key fob BUICK LACROSSE 2006 Get To Know Guide

5
Your ignition key identifies you to the
vehicle.Two keys can be programmed
for certain features that correspond to
each driver. To personalize a key:
1. From the Personal Program menu,
press the (Option) button until
“PERSONALIZE KEY” is displayed.
2. Press the (Set/Reset) button until
“YES” is displayed.
3. Press the button.
Personalization Features include:
•
Delayed Locking—Delays locking
of the vehicle doors for up to five
seconds after the last door is closed.Two chimes will sound when the
power door lock switch or the Lock
button on the Remote Keyless Entry
transmitter is pressed when a door is
open. To program:
1. From the Personal Program menu,
press the (Option) button until
“DELAYED LOCKING” is displayed.
2. Press the (Set/Reset) button until
“ON” or “OFF” appears.
3. Press the button to select it.
The ignition key must be removed for
the feature to work after programming.
•
Key Fob Feedback—Choose from
Off (no feedback), Lights (exterior
lights flash) or Lights and Horn when
you press the Remote Keyless Entry
transmitter (key fob) Lock button. To
program:
1. From the Personal Program menu,
press the (Option) button until
“FOB LOCK FEEDBACK” is displayed.
2. Press the (Set/Reset) button until
the desired setting is displayed.
3.Press the button to save the
setting.•
Exterior Light Delay—Sets the
time for exterior lights to remain on
after the key is removed from the
ignition or the vehicle is unlocked with
the Remote Keyless Entry transmitter.
To program:
1. From the Personal Program menu,
press the (Option) button until
“EXT LIGHT DELAY” is displayed.
2. Press the (Set/Reset) button to
scroll through OFF or 15/30/60/90
second delays.
3. Press the button to store a setting.
You can also use the (Option) and
(Set/Reset) buttons to personalize
each of the following:
• Return settings to factory
default/reset all keys
• Interior lights on when key is
removed from the ignition
• Content theftdeterrent system on/off
• Remote start on/off
• Personalize/replace key
• Personalize radio stations
• Auto door lock on/off
• Auto door unlock all/driver’s door/off
• Key fob unlock driver’s door/all doors
on first press
Exiting Programming Mode:The DIC
exits programming mode when:
•The vehicle is shifted out of Park.
• The vehicle is no longer in Run.
• You reach the end of the Personal
Program menu.
See Section 3 of your Owner Manual.

Getting to Know YourLaCrosse6
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine from out
side the vehicle. (See the Driver
Information Center personalization menu
section to enable.) Automatic Climate
Control system vehicles will regulate the
inside temperature.
To remote start the vehicle:
1. Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.
If the lights are not visible, hold the
Remote Start button for four seconds
and release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present by
pressing the Lock and Remote Start but
tons again. Pressing only the Remote
Start button again will turn off the igni
tion. Maximum run time is 20 minutes.
After two remote starts have been pro
vided, the Remote Vehicle Start feature
will not operate.
See Section 2 of your Owner Manual.
Unlocking the Doors with the Key
Your vehicle’s passenger doors can be
unlocked using the driver’sdoor key.
With the key in the lock cylinder:
• Turn the key toward the front of the
vehicle to unlock the driver’s door.
• Turn and hold the key toward the
front of the vehicle for two seconds to
unlock all doors.
• Turn and hold the key toward the rear
of the vehicle to lock all doors.
See Section 2 of your Owner Manual.
Headlamp Controls and
Automatic Headlamp System
You will find the exterior lamps knob on
the left side of the instrument panel.
(On/Off):If the switch is in the AUTO
position but lights are off, turn them on
by turning the switch to (On/Off) and
release. To turn the headlamps off when
the lights are on, turn the control to the
position. The momentary switch
design springs back to AUTO when
released.
AUTO:Activates the automatic head
lamp system, illuminating all exterior
lamps and the instrument panel/radio
lights when needed.
(Parking Lamps):The parking lamp
position illuminates tail/side marker/
license plate lamps and instrument
panel/radio lights.