seat memory CHEVROLET AVALANCHE 2002 1.G Owners Manual

1-4

To increase support in the lower back area, press and
hold the front of the control. Let go of the control
when the lower seatback reaches the desired level
of support.

To decrease support in the lower back area, press
and hold the rear of the control. Let go of the
control when the lower seatback reaches the desired
level of support.

You can also reshape the back wing area of the
lower seatback.

To increase support in the wing area of the lower
seatback, press and hold the top of the control.
Let go of the control when the lower seatback
reaches the desired level of support.

To decrease support in the wing area of the lower
seatback, press and hold the bottom of the control.
Let go of the control when the lower seatback
reaches the desired level of support.Memory Seat (If Equipped)
The memory function
recalls the driver's seat
cushion and recliner
positions. The buttons
are located on the driver's
side door panel.
This feature does not store the lumbar or back
support positions.
To set your memory seat do the following:
1. Adjust the driver's seat to the desired position.
2. Press the SET button and then press either the
1 or 2 memory button within five seconds.
When your vehicle is in PARK (P), press the same
memory button to recall the seat setting.
To program the seat for a second driver, follow the
preceding steps, but press the other memory button.

2-94
Sunroof (If Equipped)
Your vehicle may be equipped with a power sliding
sunroof. To open or close your sunroof, the ignition or
RAP needs to be on. See ªRetained Accessory Powerº
in the Index.
Press and release the rear side of the button located in
the front overhead console to express
-open the glass
panel and sunshade. To close the glass panel, press and
hold the front of the button. The glass will not be fully
seated unless the button is held until the glass stops
moving. With the sunroof closed, press the forward side
of the button to open the sunroof to the vent position.The sunroof is also equipped with a sunshade which
you can pull forward to block sun rays.
If a hand, arm, or other object is blocking the sunroof
glass panel as it is closing, the glass panel will stop at
the obstruction. After the obstruction is removed,
the glass panel can be closed or opened.
Use care not to leave the sunroof open for long periods
of time as debris may collect in the tracks.
If the battery has been recharged, disconnected or is
not working, you may need to reprogram the sunroof.
To do this, start the vehicle and press the forward side of
the sunroof button until the glass panel moves to a fully
closed position. Release, and press again to move to the
vent position which occurs when the sunroof is fully
tilted rearward. This will reset the memory and enable
the sunroof to function properly.