clock CHEVROLET KODIAK 2009 User Guide

5. Open the fuel filter vent
valve by turning the
screw counterclockwise
several full turns.
6. Repeatedly push down
on the fuel filter primer
pump with the palm of
your hand. Let the
pump return upward
between pushes.7. Operate the priming pump until a small amount of
fuel seeps from the vent valve. When fuel is seen,
the filter is full of fuel and the system should be
primed.
8. Close the vent valve.
9. Clean any fuel that accumulated on the fuel filter.
10. Start the engine and let it idle for a few minutes.
11. Check the filter for leaks.
5-15

Priming the 7.8L Duramax®Diesel Engine
If the vehicle is equipped with the 7.8L Duramax®diesel
engine, use the following procedure to prime the engine:
1. Make sure there is fuel in the fuel tank.
2. Make sure the specified fuel filter is properly
installed.
3. Make sure the fuel lines are securely connected.4. Make sure the fuel filter is cool to the touch.
5. Use a clean cloth to remove dirt and oil from the
fuel filter head and breather valve.
6. Use the palm of your hand to repeatedly press
and release the plunger at the top of the fuel filter
priming pump. Continue until the plunger resistance
becomes firm. This may take from 20 to 100 times,
depending upon fuel tank location.
7. Turn the fuel filter breather valve screw
counterclockwise several turns to open the
breather valve.
8. Use the palm of your hand to repeatedly press and
release the plunger at the top of the fuel filter
priming pump until fuel begins to seep from the
breather valve.
9. Tighten the fuel filter breather screw to the specified
torque, 4.9Y(43 lbs. in.).
10. Use the palm of your hand to press and release the
plunger at the top of the fuel filter priming pump
about 20 more times. This sends fuel to the engine.
11. Use a clean cloth to remove any fuel from the fuel
filter and surrounding area.
12. Start the engine and allow it to idle for a few
minutes.
13. Check the fuel filter for leakage.
5-16

4. Install the new filter element.
5. Reinstall and tighten the filter container and
reconnect the water sensor wire to the filter.
6. Use the fuel filter priming procedure earlier in this
section to prime the fuel filter.
7. Tighten the air bleed valve by turning it clockwise
until hand-tight.
8. Start the engine and let it idle for five minutes.
Check the fuel filter and air bleed valve for leaks.
How to Reset Fuel Filter Change
Light - DURAMAX 6.6L (LMM) Engine
The engine controller calculates when to change the fuel
filter based on vehicle and fuel use. Whenever the
fuel filter is changed, reset the fuel filter light so
the engine controller can calculate when the next fuel
filter change is required. If the fuel filter is ever changed
prior to a change fuel filter light being turned on,
reset the fuel filter change light.To reset the Fuel Filter Change light:
1. Turn the ignition key to ON/RUN with the engine off
2. Fully press the accelerator and brake pedals at the
same time for 10 seconds. If the Fuel Filter Change
light flashes for 5 seconds, the system is resetting.
3. Turn the key to OFF.
If the Fuel Filter Change light comes back on when you
start the vehicle, the light has not been reset. Repeat
the procedure. SeeChange Fuel Filter Warning Light on
page 3-45for more information.
Fuels in Foreign Countries
If you plan on driving in another country outside the
United States or Canada, the proper fuel might be hard
to find. Never use leaded gasoline or any other fuel
not recommended in the previous text on fuel. Costly
repairs caused by use of improper fuel would not
be covered by the vehicle warranty.
To check the fuel availability, ask an auto club, or
contact a major oil company that does business in the
country where you will be driving.
5-19

Filling the Tank
{CAUTION:
Fuel vapor is highly flammable. It burns violently,
and that can cause very bad injuries. Do not
smoke if you are near fuel or refueling the vehicle.
Keep sparks, flames and smoking materials away
from fuel.
The fuel cap can be on either or both sides of the
vehicle depending on option content.
To take off the cap, turn it slowly counterclockwise. Fuel caps for all
gasoline applications,
and all diesel between
frame rail fuel tank
applications
Fuel caps for all side
mounted diesel
applications
5-20

{CAUTION:
If you get fuel on yourself and then something
ignites it, you could be badly burned. Fuel can
spray out on you if you open the fuel cap too
quickly. This spray can happen if the tank is nearly
full, and is more likely in hot weather. Open the
fuel cap slowly and wait for any “hiss” noise to
stop. Then unscrew the cap all the way.
When reinstalling the cap, turn it clockwise until it is
tight.
Notice:If you need a new fuel cap, be sure to get
the right type. Your dealer/retailer can get one
for you. If you get the wrong type, it may not fit
properly. This may cause the malfunction indicator
lamp to light and may damage the fuel tank and
emissions system. SeeMalfunction Indicator Lamp
on page 3-36.If the vehicle has dual tanks, fill the driver side tank,
or forward tank, first. The fuel gage will give better
readings this way. The gage will show the total fuel left
in both tanks.
If the vehicle is a C4/C5 model and has dual tanks, the
engine must be off when refueling or the fuel transfer
system may become inoperable.
If the vehicle has a single tank with dual fillers, where
there is a filler on each side of the vehicle, do not
attempt to fill the tank through both fillers at the same
time. Do not fill the tank with both caps removed or
over-filling the tank and fuel spillage can result.
5-21

{CAUTION:
You can be burned if you spill coolant on hot
engine parts. Coolant contains ethylene glycol and
it will burn if the engine parts are hot enough. Do
not spill coolant on a hot engine.
1. You can remove the
coolant surge tank
pressure cap when
the cooling system,
including the coolant
surge tank pressure
cap and upper radiator
hose, is no longer hot.
Turn the pressure cap slowly counterclockwise
about one full turn. If you hear a hiss, wait for that to
stop. A hiss means there is still some pressure left.
2. Then keep turning the pressure cap slowly, and
remove it.3. Fill the coolant surge tank with the proper mixture,
to the FULL COLD mark.
5-46

First, use these pictures to decide what kind of wheels
you have.
Then, refer to the following steps for the wheels
you have.Hub-Piloted Wheels, 8-Hole or 10-Hole
The studs and nuts used with these wheels have
right-hand threads.
1. With intermittent pilot pads, position a pad at
12 o’clock to center the wheel and reduce run-out.
2. Put the tire and rim assembly on the axle hub.
Install the outer rear tire and rim assembly so
that its valve stem is exactly opposite the valve stem
on the inner tire and rim assembly.
3. Put on the wheel nuts.
4. Finger-tighten the nuts.
5. Oil the surfaces (B)
between the nuts (C)
and washers (A). Do
not oil the studs or the
threads of the nut. Hub-Piloted Type,
8-Hole
Hub-Piloted Type,
10-Hole
5-81

A
Accessories and Modifications............................ 5-3
Accessory Power Outlets.................................3-19
Adding a Snow Plow or Similar Equipment.........4-22
Adding Equipment to Your Airbag-Equipped
Vehicle.......................................................1-58
Additives, Fuel................................................. 5-7
Add-On Electrical Equipment............................5-95
Air Cleaner/Filter, Engine.................................5-38
Air Conditioning..............................................3-20
Air Pressure Gage..........................................3-47
Air Suspension...............................................2-44
Air Suspension Seats........................................ 1-6
Airbag
Off Light.....................................................3-28
Readiness Light..........................................3-27
Airbag System................................................1-48
Adding Equipment to Your Airbag-Equipped
Vehicle...................................................1-58
Airbag Off Switch........................................1-55
How Does an Airbag Restrain?......................1-53
Servicing Your Airbag-Equipped Vehicle..........1-58
What Makes an Airbag Inflate?......................1-53
What Will You See After an Airbag
Inflates?..................................................1-54
When Should an Airbag Inflate?....................1-52
Where Are the Airbags?...............................1-50Antenna, Fixed Mast.......................................3-58
Antilock Brake System (ABS)............................. 4-5
Antilock Brake, System Warning Light................3-33
Antilock Brakes, Trailer System
Warning Light.............................................3-34
Appearance Care
Aluminum or Chrome-Plated Wheels..............5-92
Care of Safety Belts....................................5-89
Chemical Paint Spotting...............................5-93
Cleaning Exterior Lamps/Lenses....................5-90
Fabric/Carpet..............................................5-88
Finish Care.................................................5-90
Finish Damage............................................5-93
Instrument Panel, Vinyl, and Other
Plastic Surfaces.......................................5-89
Interior Cleaning..........................................5-87
Sheet Metal Damage...................................5-93
Tires..........................................................5-92
Underbody Maintenance...............................5-93
Washing Your Vehicle...................................5-90
Weatherstrips..............................................5-89
Windshield and Wiper Blades........................5-91
Ashtray.........................................................3-19
Audio System.................................................3-48
Chime Level Adjustment...............................3-58
Fixed Mast Antenna.....................................3-58
Radio Reception..........................................3-58
Setting the Clock.........................................3-48
Theft-Deterrent Feature................................3-57
1

Child Restraints (cont.)
Securing a Child Restraint in the Center
Rear Seat Position...................................1-42
Securing a Child Restraint in the Right
Front Seat Position...................................1-44
Where to Put the Restraint...........................1-38
Chime Level Adjustment..................................3-58
Cigarette Lighter.............................................3-19
Cleaning
Aluminum or Chrome-Plated Wheels..............5-92
Exterior Lamps/Lenses.................................5-90
Fabric/Carpet..............................................5-88
Finish Care.................................................5-90
Instrument Panel, Vinyl, and Other
Plastic Surfaces.......................................5-89
Interior.......................................................5-87
Tires..........................................................5-92
Underbody Maintenance...............................5-93
Washing Your Vehicle...................................5-90
Weatherstrips..............................................5-89
Windshield and Wiper Blades........................5-91
Climate Control System...................................3-20
Outlet Adjustment........................................3-22
Rear Heating System...................................3-23
Clock, Setting.................................................3-48
Collision Damage Repair................................... 7-6
Control of a Vehicle.......................................... 4-3Coolant
Engine.......................................................5-47
Engine Temperature Gage............................3-34
Low Warning Light.......................................3-35
Surge Tank Pressure Cap.............................5-47
Cooling System..............................................5-43
Cruise Control................................................3-10
Customer Assistance Information
Customer Assistance for Text Telephone
(TTY) Users.............................................. 7-4
Customer Assistance Offices........................... 7-4
Customer Satisfaction Procedure..................... 7-2
GM Mobility Reimbursement Program............... 7-5
Reporting Safety Defects to General Motors........ 7-9
Reporting Safety Defects to the Canadian
Government.............................................. 7-9
Reporting Safety Defects to the
United States Government.......................... 7-9
Roadside Assistance Program......................... 7-5
Service Publications Ordering Information........7-10
D
Daytime Running Lamp...................................3-15
Daytime Running Lamps Indicator Light.............3-42
Defensive Driving............................................. 4-2
3

Outside
Convex Mirrors............................................2-52
Heated Mirrors............................................2-52
Manual Mirrors............................................2-51
Power Mirrors.............................................2-51
Overspeed Warning Light.................................3-40
P
Paint, Damage...............................................5-93
Park Brake............................................2-38, 2-41
Parking.........................................................2-35
Brake Burnish Procedure..............................2-43
Over Things That Burn.................................2-44
Two-Speed Rear Axle..................................2-36
Part A - Scheduled Maintenance Services............ 6-4
Part B - Owner Checks and Services................6-26
PartC-Recommended Fluids and
Lubricants..................................................6-31
PartD-Maintenance Record...........................6-33
Passing.........................................................4-11
Perchlorate Materials Requirements,
California..................................................... 5-4
Power
Door Locks.................................................. 2-7
Electrical System.........................................5-96
Reduced Engine Light..................................3-42
Steering Fluid.............................................5-49
Windows...................................................... 2-9
Power Take-Off Light.......................................3-43Power Take-Off (PTO).....................................2-30
Privacy..........................................................7-11
Event Data Recorders..................................7-12
Navigation System.......................................7-13
OnStar.......................................................7-13
Radio Frequency Identification.......................7-13
R
Radio Frequency Identification (RFID),
Privacy......................................................7-13
Radio(s)........................................................3-49
Radios
Reception...................................................3-58
Setting the Clock.........................................3-48
Theft-Deterrent............................................3-57
Range Inhibit Warning Indicator........................3-31
Reading Lamps..............................................3-17
Rear Axle......................................................5-67
Differential Lock Control................................. 4-7
Shift Motor.................................................5-68
Rear Heating System......................................3-23
Rear Seat Operation.......................................1-10
Rearview Mirrors.............................................2-51
Reduced Engine Power Light............................3-42
Remote Keyless Entry (RKE) System.................. 2-3
Remote Keyless Entry (RKE) System,
Operation..................................................... 2-4
Replacement Parts, Maintenance.....................5-108
9