brake pads BUICK REGAL 1995 Owners Manual
[x] Cancel search | Manufacturer: BUICK, Model Year: 1995, Model line: REGAL, Model: BUICK REGAL 1995Pages: 340, PDF Size: 17.16 MB
Page 233 of 340

Brake Wear
Your Buick has four-wheel disc brakes.
Disc brake pads have built-in wear indicators that make
a high-pitched warning sound when the brake pads are
worn and new pads are needed. The sound may come
and go or be heard all the time your vehicle is moving
(except when you are pushing
on the brake pedal
firmly),
NOTICE:
Continuing to drive with worn-out brake pads
could result in costly brake repair.
Some driving conditions or climates may cause a brake
squeal when the brakes are first applied or lightly
applied.
This does not mean something is wrong with
your brakes.
Brake linings should always be replaced as complete
axle sets.
Brake Pedal Travel
See your dealer if the brake pedal does not return to
normal height, or
if there is a rapid increase in pedal
travel. This could be a sign of brake trouble.
Brake Adjustment
Every time you make a moderate brake stop, your disc
brakes adjust for wear.
If you rarely make a moderate
or heavier stop, then your brakes might not adjust
correctly.
If you drive in that way, then -- very
carefully
-- make a few moderate brake stops about
every
1,000 miles (1 600 km), so your brakes will adjust
properly.
6-25
ProCarManuals.com
Page 307 of 340

Part C: Periodic Maintenance
Inspections
Listed below are inspections and services which should
be performed at least twice
a year (for instance, each
spring and fall).
You should let your GM dealer's
service department
or other qualified service center do
these
jobs. Make sure any necessary repairs are
completed at once.
Restraint Systems
Now and then, make sure all your belts. buckles, latch
plates, retractors, anchorages and reminder systems are
working properly. Look for any loose parts or damage.
If
you see anything that might keep a restraint system
from doing its job, have
it repaired.
Steering, SuSpension and
Front-Wheel-Drive Axle Boot and
Seal Inspection
Inspect the front and rear suspension and steering system
for damaged, loose or missing parts, signs of wear. or
lack of lubrication. Inspect the power steering lines and
hoses for proper hookup. binding, leaks, cracks, chafing,
etc. Clean and then inspect the drive axle boot seals
for
darnage, tears or leakage. Replace seals if necessary.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the body
near the exhaust system. Look for broken. damaged,
missing or out-of-position parts
as well as open seams.
holes. loose connections,
or other conditions which
could cause a heat build-up
in the tloor pan or could let
exhaust fumes into the vehicle. See "Engine Exhaust"
in
the Index.
Throttle Linkage Inspection
Inspect the throttle linkage for interference or binding.
and ,for dalnaged or missing parts. Replace parts
as
needed. Accelerator and cruise control cables should not
be lubricated.
Brake System Inspection
Inspect the complete system. Inspect brake lines and
hoses for proper hookup. binding, leaks. cracks, chafing,
etc. Inspect disc brake pads for wear and rotors for
surface condition. Inspect other brake parts. including
calipers, parking brake, etc. Check parking brake
acl-justment. You may need
to have your brakes inspected
more often
if yo~~r driving habits or conditions result in
frequent braking.
7-39
ProCarManuals.com