rpm FIAT PUNTO EVO 2010 1.G Owners Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2010, Model line: PUNTO EVO, Model: FIAT PUNTO EVO 2010 1.GPages: 270, PDF Size: 8.34 MB
Page 171 of 270
170
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
DPF (PARTICULATE FILTER)
CLEANING IN PROGRESS
(only Multijet with DPF – amber)
When the ignition key is moved to MAR position,
the warnintg light turns on but should go off after a few
seconds. The warning light stays on constantly to notify
the driver that the DPF system needs to eliminate cap-
tured pollutants (particulate) by the regeneration process.
The warning light does not come on during every DPF
regeneration, but only when driving conditions require no-
tification to the driver. The warning light will go off if the
vehicle stays in motion until regeneration has been com-
pleted. The process normally takes about 15 minutes. Op-
timal conditions for completing the process are achieved
by travelling at 60 km/h with engine revs above 2000 rpm.
If this light comes on, it does not mean the car is defec-
tive, so there is no need to take it to a garage. A specific
message will appear on the display when the warning light
comes on (for versions/markets, where provided).
h
Always drive at a speed appropriate to the
traffic conditions, the weather and speed
limits. The engine may be turned off while the
DPF light is on; however, repeated interruption of
the regeneration process may result in premature
degradation of engine oil. For this reason it is al-
ways advisable to wait for the light to go off be-
fore turning off the engine, following the instruc-
tions appearing above. It is not a good idea to
complete DPF regeneration with the vehicle sta-
tionary.
WARNINGSpeed limit exceeded
(for versions/markets where provided)
The display shows the associated message when the car
exceeds the set speed limit (see “Multifunction display”
in the “Dashboard and controls” section).
161-174 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 170
Page 239 of 270
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
238
ENGINE
GENERAL INFORMATION
Type code
Cycle
Number and layout of cylinders
Piston bore
and stroke mm
Total capacity cm3
Compression ratio
Max.
power (EEC) kW
HP
corresponding speed rpm
Max.
torque (EEC) Nm
kgm
corresponding speed rpm
Spark plugs
Fuel
(*) For versions/markets where provided
1.2
199A4000
Otto
4 in line
70.8 x 78.86
1242
11.1 : 1
48
65
5500
102
10.4
3000
NGK
ZKR7A-10
1.4
350A1000
199A7000 (*)
Otto
4 in line
72 x 84
1368
11.1 : 1
57/55 (*)
77/75 (*)
6000
115
11.7
3250
NGK
ZKR7A-10
1.4 Multi Air
955A6000
Otto
4 in line
72 x 84
1368
10.8 : 1
77
105
6500
130
13.2
4000
NGK
DCPR7E-N10
1.4 Turbo
Multi Air
955A2000
Otto
4 in line
72 x 84
1368
9.8 : 1
99
135
5000
206
21
1750
NGK
IKR9F8
Unleaded petrol 95 RON (EN228 Specification)
235-258 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 238
Page 240 of 270
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
239
1.3 Multijet
90HP
199A3000
223A9000 (*) (Õ)
Diesel
4 in line
69.6 x 82
1248
17.6 : 1
66/62 (*)
90/85 (*)
4000
200
20.4
1750
1.3 Multijet
95HP
199B1000
Diesel
4 in line
69.6 x 82
1248
16.8 : 1
70
95
4000
200
20.4
1500
1.6 Multijet
120HP
955A3000
Diesel
4 in line
79.5 x 80.5
1598
16.5 : 1
88
120
3750
320
32.6
1750
Diesel for motor vehicles (EN590 Specification)
GENERAL INFORMATION
Type code
Cycle
Number and layout of cylinders
Piston bore and stroke mm
Total capacity cm3
Compression ratio
Max power (EEC) kW
HP
corresponding speed rpm
Max torque (EEC) Nm
kgm
corresponding speed rpm
Fuel
(*) For versions/markets where provided
(Õ) Euro 4
1.3 Multijet
75HP
199A9000
199B2000 (*) (Õ)
Diesel
4 in line
69.6 x 82
1248
16.8 : 1/17.6 : 1 (Õ)
55/51 (*)
75/70 (*)
4000
190
19.4
1750 (
Õ)/1500
235-258 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 239