oil capacity Citroen BERLINGO MULTISPACE RHD 2016 2.G Owner's Manual

[x] Cancel search | Manufacturer: CITROEN, Model Year: 2016, Model line: BERLINGO MULTISPACE RHD, Model: Citroen BERLINGO MULTISPACE RHD 2016 2.G
Pages: 296, PDF Size: 11.04 MB

Page 160 of 296

Citroen BERLINGO MULTISPACE RHD 2016 2.G Owners Manual 158
Berlingo-2-VP_en_Chap07_Verification_ed02-2015
Levels
Berlingo-2-VP_en_Chap07_Verification_ed02-2015
Cooling system
Only use the fluid recommended by the manufacturer.
Otherwise,
you

158
Berlingo-2-VP_en_Chap07_Verification_ed02-2015
Levels
Berlingo-2-VP_en_Chap07_Verification_ed02-2015
Cooling system
Only use the fluid recommended by the manufacturer.
Otherwise,
you risk seriously damaging
your

engine.
When
the engine is warm, the
temperature

of the coolant is controlled
by

the engine fan.
As
this fan can
operate

with the ignition key removed
and

because the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying

out any work.
Slacken
the cap by 1/4 of a turn to
release the pressure to prevent any
risk

of scalding. When the pressure
has

dropped, remove the cap and top
up

the level with coolant.
If
fluid has to be added frequently,
this

indicates a fault which must be
checked

by a CITROËN dealer as
soon

as possible.
Power steering fluid level
The vehicle must be parked on level ground with the engine cold. Unscrew
the cap integrated with the gauge and
check

the level which must be between
the

MIN and MAX marks. In
order to regenerate the filter, you are advised to drive at a speed higher
than
40 mph (60 km/h) for at least five minutes
as soon as possible, when
traffic

conditions permit (until the
message

disappears and the service
warning

lamp goes off).
d

uring regeneration of the particle
emission
filter, the noise of a relay
operating

may be heard under the
dashboard.
If

the message is still displayed and
if

the service warning lamp remains
on, contact a CITR

o Ë n dealer or a
qualified
workshop.
Topping up
The

level

must

be

between

the

MIN

and

MAX

marks

on

the

expansion

bottle.

If

more

than

1

litre

of

fluid

is

required to top up the level, have the
system

checked

by

a

CITROËN

dealer

or

a

qualified

workshop.
Screenwash and headlamp
wash level
For best quality cleaning and for your
safety, we would advise that you use
products of the CITROËN range.
For
optimum cleaning and to avoid
freezing,

this fluid must not be topped
up

or replaced with plain water.
Capacity
of the screenwash reservoir:
approximately

3 litres.
If
your vehicle is fitted with headlamp
washers, the capacity of the reservoir
is

6 litres.
Diesel additive level
(Diesel with particle
filter)
Topping up
This additive must be topped up by
a

CITROËN dealer or a qualified
workshop

without delay.
Waste products
avoid prolonged contact of used oil
with the skin.
Brake
fluid is harmful to health and
very

corrosive.
Do
not dispose of used oil, brake fluid
or coolant into drains or into the ground
but into the containers dedicated to this
use at a CITR

o Ë n dealer (France) or
an
authorised waste disposal site.
The

minimum

level

of

this

additive

is indicated by lighting of the service
warning

lamp,

accompanied

by

an

audible

signal

and

a

message

in

the

screen.
When this occurs with the engine
running it is due to the start of
saturation

of

the

particle

filter

(exceptionally prolonged urban type
driving

conditions:

low

speed,

long

traffic

jams,

...).