Hill Citroen JUMPER RHD 2015.5 2.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2015.5, Model line: JUMPER RHD, Model: Citroen JUMPER RHD 2015.5 2.GPages: 276, PDF Size: 8.88 MB
Page 4 of 276
2
contents
3. EASE OF u SE and c
OMFO rt 44-86
Lighting control stalk 45
Wipers 48
Cruise control
49
Speed limiter
55
Demisting and
defrosting
59
Heating / Manual air conditioning
61
Digital air conditioning
63
Additional heating
systems
65
Rear Heating /
Air Conditioning
65
Programmable
additional heating
67
Front seats
71
Front bench seat
73
Rear seats
74
Front fittings
76
Rear fittings
81
Exterior fittings
84
Mirrors
85
Electric windows
86
Presentation
4
Exterior
6
Interior
7
Instruments and controls
9
T
echnical data - Maintenance
10
Environment
11
Eco-driving
12
1. OVErVIEW 4-15 4. t E c H n OLOGY on
BOA rd 87-97
Vehicle configuration 87
T rip computer 92
T
achograph
93
Rear parking sensors
94
Reversing camera
95
Pneumatic suspension
96
2. rEAdY tO GO 14-43
Remote control 14
Key 16
Alarm
19
Front / rear doors
20
Load space
22
Instrument panel
23
W
arning/indicator lamps
24
Fuel gauge
32
T
emperature indicator
32
Tyre under-inflation detection
33
Service indicator
35
Gearbox and steering
wheel
36
Gear shift indicator
36
Starting and
switching off
38
Hill start assist
39
Stop & Start
40
Driving
recommendations
43
This symbol informs you
of equipment which is
specific to the Combi /
Minibus model. Child lock.Rear heating / air
conditioning / Rear
seats / bench seats.
Reading lamps. Sliding
side windows.
Page 6 of 276
4
cEntrE cOnSOLE
1. Audio / Navigation system.
2. Heating / Air conditioning.
3.
Storage / portable ashtray
.
4.
12 volt accessory socket (180 W max).
5.
USB port / Cigarette lighter
.6.
Dynamic stability control (DCS/ASR) /
Intelligent traction control.
7.
Hill descent control.
8.
Lane departure warning system.
9.
Hazard warning lamps.10.
Central locking / Locking indicator
lamp.
11 .
Demisting / Defrosting.
12.
Gear lever
.
Presentation
Page 10 of 276
8
Lane departure warning system 105
Hill descent control
104
Intelligent T
raction Control
103
ASR, DSC
101-102
V
ehicle configuration
90-91
Setting the time
91
Reversing camera
95
T
ouch screen audio
system
1
83-230
Audio system
231-247
T
achograph
93
Cab fittings
76-80
●
cigarette lighter
,
●
glove box - cooled,
●
overhead storage,
●
portable ashtray
,
●
courtesy lamps,
●
12 volt socket / USB port,
●
writing table / multifunction
support,
●
storage compartments.
Demisting-defrosting
59
Central locking
22
Locking indicator lamp
22
Hazard warning lamps
98 V
entilation,
heating, A/C
60-62, 63-64
●
manual air conditioning,
●
mono-zone digital air
conditioning,
●
air recirculation.
Opening the bonnet
127
Dashboard fuses
145-146
InStruMEntS And cOntrOLS
Location
Page 11 of 276
9
Gearbox 36-37
Parking sensors 94-95
Instrument panels, screens,
speedometer
23
W
arning lamps,
indicator lamps
24-31
Gauges, indicators
32, 35
Gear shift indicator
36-37
Lighting controls
45-47
Automatic illumination of headlamps
46
Guide-me-home lighting
46
Parking lamps
47
V
ehicle configuration
87-89
Setting the time
88
Headlamp beam height adjustment
47
Front/rear fog lamps
45
Pneumatic suspension
96-97
Stop & Start
40-42
Front/rear wipers
48
Screenwash/headlamp wash
48
T
rip computer
92
Starter
, ignition switch
38
Hill start
39
Cruise control
49-51, 52-54
Speed limiter
55-57
Fixed speed limiter
58 Instruments and controls
4-5
Steering wheel, reach adjustment
37
Horn
99
Steering mounted radio controls
186, 233
Mirrors, electric windows
85-86
Locking the load space
22 Additional heating, rear air
conditioning
65-66
Programmable additional heating
67-70
1
OVERVIEW
Location
Page 29 of 276
27
Warning/indicator lampisindicates Solution - action
DSC/ASR flashing.
that it is in operation. The system optimises traction and allows improved
directional stability of the vehicle.
on,
accompanied
by an audible
signal and a
message in the
screen. a fault with the system or the
hill start assist.
Contact a CITROËN dealer or a qualified workshop.
"Safety - Driving safely" section.
on. a fault with the Intelligent
Traction Control.
Particle filter on. the regeneration of the particle
filter. It is recommended that you leave the engine running
until the warning lamp goes off so that regeneration can
be completed.
"Checks - Levels and checks" section.
Emission control
system on.
a fault with the system. Have the system checked by a CITROËN dealer or a
qualified workshop without delay.
Tyre under-
inflation
detection on.
a tyre deflated or punctured. Park and switch off the ignition. Change or repair the
wheel.
on,
accompanied
by the service
warning lamp. a faulty sensor.
Have it checked by a CITROËN dealer or a qualified
workshop.
2
rEAdY tO GO
Instruments and controls
Page 41 of 276
39
HILL StA rt ASSIS t
This system (also called HHC - Hill Holder
Control), linked to the dynamic stability
control system, makes hill starts easier and
is activated in the following conditions:
-
the vehicle must be stationary
, engine
running, foot on the brake,
-
the gradient of the road must be steeper
than 5%,
-
uphill, the gearbox must be in neutral or
in a gear other than reverse,
-
downhill, reverse gear must be engaged.
The Hill Start
Assist system is a driving
aid. It is not an automatic vehicle parking
function or an automatic parking brake.Operation
With the brake pedal and clutch pedal
pressed, from the time you release the brake
pedal, without using the parking brake, you
have approximately 2 seconds to move off
before the vehicle starts to roll back.
During the moving off phase, the function
is deactivated automatically, gradually
releasing the braking pressure. During
this phase, the characteristic noise of
mechanical release of the brakes may be
heard, indicating the imminent movement of
the vehicle.
Operating fault
If a malfunction of the system
occurs, this warning lamp comes
on accompanied by an audible
signal and confirmed by a message
in the screen. Have the system checked by at
a CITROËN dealer or a qualified workshop. Hill start assist is deactivated in the following
situations:
-
when the clutch pedal is released,
-
when the parking brake is applied,
-
when the engine is switched of
f,
-
when the engine stalls.
2
rEAdY tO GO
Starting and switching off
Page 59 of 276
57
Exceeding the programmed
speed
Pressing the accelerator pedal in order to
exceed the programmed speed will have
no effect unless you press the pedal firmly
beyond the point of resistance.
If the limiter is unable to prevent an increase
in the speed of the vehicle because of the
profile of the road or when going down a
step hill, the programmed speed may be
exceeded.
The limiter is deactivated temporarily and
the programmed speed flashes.
To return to the limiter function, reduce your
speed to below the programmed speed.
Switching the system off
- Place the ring in the central O position
or switch off the ignition to switch the
system off.
The last programmed speed remains in the
memory.
Operating fault
The programmed speed is cleared then
replaced by dashes.
Contact a CITROËN dealer or a qualified
workshop to have the system checked.
Good practice
In any event, the speed limiter cannot
replace the need to observe speed limits,
nor can it replace the need for vigilance on
the part of the driver.
Always pay attention to the profile of the
road and sharp acceleration and stay in
complete control of your vehicle.
To avoid any jamming under the pedals:
-
ensure that the mat and its fixings on the
floor are positioned correctly,
-
never place one mat on top of another
.
3
EASE OF uSE and cOMFOrt
Steering mounted controls
Page 106 of 276
104
Hill descent control
System that provides assistance when
descending on surfaces with poor grip (mud,
gravel...) or on a steep gradient.
This system reduces the risk of slip or loss
of control of the vehicle while descending a
hill.
It keeps the vehicle at a steady speed during
a descent by acting independently and with
varying force on each of the brakes.Switching off
Press this button, located in the middle of the
dashboard, to deactivate the system; the indicator
lamp in the button goes off.
Above 30 mph (50 km/h), the system is completely
deactivated; the indicator lamp in the button goes off.
Operating fault
If a fault occurs with the hill
descent control system, this
warning lamp comes on.
Have the system checked by a CITROËN
dealer or a qualified workshop.
Switching on
On starting the vehicle, the system is
deactivated.
With the speed below 18 mph (30 km/h)
press this button, located in the middle of
the dashboard, to activate the system; the
indicator lamp in the button comes on.
Once the vehicle starts its descent, you can
release the accelerator and brake pedals;
the indicator lamp in the button flashes.
The brake lamps come on automatically
when the system is brought into operation.
If the speed of the vehicle exceeds 18
mph
(30 km/h), the system is automatically
deactivated, but the indicator lamp in the
button stays on.
The system reactivates automatically as
soon as the speed of the vehicle drops
below 18 mph (30 km/h).
For the system to operate, the slope
must be steeper than 8%.
Do not use the system with the gearbox in
neutral.
Engage an appropriate gear for the speed of
the vehicle, to avoid the engine stalling.
You can press the accelerator or brake
pedal at any time. The system may not be available if the
brakes overheat. Wait a few minutes
for them to cool down before trying again.
Driving safely
Page 236 of 276
234
Briefly press one of the buttons to
carry out an automatic search down/
up for radio stations. Press the "
rAd
IO
" button to select
the FM or AM waveband.
Turn the dial to carry out a manual
search down/up for radio stations.
Press the dial to display the list of
stations received locally.
Turn the dial to choose a radio station
then press to select it. Press the "
rAd
IO
" button to select
the FM or AM waveband.
Press the ME
nu b
utton.
Press the "
A-B-
c" b
utton to select
one of the three sets of preset
stations.
Select "re gional" then press to
switch RDS on or off.
Make a long press one of the buttons
to preset the current radio station.
The name of the station is displayed
and an audible signal confirms the
preset.
Press "
InFO" t o display information
on the current radio station.
Presetting a station
Selecting a station
The surroundings (hills, buildings,
tunnel, parking, under ground...) may
prevent reception, including RDS
alternative frequencies.
This phenomenon is normal in the
propagation of radio waves and does
not in any way imply a fault with the
audio system.RDS, if displayed, makes it possible
to continue listening to the same radio
station using the alternative frequencies
function. However, in certain conditions
it may not be possible to stay with the
same station as not all radio stations
cover the entire country. When reception
is poor the system switches to a regional
frequency.
Radio
rdS
Audio System