stop start Citroen C4 PICASSO 2013 1.G Owner's Guide

139
4
Driving
Electronic key not
recognised
If the electronic key is no longer in the definedzone when driving or when you (later) request
switching off the engine, a message appears in
the instrument panel.
) Press and hold the "STA R T/STOP" button for about3 seconds if you want to forceswitching off the engine (note
that restarting will not be possible without the key ).

y

Emergency switch- off
In the event of an emergency only,
the engine can be switched of withoutconditions. To do this, press and hold
the "STA R T/STOP" button for about3 seconds.

In this case the steering column locks as soon
as the vehicle stops.

140
Driving














Ignition on without
starting


With the ignition on, the system goes into energy economy mode whennecessary to maintain the state of charge of the battery. With the electronic key in the reader or the
Keyless Entry and Starting key inside the
vehicle, pressin
g the "START/STOP" button,
with no action on the pedals
, allows the
ignition to be switched on.
)
Press the "START/STOP" button,the instrument panel comes onbut the engine does not star t.
)Press the button again to switch off the ignition and so allow the vehicle to belocked.












Anti-theft protection


Electronic engine immobiliser

The keys contain an electronic chip which has
a secret code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible.
This electronic engine immobiliser locks the
engine management system a few minutes
after the ignition is switched off and prevents
starting of the engine by anyone who does not
have the key.
In the event of a malfunction, you are informedby a message in the instrument panel screen.
In this case, your vehicle does not start; contact
a CITROËN dealer as soon as possible.

143
4
Driving
With the vehicle stationary, the parking brakeis automatically applied when the engine is switched offby pressing the START/STOP fbutton.

Application o
f of the parking brake
is confirmed by illumination of the
brake indicator lamp and the Pindicator lamp in the control lever, accompanied by the display of the message "Parking brake applied".

With the engine stalled or in STOP mode of Stop & Star t, automatic application does not take place.


In automatic mode, you can manuallyapply or release the parking brake using the control lever.


Automatic operation


Automatic release


The complete release of the parkingbrake is confirmed by the brake
indicator lamp and the P indicator
lamp in the control lever going off,
accompanied by the display of the
message "Parking brake released".
When stationary with the engine running, do notdepress the accelerator pedal unnecessarily,you risk releasing the parking brake.
Ensure first that the engine is running and the
driver's door is properly closed.
The electric parkin
g brake releases automatically and progressivelywhen youpress the accelerator: )Manual gearbox: fully depress the clutchpedal, engage 1 st
or reverse gear; press
the accelerator pedal and let up the clutch pedal. )Automatic gearbox: select position D , Mor Rthen press the accelerator. )Electronic gearbox: select position A, Mor Rthen press the accelerator pedal.



Automatic application

154
Driving








Automatic gearbox
This gearbox offers two driving modes.
- automatedmode for automatic management of the gears by the gearbox,
without any action on the par t of the driver,-manualmode for sequential gear changingby the driver using the steering mountedpaddles.
P
.Park.


- Immobilisation of the vehicle, parking brake
applied or released.

- Starting the engine.R.
Reverse.


- Reversing, vehicle stationary and engine at
i
dle.
N.Neutral.


- Immobilisation of the vehicle, parking brake
applied.

- Startin
g the engine.D.Automatic operation. M.Manual operation with sequential changingof the six gears.


Gear selector lever


To select position P
, move the gear Pselector to the highest position (towards R), then push it for wards and Rthen to the left. Only engage it when the vehicle is at acomplete stop. In this position, the frontwheels are locked. Ensure that the gear selector is correctly positioned.

To move the gear selector, switch onthe ignition or star t the engine.
If the battery is not sufficiently charged, it is not possible to move the gear selector.


To come out of position P
, move the Pgear selector to the right to the desired position, while keeping your foot on thebrake pedal.


It is possible to change from one modeto the other at any time.
With the automated mode, you cantemporarily take control of the gear changes at any time.

160
Driving














Stop & Start
Operation
Going into engine STOP mode
The "ECO"
warning lamp comes onin the instrument panel and the enginegoes into standby automatically:
-with a manual gearbox
, at speeds below
12 mph (20 km/h), when you place the gear lever in neutral, and you release the clutch pedal, - with an electronic gearbox,at speeds
below 5 mph (8 km/h), when you press the
brake pedal or place the gear selector lever in position N ,
- with an automatic gearbox,
with the
vehicle stationary, when you press the brake pedal or place the gear selector lever in position N.If your vehicle is fitted with the system, a timecounter calculates the sum of the periods in STOP mode during a journey. It resets itself to
zero every time the ignition is switched on with
the STA R T/STOP button.
Never refuel with the engine in STOPmode; you must switch off the ignition with the STA R T/STOP button.
For your comfor t, during parkingmanoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear.STOP mode does not affect the functionality of the vehicle, such as for example, braking, power steering...


Special cases: STOP mode not
available
STOP mode is not invoked when:


- the driver's door is open,

- the driver's seat belt is not fastened,

- the vehicle has not exceeded
6 mph(10 km/h) since the last engine start usingthe START/STOP button,

- the electric parking brake is applied or being applied,

- the engine is needed to maintain acomfor table temperature in the passenger compartment,

- demistin
g is active,

- some special conditions (battery charge, engine temperature, braking assistance,ambient temperature...) where the engine isneeded to assure control of a system.

In this case, the "ECO"
warning lampflashes for a few seconds then goesoff.This operation is per fectly normal.
The Stop & Star t system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine restar ts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.

161
4
Driving

Going into engine START mode
The "ECO"warning lamp goes off and the engine starts automatically:
-with a manual gearbox
, when you fullydepress the clutch pedal,
-
with an electronic gearbox
:
●
gear selector lever in position Aor M
,
when you release the brake pedal,
●
or gear selector lever in position Nand the brake pedal released, when you place the gear selector lever inposition A
or M,●
or when you engage reverse gear.
-
with an automatic gearbox:
●
gear selector in position Dor M
, whenyou release the brake pedal,
●
or gear selector in position N
and brakepedal released, when you place the gear selector in position D
or M,●
or when you engage reverse.
START mode is invoked automatically when:
- you open the the driver's door,
- you unfasten the driver's seat belt,
- the speed of the vehicle exceeds 15 mph (25 km/h) with a manual gearbox, 7 mph(11 k m / h) with an electronic gearbox and
2 mph (3 km/h) with an automatic gearbox,
- the electric parking brake is being applied,
- some special conditions (battery charge,engine temperature, braking assistance,
ambient temperature...) where the engine is
needed for control of a system.
Special cases: START invoked automatically

If the system has been deactivatedin STOP mode, the engine restar ts immediately. Deactivation o
f Stop & Star t is done in the
"Driving assistance" menu.
Deactivation
In this case the "ECO"
warning lampflashes for a few seconds, then goes off.
This operation is per fectly normal.
Press this button to deactivate thesystem.
This is con
firmed by the indicator lamp in the button and this symbol.


When driving on a flooded road, it isrecommended that the Stop & Star tfunction be deactivated and that you drive very slowly.

162
Driving

The system is reactivated automaticallyevery time the engine is star ted by the driver.

Reactivation

Press this button again.


Operating fault

Have it checked by a CITROËN dealer or aqualified workshop.
In the event of a fault in STOP mode, the
vehicle may stall.
All of the instrument panel warning lamps come on.
Depending on version, an alert message may
also be displa
yed, asking you to place the gear
selector lever in position Nand put your foot on
the brake pedal.
It is then necessar
y to switch off the ignition
and star t the engine again using the "START/STOP" button.In th
e event of a fault with the system, this warning lamp comes
on continuously.
The system is active again; this is confirmed by the indicator lamp in thebutton going off and illumination of
this symbol.
The Stop & Start system makes use of advanced technology. For any work onthe system go to a qualified workshop with the skills and equipment required, which a CITROËN dealer is able toprovide.

Before doing anything under the bonnet,deactivate the Stop & Start system toavoid any risk of injury resulting fromautomatic operation of STA R T m o d e .


Maintenance

This system requires a 12 V battery with a special specification and technology (reference numbers available from CITROËN dealers).
Fitting a battery not listed by CITROËN introduces the risk of malfunction of
the system.
For charging, use a 12 V charger and do not
reverse the polarity.

194
Driving





Park Assist
This system provides active assistance with parking, detecting a parking space then controlling the steering to park in the space. It controls the steering while the driver manages the accelerator, brakes, gears andclutch (manual gearbox). During phases of entry into and exit from a parking space, the system provides visual and audible information
to the driver in order to make the manoeuvres safe. It may be necessary to move for wards and backwards more than once.
During a manoeuvre the steering wheelturns quickly: do not hold the steeringwheel, do not place your hand between
the spokes of the steering wheel and take care with loose and bulky clothing, scarves, handbags... There is a risk of injury.


When Park Assist is activated, itprevents a change to STOP mode of Stop & Start. In STOP mode, activation of Park Assist restarts the engine.


The Park Assist system cannot in anycircumstances replace the care and responsibility of the driver.
The driver must remain in control of their vehicle ensuring that thespace remains clear throughout themanoeuvre. In some circumstances, the sensors may not detect small obstacles located in their blind spots.
The driver can take control at any time bygripping the steering wheel.
The Park Assist s
ystem provides assistance for
the following manoeuvres:


- entr
y into a parallel parking space

- exitin
g from a parallel parking space

- ba
y parking

The Park Assist system takes control of the power steering for a maximumof 4 manoeuvre cycles. The functionis deactivated after these 4 cycles.If you think that your vehicle is notpositioned correctly, you should then take control of the steering to carry outthe manoeuvre.

The Park Assist system cannot workwith the engine off.

290
Practical information

Type 1 fuse tables
Fusebox 1


Dashboard fuses

The fusebox is located in the lower dashboard (left-hand side).
Access to the fuses
)Refer to the paragraph "Access to the tools".
Fuse N°RatingFunctions
F
85 A Steering mounted controls
F1
820 A Touch screen tablet, audio and navigation system, CD player,USB por ts and auxiliary sockets.
F1
615 A
Front 12V socket.
F1
515 A
Boot 12V socket.
F2
85 A STA R T/STOP button.
F3
015 A Rear wiper.
F27 15 A
Front screenwash pump, rear screenwash pump.
F2
615 A
Horn.
F20 5
A Airbags.
F215 A Instrument panel.
F1
95 A Rain and sunshine sensor.
F12 5
A Keyless starting unit.
F2 5
A Manual headlamp adjustment control.

292
Practical information
Type 2 fuse tables
Fuse N°RatingFunctions
F
33 A START/STOP button.
F6A 15 A Touch screen tablet, audio and navi
gation system, CD player,USB ports and auxiliary sockets.
F8 5
A Alarm.
F
93 A Steering mounted controls.
F1
95 A Instrument panel.
F2
43 A Rain and sunshine sensor.
F25 5
A Airbags.
F33 3
A Memorisation of driving position.
F3
45 A Electric power steering.
F13 10 A
Fr
ont 12V socket.
F1410 A
Boot 12V socket.
F1
63 A Map reading lamps in row 1 cour tesy lamps.
F27 5
A Electronic gearbox gear selector.
F3
020 A Rear wiper.
F3
83 A Manual headlamp adjustment control.