lamp
3 Receiver for programming
Read and comply with the safety
precautions on page 121.<
1 Ignition key in position 2.
2 For initial operation: press and hold
the two outer buttons 1 until the indi-
cator lamp 2 flashes. Release the
buttons. The three channel buttons
are cleared.390de640
3 Hold the original hand-held transmit-
ter at the receiver 3 a maximum of
2 in (5 cm) away.
4 Simultaneously press the transmitting
key of the original hand-held trans-
mitter (arrow 2) and the desired chan-
nel button of the BMW Universal
Transmitter (arrow 1). Release both
buttons as soon as the indicator lamp
flashes rapidly.
5 To program other original hand-held
transmitters, repeat steps 3 and 4.
The corresponding channel button is
now programmed with the signal of the
original hand-held transmitter.380de712
Programming a hand-held
transmitter with change code
Read and comply with the safety
precautions on page 121.<
Consult the operating instructions for
the individual device when program-
ming the BMW Universal Transmitter.
Read and comply with the following
programming instructions for the use of
the BMW Universal Transmitter with a
change code system:
A second person simplifies pro-
gramming of the BMW Universal
Transmitter.<

IndexDataTechnologyRepairsCar careControlsOverview
123n
BMW Universal Transmitter
*
1 Program the BMW Universal Trans-
mitter as described above under
"Programming."
2 Press and hold the programming but-
ton on the receiver of the device for
about two seconds or until the pro-
gramming lamp on the device comes
on.
3 Press the desired channel button of
the BMW Universal Transmitter three
times.
If you have additional questions,
please consult your BMW cen-
ter.<
Clearing the channel buttons
Read and comply with the safety
precautions on page 121.<
Individual channel buttons cannot be
cleared. However, the three channel
buttons can be cleared together in the
following manner:
>Press and hold the two outer channel
buttons of the BMW Universal Trans-
mitter until the indicator lamp flashes,
and then release the buttons.
All channel buttons are cleared.
User's informationDo not use this BMW Universal Trans-
mitter with any garage door opener that
lacks safety "stop" and "reverse" fea-
tures as required by federal safety stan-
dards (this includes any garage door
opener model manufactured before
April 1, 1982).
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any inter-
ference received, including interference
that may cause undesired operation.

Index
Data
Technology
Repairs
Car care
Controls
Overview
133nLuggage compartment – sport wagon
Removing the roll-up cover and
partition net
1 Press on the buttons (arrow 1) to re-
lease the case on both sides.
2 Holding the case straight, pull out to the rear (arrow 2).
Installation
Simply slide the case forward in the two
side holders until it engages.
392de164
Storage
There are holders for the case in front
of the rear seats.
Guide the case in from the side as
shown in the illustration. The strap of
the partition net must be directed up-
ward, while the end of the roll-up cover
must be laid around and under the case
to the rear.
You can pull the partition net out and
insert it in the holders above it in the
upper roof area.
392de165
Side covers
Open the side covers by pressing the
button.
392de166

Everything from A to Z
233n
IndexDataTechnologyRepairsCar careControlsOverview
Rear wiper blade, blade
replacement182t
Rear-seat backrest,
removable128
Rearview mirror57
Recirculated air mode110
Recirculated-air control117
Reclining seat52
Refueling28
Releasing fuel filler door after
electrical defect198t
Releasing the hood159t
Reminder signal93
Remote control39
computer99
Removable rear-seat
backrest128
Removing condensation
from the
windows113t, 117t
from the
windshield113t, 117t
Replace wiper
blades182t
Replacement keys36
Replacement of tires151
Replacing fuses196t
Reporting safety defects7
Reservoir, washer
fluids164t
Residual heat118
Restraint system62Reverse71
Rims153
Roller sun blind120
Roof load capacity221
Roof-mounted luggage
rack137
Rubber parts147
SSafety belt tensioner210
Safety belts61
Safety lock buttons42
Seats
electric power52
forward/backward
adjustment52, 55
heating119
height adjustment52
machanical53
mechanical53
memory58
Secure the load46, 136
Selector lever, automatic
transmission72, 75
Self-dimming rearview
mirror211
Service and Warranty
Information Booklet
(US models)170
Service Interval
Display85, 170
Servotronic148Shift lever70
Shiftlock72, 75
Shoulder support54
Shutting off the engine69
Side airbags62
Side Impact Head Protection
System62
Side lamps, bulb
replacement184t
Ski bag129
Ski bag in the sport
wagon131
Skid control148
Sliding148
Sliding/tilt sunroof50
closing after an after an
electrical defect198t
convenience operation38
glass moonroof51
manual operation198
power supply
interruption51t
remote control40
Slippery roads147
Snow chains147, 155t
Socket127
Sound system, refer to
DSP211
Spare key36
Spare tire191t
Spark plugs224
Speaker125Special oil166t
Specifications for engine
oil166
Speed98
Speed control81
Speed limit95, 96
Speedometer18, 20
sport wagon
compartments in the
luggage
compartment133
folding down the rear
backrest132
lashing eyes136
load-securing
devices136
luggage
compartment132
luggage compartment
lamps, bulb
replacement189t
opening the rear
window44
partition net132
rear window wiper80
rear window wiper, blade
replacement182t
releasing the fuel filler
door after an electrical
defect198t
releasing the tailgate after
an electrical defect199t