reset Citroen C1 2012 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2012, Model line: C1, Model: Citroen C1 2012 1.GPages: 140, PDF Size: 4.24 MB
Page 21 of 140
1
Monitoring
19
Instrument panel
1.Total or trip distance recorder display button,
trip zero reset button
2. Display of warning lamps 3.
Direction indicators4.
Speedometer
5. Fuel gauge 6
. To t a l / trip distance recorder 7.Front foglamp warning lamp8.
Rear foglamp warning lamp9.Main beam headlamp warning lamp
10. Dipped beam headlamp warning lamp
Rev counter
Approaching the maximum engine speed, when
the rev counter needle crosses into the red
zone, you must change up.
11. Indicator of gear engaged or position of thegear lever for the electronic gearbox.
Page 25 of 140
1
Monitoring
23
Total/trip distance recorder
Indicators
This indicates the quantity of fuel available:
- 1/1and six bars, the fuel tank is full.
- Rand one bar flashing, the fuel tank is on
the reserve.
When the i
gnition is switched on, the distance
recorder selected when the engine was switched off is displayed.
Press button 1to alternate the distance display:
- total with "ODO"displayed,
- trip with "TRIP"
displayed. To reset the trip recorder to zero, when it is
displayed, press and hold button 1.
Low fuel level
When the minimum level in the fuel tank is reached,
the last bar flashes accompanied b
y an audiblesignal.
In cer tain driving conditions and depending on theengine, the distance which can be travelled with the fuel remaining may be less than 30 miles (50 km).You have approximately 5 litres remaining.
When the frequency of the flashing increases, you
have approximately 3 litres remaining .
At least 5 litres must be added after running out of fuel.
Fuel gauge
Page 40 of 140
38Comfort
Front seats
Push control A rear wards while adjusting the
angle of the seat back.
Raise the control and slide the seat forwards or backwards.
Position the seat belt along the door pillar.
Push control A
rearwards to fold the seat back and move the seat forwards.
To put the seat back in place, push the seat
back until the seat locks.
Reset the for wards-backwards adjustment of
the seat and the seat back angle.
No person or object must prevent the seat from returning to the required
position.
1. Forwards-backwardsadjustment
2. Seat back angle adjustment 3. Access to the rear seats (3-door)
Page 96 of 140
01
VOLMENUSRC/
LIST
ESC
SEEK +
_
MP3
94
FIRST STEPS
Select the source:
- FM1, FM2, AM, CD, USB, AUX, Streamin
g.
- accept an
incoming call.
Long press:
- open the calls lo
g for the telephone connected.
- or end a call i
f in progress.
Adjust audio settings: sound ambience, treble, bass, loudness, left/right balance.
On / Off.
Abandon the current
operation.
Go up one level (menu or folder).
E
ject CD.
Select a preset radio station.
Radio: long press: preset a
radio station.
Other than radio: see the corresponding sections.
Automatic search for a lower / hi
gher radio
frequency.
Select previous / next CD, USB track.
Navigation in a list.
Press and hold: fast forwards or backwards.
Open the main menu.
Displa
y the list of stationsreceived, the CD/USB tracksor folders.
Lon
g press: update the list of stations received.
V
olume adjustment.
Page 97 of 140
02
95
RADIO
Press SRC/TEL
repeatedly and select
the FM1, FM2 or AM waveband.
Press a button to listen to the corresponding preset station.
Select the desired radio station and confi rm by pressing "OK".
RADIO
Press LIST
to display the list of stations
received in alphabetical order.
The exterior environment
(hills, buildings, tunnel, car park, below ground...) may prevent reception, even in RDS station tracking (alternative
frequencies) mode. This phenomenon is normal in the propagation of radio waves and is in no way indicative of a fault with the audio system.
A long press on LISTbuilds or updates
the list of stations; audio reception iscut momentarily.
Make a lon
g press on one of the buttons
to preset the station being listened to.
The name o
f the station is displayed andan audible signal confi rms the preset.
A press chan
ges to the next or previous
letter (e.g. A, B, D, F, G, J, K, ...). MANAGE THE LIST
PRESETTING AND SELECTING A STATION
When recalling a preset station, of the reception of the station is poor, the radio will try to fi nd a frequency transmitting the same programme and a message appears in the screen.
Page 115 of 140
113
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWERSOLUTION
There is a difference in sound quality between
the different audiosources (radio, CD...).
For optimum sound quality, the audio settings
(Bass, Treble, Ambience, loudness) can be adapted to the different sound sources, which mayresult in audible differences when changing source (radio, CD...).
Check that the audio settings (Bass, Treble, Ambience, Loudness) are adapted to the sources listened to. It is advisable to adjust audio settings(Bass, Treble, Front-Rear balance, Left-Right balance)
to the middle position, select the musical ambience
and set the loudness correction to the "Active" position
in CD mode or to the "Inactive" position in radio mode.
When chan
ging the settings for treble and
bass, the ambience
setting is deselected.
When changing the
ambience setting, treble and bass are reset to zero.
Choosing an ambience imposes settings for treble and bass. Modifyingone without the other is only possible with a personalised ambience. Modify the treble and bass settings or the
ambience setting to obtain the desired sound quality.
The qualit
y of receptionof the radio station
listened to graduallydeteriorates or the stored stations do not function(no sound, 87.5 MHz is
displayed...). The vehicle is too
far from the transmitter used by the station listened
to or there is no transmitter in the geographical area through which the
vehicle is travellin
g.
Activate the RDS function to enable the system
to check whether there is a more powerful
transmitter in the geographical area.
The environment
(hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode. This phenomenon is normal and does not indicate
a failure of the audio equipment.
The aerial is absent or has been dama
ged (for example when goingthrough a car wash or into an underground car park). Have the aerial checked by a CITROËN dealer.
Sound cut-outs of 1 to
2 seconds in radio mode.During this brief sound cut-out, the RDS searches for any frequency
permitting better reception of the station. Deactivate the RDS function if the phenomenon is
too frequent and always on the same route. The
following tables contain answers to the most frequently asked questions.
Page 123 of 140
02
121
Select the required station.
Pr
ess one of the buttons "1"
to "6"for more than 2 seconds.
An audible signal confi rms that the station has been preset. MANUAL STATION PRESETTING
Press this button.
Your audio equipment automatically presets the six strongest stations received on AMand FM
in your current location. These stations are stored on the
AMand FM3wavebands. The end of the search is signalled by two audible signals.
AUTOMATIC PRESETTING OF FM STATIONS(AUTOSTORE)
RADIO
If it was not possible to fi nd six stations the remaining memories remain empty: three dashes are displayed on the audio system screen for each empty memory.
RECALLING PRESET STATIONS
On each waveband, a brief press on one of the buttons "1"
to "6"
recalls the corresponding preset station.
RADIO RECEPTION
Your audio system will be subjected to phenomena which do not
affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no refl ection on the quality of the system but is due to the nature of the signals and the
way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high
voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from
the transmitter, defl ection of the signal by obstacles (mountains,
hills, buildings, etc) or of being in an area which is not covered by a
transmitter.