remote start CHEVROLET CORVETTE 2021 Get To Know Guide

4
REMOTE KEYLESS ENTRY TRANSMITTER (KEY FOB)
X2 Hatch/Trunk Release
Press and release followed by press and hold to open the hatch/trunk.
Lower Convertible TopF
Press and release the Unlock button and then press and hold the button to lower the top.
Press and release the Lock button and then press and hold the button to open the engine compartment.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle. The horn sounds and lights flash 3 times.
Press and hold to activate the alarm. Press again to cancel the alarm.
KEY RELEASE
If vehicle power is lost, press the button on the side of the transmitter to pull out the key. Use the key to open the door. Pull the looped cord below the instrument panel to open the hood for access to the battery.
Lock
Press to lock all doors and the fuel door. Press again to fold the power mirrorsF.
Unlock
Press to unlock the driver’s door and the fuel door only or all doors, based on vehicle settings. Press and hold for 3 seconds to open all windows.
To enable automatic mirror foldingF when using the Lock and Unlock buttons, go to Settings > Vehicle > Comfort and Convenience > Remote Mirror Folding.
[ Remote Vehicle Start
Press twice to start the engine from out-side the vehicle. The turn signal lamps will flash. After entering the vehicle, turn on the ignition.
X2 Hood Release
Press and release followed by press and hold to open the hood.
F Optional equipment
Note: To change or enable some Remote Keyless Entry settings, go to Settings > Vehicle > Remote Lock, Unlock, Start. See Keys, Doors and Windows in your Owner’s Manual.
The system enables operation of the doors, hatch/trunk, and hood without removing the Remote Keyless Entry (RKE) transmitter from your pocket or purse. The transmitter must be within 3 feet of the hatch/trunk, hood or door being unlocked.
KEYLESS UNLOCKING
With the RKE transmitter within range:
Press the driver’s door handle touchpad (A) to unlock the driver’\
s door only or all doors.
Press the passenger’s door handle touchpad to unlock all doors.
KEYLESS LOCKING
Press the Lock button on the RKE transmitter or interior door panel to lock all doors.\
If Passive Locking is turned on in the Settings menu, all doors will loc\
k automatically after a short delay once all doors are closed.
See Keys, Doors and Windows in your Owner’s Manual.
KEYLESS ACCESS SYSTEM
A

5F Optional equipment
KEYLESS ACCESS SYSTEM
PASSIVE LOCKING
To have all doors lock automatically after a short delay when the igniti\
on is off, the RKE transmitter is removed from the vehicle, and all doors are closed, g\
o to Settings > Vehicle > Remote Lock, Unlock, Start > Passive Door Lock.
To have the driver’s door or all doors unlock when using the touchpad on the driver’s door handle, go to Settings > Vehicle > Remote Lock, Unlock, Start > Passive Door Unlock.
HATCH/TRUNK ACCESS
The vehicle must be in Park.
Press and release followed by press and hold the X2 button on the RKE transmitter, press and hold the button on the driver’s door, or press the touchpad (B) above the license plate with the vehicle unlocked or, if locked, with the RKE transmitter within range.
When closing the hatch/trunk, set the
decklid into the power latch. The latch will close automatically.
HOOD ACCESS
The vehicle must be in Park.
Press and release followed by press and hold the X2 button on the RKE transmitter, press and hold the button on the driver’s door, or press the touchpad (C) in the driver-side grille opening below the headlamp.
When closing the hood, set the hood striker into the latch and then press on the front edge of the hood until the latch clicks twice. Never drive without the hood fully closed.
AUXILIARY DOOR RELEASES
If the vehicle battery is weak or disconnected, the doors can be opened manually.
From inside the vehicle, pull the driver’s or passenger’s door release handle (D) on the floor near each door opening.
From outside the vehicle, use the mechanical key from the RKE transmitter in the key
cylinder, located rearward of the driver’s door handle in the air inlet (E), to open the driver’s door, or in the key cylinder behind the license plate to open the hatch/trunk.See Keys, Doors and Windows in your Owner’s Manual.
E
D
C
B

6
STARTING THE ENGINE/ON
With the transmission in Park, press the brake pedal and then press the ENGINE START/STOP button to start the engine. The green button indicator will illuminate.
Note: If the Remote Keyless Entry transmitter battery is weak, place the transmitter in the rear cupholder in the center console to enable the engine to start. Replace the transmitter battery as soon as possible.
STOPPING THE ENGINE/OFF
Shift to Park and press the ENGINE START/STOP button to turn off the engine.
ACCESSORY MODE
With the engine off and the brake pedal not depressed, press the ENGINE START/ STOP button to place the ignition in accessory mode to operate the radio, wi\
ndows and other accessories. The amber button indicator will illuminate.
BATTERY LOCATION
The battery is located under a cover in the underhood compartment. To ac\
cess the
battery, remove the left and right side shields first before removing \
the cover assembly.
BATTERY CHARGERF
If the vehicle is not driven weekly, or the battery is disconnected or d\
rained, use the
optional battery maintainer to charge the battery. To operate the batter\
y maintainer, plug it into a standard electrical outlet and into the vehicle’s underhood ac\
cessory power outlet.
See Vehicle Care in your Owner’s Manual.
WINDOW PROGRAMMING
To provide a tight seal, window indexing automatically lowers the window\
slightly when the door is opened and then automatically raises the window when the doo\
r is closed.
If battery power is disconnected, program the power windows:
1. Close all doors and start the vehicle.
2. Partially open the window to be programmed and then fully close the wind\
ow. Continue to hold up the window switch briefly after the window has clo\
sed.
3. Fully open the window. Continue to hold down the window switch briefly\
after the window has opened.
Note: The power windows’ express-close feature and the power convertible topF will not operate until the windows are programmed.
See Keys, Doors and Windows in your Owner’s Manual.
KEYLESS (PUSHBUTTON) START
BATTERY TIPS
The Remote Keyless Entry transmitter must be in the vehicle to turn on t\
he ignition.
See Driving and Operating in your Owner’s Manual.
F Optional equipment

15
COUPE ROOF PANEL
CONVERTIBLE TOP OPERATIONF
It may be necessary to have two people remove the roof panel. Refer to your Owner’s Manual for complete instructions.
The roof panel is secured with two front levers and one rear lever. To unlock the roof panel, pull the two front levers outward and then press the button on the front of the rear lever and pull the lever down.
When removed, secure the roof panel with the interior facing forward and the rear pins in the lower receivers on the rear storage compartment floor. Push eac\
h front corner of the panel forward until it clicks into the upper receivers. If not pr\
operly secured, damage to the panel may occur.
During roof panel installation, install the rear edge of the panel fir\
st.
Note: A Corvette Accessory Roof Panel Storage BagF is available to protect the panel when not installed on the vehicle.
See Keys, Doors and Windows in your Owner’s Manual.
Before operating the power convertible top, ensure that the roof and tonneau cover are clear of any objects and that the trunk is closed. When possible, operate the convertible top when the vehicle is stopped. If necessary, the top can be operated at vehicle speeds up to 30 mph.
POWER TOP OPERATION
1. Start the vehicle.
2. Press and hold down the Convertible Top button (A) on the driver’s door to lower the top; pull and hold up \
the button to raise the top. The windows will lower automatically.
3. A chime will sound when the top is completely lowered or raised.
The top also may be opened using the Remote Keyless Entry transmitter.
Press and release the Unlock button and then press and hold the Convertible Top button to lower the top.
Note: After a loss of vehicle power, program the power windows in order to operate the convertible top.
REAR WINDOW OPERATION
Press the Rear Window button (B) on the driver’s door to lower the rear window. To help deflect the wind, the rear window will not lower completely. P\
ull the button to raise the rear window. The window can be lowered with the conv\
ertible top up or down.
See Keys, Doors and Windows in your Owner’s Manual.
F Optional equipment
A
B