lock DODGE SPRINTER 2008 2.G User Guide

76 SafetyDriving safety systems
2
EBV monitors and regulates the brake
pressure at the rear wheels to improve
driving stability during braking.There is a malfunction if the
#
, k
,
-
and
6
indicator lamps are per-
manently lit while the engine is running
(
\2
page 462).
Electronic brake force distribution
(EBV)
Warning
G
If EBV malfunctions, the brake system is
still available with the full brake boosting
effect. However, the rear wheels may
lock, for example if the brakes are applied
with maximum force. You could then lose
control of the vehicle and cause an acci-
dent. Always adapt your driving style to
the change in handling characteristics.
Have the system checked at an autho-
rized Sprinter Dealer as soon as possible.
nf_BA.book Page 76 Friday, January 25, 2008 3:53 PM

77 Safety
Anti-theft systems
2
\3 Anti-theft systemsThe immobilizer prevents the vehicle
from being started without the correct
key.\1To switch on:
remove the key from
the ignition lock (
\2
page 111).
\1To switch off:
switch on the ignition
(
\2
page 111).A visual and audible alarm is triggered if
the alarm system is enabled and:
\4
a door is opened
\4
the hood is opened
Enabling the alarm system
\1
Close all the doors.
\1
Lock the vehicle using the
‹
but-
ton on the key (
\2
page 83).
The indicator lamp in the central
locking switch (
\2
page 104) flashes.
Deactivating the anti-theft alarm
system
\1
Unlock the vehicle using the
Œ

button on the key (
\2
page 83).
The indicator lamp
in the central
locking switch (
\2
page 104) goes
out.
Immobilizer
Anti-theft alarm system (ATA)*
iThe vehicle locks again automatical-
ly if you do not open a door within 40
seconds after unlocking the vehicle.
nf_BA.book Page 77 Friday, January 25, 2008 3:53 PM

78 SafetyAnti-theft systems
2
Switching off the alarm
\1
Insert the key into the ignition lock.
or
\1
Press the
Œ
button (
\2
page 83).
The alarm is switched off.A visual and audible alarm is triggered if
the inclination of the vehicle changes
while tow-away protection is enabled.
Enabling tow-away protectionTow-away protection is automatically
enabled approximately 20 seconds after
you lock the vehicle.Tow-away protection is automatically
deactivated when you unlock the vehi-
cle.
Deactivating the tow-away protec-
tion for transportationDeactivate tow-away protection if the
vehicle is transported or loaded onto an-
other vehicle. This will prevent false
alarms.
The button is located in the overhead
control panel.
iThe alarm system will be triggered if
the vehicle has been locked with the
key and is then unlocked from the in-
side.
Tow-away protection*iThe tow-away protection alarm is
triggered shortly before the wheel
leaves the ground if the vehicle is be-
ing jakked up on one side, for exam-
ple.
nf_BA.book Page 78 Friday, January 25, 2008 3:53 PM

79 Safety
Anti-theft systems
2
1To deactivate tow-away protection
2Indicator lamp
\1
Turn the key to position
0 or
1
(
\2
page 111) in the ignition lock or
remove the key.
\1
Press button
1
.
Indicator lamp2
lights up for ap-
proximately 5 seconds after the but-
ton is released.
\1
Lock the vehicle using the key.
Tow-away protection remains deactivat-
ed until you lock the vehicle again.If the anti-theft alarm system is enabled
and the vehicle is locked, a visual and
audible alarm is triggered if one of the
side windows or the rear window on your
vehicle is smashed and someone reach-
es into the interior, for example.
Enabling the interior motion sensor
\1
Close:\4
the side windows
\4
the sliding sunroof
This will prevent false alarms.
\1
Lock your vehicle.
iWhen the ignition is switched off
(\2
page 111), you cannot deactivate
tow-away protection.
Interior motion sensor*
nf_BA.book Page 79 Friday, January 25, 2008 3:53 PM

80 SafetyAnti-theft systems
2
The interior motion sensor is enabled
after approximately 40 seconds.
Deactivating the interior motion
sensorDeactivate the interior motion sensor if
people or animals remain in the locked
vehicle. This will prevent false alarms.
The button is located in the overhead
control panel.
1To deactivate the interior motion sensor
2Indicator lamp
\1
Turn the key to position
0 or
1
(
\2
page 111) in the ignition lock or
remove the key.
\1
Press button
1
.
Indicator lamp2
lights up for ap-
proximately 5 seconds after the but-
ton is released.
iDo not leave anything (for example
mascots or coat hangers) hanging on
the rear-view mirror or on the grab
handles on the roof trim. This will pre-
vent false alarms.
iThe interior motion sensor remains
deactivated until you lock the vehicle
again.
nf_BA.book Page 80 Friday, January 25, 2008 3:53 PM

83 Controls in detail
Opening and closing
3
\3 Opening and closingYour vehicle is supplied with either 2 or
4* remote keyless entry transmitters or
4 keys* without remote control.
Vehicle keys* which were not included
with delivery must be activated before
they can be used. You can obtain further
information at any authorized Sprinter
Dealer.
When leaving the vehicle, always take
the key* or remote keyless entry trans-
mitter with you and lock the vehicle. The
engine could be started by anyone with
a valid key* or remote keyless entry
transmitter that is left inside the vehicle.You will find information about opening
and closing your vehicle with the key in
the “Locking and unlocking the vehicle
with the key” section (
\2
page 88).
I n c l u d e d w i t h y o u r v e h i c l e a r e 2 o r 4 * r e -
mote keyless entry transmitters with a
folding mechanical key.
Remote control with key
iUSA only:
This device complies with Part 15 of
the FCC rules. Operation is subject
to the following two conditions:
(1) This device may not cause harm-
ful interference, and
(2) this device must accept any in-
terference received, including inter-
ference that may cause undesired
operation.
Any unauthorized modification to
this device could void the user’s au-
thority to operate the equipment.
nf_BA.book Page 83 Friday, January 25, 2008 3:53 PM

84 Controls in detailOpening and closing
3
Remote controls with keys which were
not included with delivery must be acti-
vated at an authorized Sprinter Dealer
before they can be used.
The remote keyless entry transmitter
transmits in all directions. It does not
have to be pointed at the vehicle.
The remote keyless entry transmitter
has an average range of about 32 ft
(about 10 m). Always verify the correct
operation of the remote keyless entry transmitter by checking whether the
locking knobs on the driver's and pas-
senger's doors move down and whether
the turn signals flash.
The remote control unlocks the driver's
door and/or all doors centrally. If pro-
grammed as a factory setting, it locks
the following centrally:
\4
the driver’s and passenger’s door
\4
the sliding doors
\4
the rear doorsThe remote keyless entry transmitter
will not function when there is a vehicle
key inserted in the ignition lock.
iCanada only:
This device complies with RSS-210
of Industry Canada.
iIf the driver’s or passenger’s door is
not completely closed, the respective
door is not locked.
If one sliding door or rear door is not
completely closed, all doors of the
load compartment are not locked.
nf_BA.book Page 84 Friday, January 25, 2008 3:53 PM

85 Controls in detail
Opening and closing
3
Remote control with key
1 To unlock the sliding doors and
rear doors and opens or closes the elec-
tric sliding door*
2ΠUnlocking button
3‹ Locking button
4Release button for mechanical key
5Battery check lamp.
Warning
G
Do not leave children unsupervised in the
vehicle, even if they are secured by a child
restraint system.The children could:injure themselves on parts of the vehicleunlock the door on vehicles with an elec-
tric sliding door by pressing the central
locking button, and then open the doors
and thereby injure other persons
Continued
Warning (Continued)
G
get out of the vehicle and could either in-
jure themselves when doing so or they
could be injured by passing vehiclesbe severely or even fatally injured by pro-
longed exposure to intense heat
!Do not expose the key to high levels
of electromagnetic radiation, other-
wise this may interfere with the func-
tions of the key.
Protect the key from moisture to pre-
vent malfunctions.
nf_BA.book Page 85 Friday, January 25, 2008 3:53 PM

86 Controls in detailOpening and closing
3
As a precaution, both remote controls
should always be carried.Checking the batteries
\1
Press the
Œ
or
‹
button for
longer than 2 seconds.The battery check lamp
5
comes on
briefly to indicate that the remote
control batteries are in order.
Change the batteries immediately if
the lamp
does not
light up briefly
during check (
\2
page 540).
Locking and unlocking the vehicle
with the remote control
Unlocking the driver's door
\1
Press the
Œ
button.
The turn signals flash once.
The anti-theft alarm system (ATA)* is
deactivated.
iTo prevent theft, only use the remote
control in the immediate vicinity of
the vehicle.
In an emergency, the driver’s door
and rear door can also be unlocked
manually using the key.
iIf the batteries are checked within
signal range of the vehicle, pressing
the
Œ
or
‹
but ton wil l lock or
unlock the vehicle accordingly.
iIf you unlock the vehicle using the
key and do not open a door within 40
seconds, the vehicle locks again au-
tomatically.
nf_BA.book Page 86 Friday, January 25, 2008 3:53 PM

87 Controls in detail
Opening and closing
3
Unlocking the vehicle centrally
\1
Unlock the driver's door.
\1
Press the
Œ
button within 2 sec-
onds again.
The turn signals flash once.
Locking the vehicle centrally
\1
Press the
‹
button.
The turn signals flash three times if:
\4
the drive authorization system or
the anti-theft alarm system
(ATA)* is activated
\4
all the doors are closed
Unlocking the sliding doors and the
rear door*When the vehicle is locked, the
button can only be used to unlock the
sliding doors and the rear door.\1
Press the button.
The turn signals flash once.
Opening the electric sliding doors
\1
Press and hold the button.
The turn signals flash once.
iMake sure that the locking knobs
have dropped down.
nf_BA.book Page 87 Friday, January 25, 2008 3:53 PM