engine oil Citroen C5 RHD 2012 (RD/TD) / 2.G Owner's Manual

15
FAMILIARISATION
MONITORING


Instrument panel

The hazard warning lamps
can also be used with the
ignition switched off.

A.
Fuel gauge and low fuel warning lamp.

B.
Cruise control/speed limiter information.

C.
Coolant temperature.

D.
Speedometer.

E.
Instrument panel screen.

F.
Mileage recorder.
G.
Trip mileage recorder reset button.

H.
Rev counter.

I.
Engine oil temperature.

J.
Automatic gearbox information.



- When the ignition is switched on, the orange and
red warning lamps come on.

- When the engine is running, these warning lamps
should go off .

- If any warning lamps remain on, refer to the
"Monitoring" section.



Hazard warning lamps




26




116

25

Limit the causes of excess
consumption

Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.

At the end of winter, remove snow
tyres and refi t your summer tyres.



Observe the recommendations
on maintenance

Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.

Have your vehicle serviced regularly
(engine oil, oil fi lter, air fi lter...) and
observe the schedule of operations
recommended by the manufacturer.


When refuelling, do not continue after
the 3 rd cut-off of the nozzle to avoid
any overfl ow.

At the wheel of your new vehicle,
it is only after the fi rst 1 800 miles
(3 000 kilometres) that you will see
the fuel consumption settle down to a
consistent average.

I
26
MONITORING














INSTRUMENT PANELS - PETROL AND DIESEL - MANUAL AND AUTOMATIC GEARBOX

Panel grouping together the dials and vehicle operation indicator and warning lamps.


A.
Fuel gauge

B.
Indicator:


●
Coolant temperature

●
Cruise control/Speed limiter
information

C.
Speedometer

D.
Rev counter
E.
Indicator:


●
Engine oil temperature

●
Gear lever position and gear
engaged (Automatic gearbox)

F.
Controls:


●
Lighting dimmer

●
Resetting to zero of trip mile-
age computer and mainte-
nance indicator
G.
Instrument panel screen indicating:


●
Depending on the page
selected with the left-hand
thumb wheel on the steering
wheel:


- Digital speed repeater

- Trip computer

- Navigation (guidance) infor-
mation

- Display of message alerts

- Engine oil level check

- Service indicator

●
Permanently:


- Trip mileage recorder

- Total mileage recorder

I
40
MONITORING













Service indicator zero reset
After each service, the service indi-
cator must be reset to zero.
The procedure for resetting to zero
is as follows:


)
switch off the ignition,

)
press and hold the trip distance
recorder zero reset button,

)
switch on the ignition; the dis-
tance recorder display begins a
countdown,

)
when the display indicates "=0"
,
release the button; the spanner
disappears.
Following this operation, if you wish
to disconnect the battery, lock the
vehicle and wait at least fi ve minutes
for the zero reset to be taken into
account.
















Engine oil level indicator

System which informs the driver
whether the engine oil level is correct
or not.
This information is indicated for a
few seconds when the ignition is
switched on, after the service infor-
mation.
The level read will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 15 minutes.

Oil level correct

Oil level incorrect
This is indicated by displaying of the
message "Oil level incorrect".
If the low oil level is confi rmed by a
check using the dipstick, it is essen-
tial that the level is topped up to pre-
vent damage to the engine.
Oil level gauge fault
This is indicated by displaying of the
message "Oil level measurement in-
valid". Contact a CITROËN dealer
or a qualifi ed workshop.

I
41
MONITORING















Engine oil temperature gauge

Under normal operating conditions,
the bars should be within section 1
.
In severe operating conditions, the
bars may extend into section 2
.

In this event, slow down, and if neces-
sary, stop the engine and check the
levels (see corresponding section).


Coolant temperature gauge

Under normal operating conditions,
the bars should be within section 1
.

In severe operating conditions, the
bars may extend into section 2
, the
engine coolant temperature warning
lamp A
and the STOP
warning lamp
come on, stop as soon as it is safe
to do so
. Switch off the ignition. The
cooling fan may continue to oper-
ate for a certain time
.

Contact a CITROËN dealer or a
qualifi ed workshop.

If the SERVICE
warning lamp comes on, check the levels (see corre-
sponding chapter). On horizontal ground, illumination of
the fuel low warning lamp indicates
that you are at the reserve level.
An alert message is displayed in the
instrument panel.







Fuel gauge

IV
87
ACCESS










Quality of the fuel used for
petrol engines

The petrol engines are perfectly
compatible with E10 type petrol
biofuels (containing 10 % ethanol),
conforming to European standards
EN 228 and EN 15376.
E85 type fuels (containing up to 85 %
ethanol) are reserved exclusively for
vehicles marketed for the use of this
type of fuel (BioFlex vehicles). The
quality of the ethanol must comply
with European standard EN 15293.
For Brazil only, special vehicles are
marketed to run on fuels containing
up to 100 % ethanol (E100 type).














Quality of the fuel used for
Diesel engines

The Diesel engines are perfectly
compatible with biofuels which con-
form to current and future European
standards (Diesel fuel which com-
plies with standard EN 590 mixed
with a biofuel which complies with
standard EN 14214) available at the
pumps (containing up to 7 % Fatty
Acid Methyl Ester).
The B30 biofuel can be used in cer-
tain Diesel engines; however, this
use is subject to strict application
of the special servicing conditions.
Contact a CITROËN dealer or a
qualifi ed workshop.
The use of any other type of (bio)fuel
(vegetable or animal oils, pure or
diluted, domestic fuel...) is strictly
prohibited (risk of damage to the en-
gine and fuel system).


















MISFUEL PREVENTION
(DIESEL) *

Mechanical device which prevents
fi lling the tank of a Diesel vehicle
with petrol. It avoids the risk of en-
gine damage that can result from fi ll-
ing with the wrong fuel.
Located in the fi ller neck, the misfuel
prevention device appears when the
fi ller cap is removed.


Operation

When a petrol fi ller nozzle is intro-
duced into the fuel fi ller neck of your
Diesel vehicle, it comes into contact
with the fl ap. The system remains
closed and prevents fi lling.

Do not persist but introduce a
Diesel type fi ller nozzle.


It remains possible to use a fuel
can to fi ll the tank; this must be
done slowly.
In order to ensure a good fl ow of
fuel, do not place the nozzle of the
fuel can in direct contact with the fl ap of the misfuel prevention device.

*
According to country of sale.

X
165
CHECKS








BLEEDING THE DIESEL FUEL
FILTER

Protective cover


Removing the cover


Bleeding water from the fuel
filter
Bleed regularly (at each oil change).
To bleed the water, slacken the bleed
screw or the water in diesel fuel sen-
sor, located at the base of the fi lter.
Continue until all the water has
fl owed out.
Then tighten the bleed screw or the
water detection sensor.

HDi 110, HDi 160 and V6 HDi 240
engines



)
Pull the protective cover upwards
to remove it.

HDi 140 engine



)
Remove the protective cover by
fi rst unclipping at 3
, then 1
and 4.

)
Unclip at 2
by pulling towards
you, then lift up.
Refi tting


)
Firstly clip in at 2
.

)
Lower and centre the cover.

)
Clip in at 3
and 4
, pushing verti-
cally and gently from the rear.

)
Clip in at 1
pushing vertically.


165

XX














PETROL ENGINES

The various caps and covers allow
access for checking fl uid levels and
for replacing certain components.


1.
Screenwash and headlamp wash
reservoir.

2.
Power steering fl uid reservoir or
power steering and suspension
fl uid reservoir.

3.
Engine coolant header tank.

4.
Engine oil dipstick.

5.
Engine oil fi ller cap.

6.
Brake fl uid reservoir.

7.
Battery.

8.
Air fi lter.
1.6i THP


1.6i VTi

167
CHECKS

X
!
168
CHECKS
Vehicles fi tted with the 2.0i 16v

engine may be fi tted with metal
spring suspension. In this case,
a different power steering fl uid reser-
voir is fi tted.
2.0i 16V


1.
Screenwash and headlamp wash
reservoir.

2.
Power steering fl uid reservoir or
power steering and suspension
fl uid reservoir.

3.
Engine coolant header tank.

4.
Engine oil dipstick.

5.
Engine oil fi ller cap.

6.
Brake fl uid reservoir.

7.
Battery.

8.
Air fi lter.

X
!
169
CHECKS














DIESEL ENGINES

The various caps and covers allow
access for checking fl uid levels, for
replacing certain components and
for priming the fuel system.


1.
Screenwash and headlamp wash
reservoir.

2.
Power steering fl uid reservoir or
power steering and suspension
fl uid reservoir, depending on
equipment.

3.
Engine coolant header tank.

4.
Engine oil dipstick.

5.
Engine oil fi ller cap.

6.
Air fi lter.

7.
Brake fl uid reservoir.

8.
Battery.
As the Diesel fuel system
operates under high pressure,
any work on the fuel system is
prohibited.
Vehicles fi tted with the HDi 140

engine may be fi tted with metal
spring suspension. In this case, a
different power steering fl uid reser-
voir is fi tted.
HDi 110
/ e-HDi 110


HDi 140