turn signal bulb FORD AEROSTAR 1996 1.G Owners Manual

322 %
*
[SV44100(ALL)03/95]
Circuit Breakers
[SV44200(ALL)08/95]
If you need to check a circuit breaker, locate the
fuse panel first. Otherwise, locate the circuit
breaker according to the instructions on the
charts given earlier in this chapter.
*
[SV44400(ALL)10/92]
However, you should know that the circuit
breakers will reset themselves and allow the
electrical parts to work again once the overload
on the circuit is removed. If the circuit breakers
continue to cut off electricity, have your vehicle's
electrical system checked.
*
[SV44450(ALL)02/95]
Diagnostic equipment is needed to check circuit
breakers. Refer to the manufacturer's
instructions.
[SV44500(ALL)08/95]
If you replace a circuit breaker, use one with the
same amperage rating. To remove a circuit
breaker, grip it with your finger and thumb and
pull it straight out of its socket.
%
*
[SV44600(ALL)03/95]
Lights and Bulb Replacement
*
[SV44700(ALL)01/95]
It is a good idea to check the operation of the
following lights frequently:
*
[SV44800(ALL)01/95]
q
headlamps
*
[SV44850(ALL)02/95]
q
high-mount brakelamp
*
[SV44900(ALL)01/95]
q
tail lamps
*
[SV45000(ALL)01/95]
q
brakelamps
*
[SV45100(ALL)01/95]
q
hazard flasher
*
[SV45200(ALL)01/95]
q
turn signals
*
[SV45300(ALL)01/95]
q
license plate lamp
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995

323 %
*
[SV45400(ALL)01/95]
The alignment of your headlamps should be
checked if:
*
[SV45500(ALL)01/95]
q
oncoming motorists frequently signal you to
turn off your vehicle's high beams when you
do not have the high beams on
*
[SV45600(ALL)01/95]
q
the headlamps do not seem to give you
enough light to see clearly at night
*
[SV45700(ALL)01/95]
q
the headlamp beams are pointed substantially
away from a position slightly down and to
the right
%*
[SV45800(ALL)03/95]
Headlamp Bulb
*
[SV45900(ALL)01/95]
The headlamps on your vehicle use replaceable
bulbs. When the lamp burns out, simply replace
the bulb, rather than the whole lamp.
*
[SV46000(ALL)05/95]
RWARNING
Handle a halogen headlamp bulb carefully
and keep out of children's reach. Grasp
the bulb only by its plastic base and do
not touch the glass. The oil from your
hand could cause the bulb to break the
next time the headlamps are operated.
*
[SV46050(ALL)12/91]
NOTE: If the bulb is accidently touched, it
should be cleaned with rubbing
alcohol before being used.
*
[SV46100(ALL)01/95]
Do not remove the burned-out bulb unless you
can immediately replace it with a new one. If a
bulb is removed for an extended period of time,
contaminants may enter the headlamp housing
and affect its performance.
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995

Index 371
Lamps (continued)
interior lamps............ 101
replacing bulbs............ 322
trailer................ 219
Lane change indicator (see Turn signal) . . 109
Lap belts................. 20
Lights, warning and indicator
airbag................. 81
brake................. 75
charging system............ 81
check engine.............. 78
door ajar................ 77
engine oil pressure........... 83
hazard warning light......... 113
high beam............... 84
oil pressure.............. 83
safety belt............... 77
service engine soon........... 78
turn signal indicator......... 109
Load limits............... 202
GAWR................ 202
GVWR................ 202
trailer towing............. 205
Lubricant specifications......... 338
Luggage rack.............. 223
Lug nuts................ 237
standard............... 239
tightening sequence.......... 241
Lumbar support, seats.......... 142
Lumbar support pad.......... 142
M
Maintenance schedule and record
(see separate Maintenance Schedule
and Record booklet).......... 3
Maintenance (see Servicing)....... 265
Master cylinder, brakes......... 309
Methanol in fuel............ 277
File:cpixa.ex
Update:Tue Aug 29 17:47:05 1995