check engine light Citroen C5 2000 (DC/DE) / 1.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine ENGINE
82
CHECKING AND SETTING THE VALVE TIMING
Engines : RHY - RHZ
Setting the valve timing (continued).
- Retighten the screws (21)by hand.
- Turn the pinion(24)(clockwise) to the bottom of the buttonhole.
- Refit the belt on the crankshaft (25).
- Hold the belt, using tool [4].
Reposition the timing belt, keeping the belt tight at «a»,
in the following order :
- Guide roller (23).
- Fuel high pressure pump pinion (26).
- Camshaft pinion (24).
- Water pump pinion (18).
- Tensioner roller (20).
NOTE :If needed, slightly turn the pinion(24)anti-clockwise (not by
more than one tooth).
- Remove the tool [4].
B1EP154CB1EP155DB1EP153D

Downloaded from www.Manualslib.com manuals search engine ENGINE
88
CHECKING AND SETTING THE VALVE TIMING
Engine : 4HX
Setting the valve timing (continued).
Refit
- Retighten the screws (25) by hand.
- Turn the pinion (29)(clockwise)to the bottom of the buttonhole.
- Refit the belt on the crankshaft (28).
- Hold the belt, using tool[4].
- Reposition the timing belt, keeping the belt tight at «a», in the following order :
- Guide roller (27).
- Fuel high pressure pump pinion (30).
- Camshaft pinion (29).
- Water pump pinion (22).
- Tensioner roller (24).
NOTE : If needed, slightly turn the pinion (29)anti-clockwise(not by more
than one tooth).
- Remove the tool [4].
B1EP15CCB1EP15DDB1EP15BD

Downloaded from www.Manualslib.com manuals search engine 212
AXLES
SUSPENSION
STEERING
L1
The dimension«L1» for checking front height is between the level of
the front subframe «b» and the wheel axis «a».
This method eliminates all the variations in measurement due to :
Different wheel fiittings.
Vehicle loading.
Wear or incorrect inflation of tyres.
(Measuring from the wheel axis : tool 8006-T)
AXLE GEOMETRY
General adjustment conditions
Rear height Front height
NOTE : After each movement of the vehicle body, and before each mea-
surement :
- Move the vehicle slightly forwards and backwards, by turning the road
wheel by hand.- Check the tyre pressures.
- Release the handbrake.
- Place the manual height control in the «NORMAL» position.
- Engine running.
L2
The dimension«L2»for checking rear height is between the measuring
zone «b» and the wheel axis «a».
H1 = R1 - L1
H1 = Front height(± 6 mm).
R1 =Wheel radius(mm).
L1 = Theoretical dimension between the level of the front subframe and
the wheel axis.H2 = R2 + L2
H2 = Rear height (± 6 mm).
R2 = Wheel radius(mm).
L2 = Theoretical dimension between the measuring zone on the cross-
member support and the wheel axis.