buttons CHEVROLET BLAZER 1997 2.G User Guide

Downloaded from www.Manualslib.com manuals search engine I. Write down any three or four-digit number from
000 to 1999 and keep it in a safe place separate from
the vehicle.
2. Turn the isnition to ACCESSORY or RUN.
3. Turn the radio off.
4. Press the 1 and 4 buttons together. Hold thcm dow~l
until --- shows on the display. Next yo11 will use the
secret code number which
you have written down.
5. Press MN and 000 will appear on the display.
6. Press MN again to make the last two digits agree
with your code.
7. Press HR to 111ake the first one or two digits agree
with your
code.
8. Press AM-FM after- you have confirmed that the
code matches the secret code
you ha\;e written down.
The display will show REP to Ict you
know that you
need to repeat Steps 5 through 7 to confirm your
secret code.
Unlocking the Theft-Deterrent Feature After a
Power
Loss
Enter your secret code as follows: pause no more than
I5 seconds between steps:
1. LOC appears when the ignition is on.
2. Press MN and 000 cvill appear on the display.
3. Press MN again to lnake the last two digits agree
with your code.
4. Press HR to make the first one or two digits agree
with your code.
5. Press AM-FM after you have confirmed that the
code matches the secret code
~OLI have written down
The display will show SEC, indicating the radio is
now operable and secure.
If ~OLI enter the wrong code eight times, INOP will
appear on the display. You will have to wait an hour
with the ignition on before yo11 can try apin. When you
try asain. you will only have three chances to enter the
correct code before
lNOP appears.
If you lose or forger your code. contact your dealer.
3-18

Downloaded from www.Manualslib.com manuals search engine Disabling the Theft-Deterrent Feature
Enter your secret code as follows; pause no more than
15 seconds between steps:
1. Turn the ignition to ACCESSORY or RUN.
2. Turn the radio off.
3. Press the 1 and 4 buttons together. Hold them down
until SEC shows on the display.
4. Press MN and 000 will appear on the display.
5. Press MN again to make the last two digits agree
with your code.
6. Press HR to make the first one or two digits agree
with your code.
7. Press AM-FM after you have confirmed that the
code matches the secret code you have written down.
The display will show
---, indicating that the radio is
no longer secured.
If the code entered is incorrect, SEC will appear on the
display. The radio will remain secured until
the correct
code is entered.
When battery power is removed and later applied
to a
secured radio, the radio won’t turn
on and LOC will
appear
on the display. To
unlock a secured radio,
see “Unlocking the
Theft-Deterrent Feature After
a Power Loss” earlier in
this section.
Understanding Radio Reception
FM Stereo
FM stereo will give you the best sound. But FM signals
will reach only about 10 to 40 miles (16 to 65 km). Tall
buildings or hills can interfere with
FM signals, causing
the sound to come and go.
AM
The range for most AM stations is greater than for FM,
especially at night. The longer range, however, can
cause stations to interfere with each other.
AM can pick
up noise from things like storms and power lines. Try
reducing
the treble to reduce this noise if you ever get it.
Tips About Your Audio System
Hearing damage from loud noise is almost undetectable
until it is too late. Your hearing can adapt to higher
volumes
of sound. Sound that seems normal can be loud
and harmful to your hearing. Take precautions by
adjusting the volume control on your radio to
a safe
sound level before your hearing adapts
to it.
3-19