instrument cluster FORD AEROSTAR 1997 1.G Owners Manual

7
Instrumentation
%*
[IS00400(ALL)01/96]
The instrument panel (dashboard) on your
vehicle is divided into several different sections.
The illustrations on the following pages show
the major parts of the instrument panel that are
described in this chapter. Some items shown
may not be on all vehicles.
*
[IS00525(ALL)01/96]
In your vehicle, the warning lights and gauges
are grouped together on the instrument panel.
We call this grouping a cluster. Your vehicle has
a mechanical cluster.
File:03cpisa.ex
Update:Fri Jun 7 14:23:36 1996

127
*
[SS12700(ALL)05/96]
q
and the electrical wiring which connects the
components.
*
[SS12800(ALL)05/96]
The diagnostic module monitors its own internal
circuits and the supplemental air bag electrical
system readiness (including the impact sensors),
the system wiring, the air bag system readiness
light, the air bag backup power and the air bag
igniters.
*
[SS12900(ALL)05/96]
Determining if System Is Operational
*
[SS13000(ALL)05/96]
The Air Bag Supplemental Restraint System uses
a readiness light and a tone to indicate the
condition of the system. The readiness light is in
the instrument cluster. When you turn the
ignition key to ON, this light will illuminate for
approximately six (6) seconds and then turn off.
This indicates that the system is operating
normally. NOTE: Routine maintenance of the air
bag system is not required.
%*
[SS13100(ALL)05/96]
A problem with the system is indicated by one
or more of the following:
*
[SS13200(ALL)05/96]
q
the readiness light will either flash or stay lit,
*
[SS13300(ALL)05/96]
q
the readiness light will not light immediately
after ignition is turned on,
%*
[SS13400(ALL)05/96]
q
a group of five beeps will be heard. The tone
pattern will repeat periodically until the
problem and light are repaired.
*
[SS13500(ALL)05/96]
If any of these things happen, even
intermittently, have the Air Bag Supplemental
Restraint System serviced at your Ford or
Lincoln-Mercury dealer immediately. Unless
serviced, the system may not function properly
in the event of a collision.
File:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996

163
Driving
%*
[GF00300(ALL)05/96]
Brakes
*
[GF00350(ALL)01/96]
Front Disc Brakes
*
[GF00400(ALL)01/96]
The front disc brakes are self-adjusting. They do
not require service other than periodic inspection
for pad wear.
*
[GF00450(ALL)03/96]
Rear Drum Brakes
*
[GF00500(ALL)03/96]
The rear drum brakes are self-adjusting.
Automatic adjustment occurs when the brakes
are applied while ªbacking up.º If normal
operation does not include much backing, adjust
the brakes when they seem ªlow,º using the
procedure underIf Brakes Do Not Grip Well or
Pedal is ªLowºin this chapter.
*
[GF00550(ALL)01/96]
Hydraulic Power Brakes
*
[GF00600(ALL)03/96]
The hydraulic brake system is made up of two
independent hydraulic circuits. One hydraulic
circuit supplies fluid to the front disc brakes and
the other hydraulic circuit supplies fluid to the
rear drum brakes. These two circuits are
supplied by a common hydraulic brake fluid
reservoir, with a fluid level sensor.
*
[GF00650(ALL)01/96]
The brake light in the instrument cluster will
light for low brake fluid in the common brake
fluid reservoir.
*
[GF00700(ALL)01/96]
RWARNING
An increase in pedal travel will result in
reduced braking capability. The brake
system should be checked immediately.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

244 [MC08970(ALL)04/96]NOTE: Due to air being trapped in the 4.0L
engine cooling system, it is not
unusual to experiencea4to7ounce
(120 to 210 ml) coolant loss up to 7,500
miles (12,000 km) after initial system
fill.
%
*
[MC09000(ALL)01/96]
Power Steering Fluid
*
[MC09020(ALL)01/96]
Check the level of the power steering fluid at
least twice a year (i.e., every Spring and Fall).
%*
[MC09030(ALL)01/96]
Checking and Adding Power Steering
Fluid
*
[MC09035(ALL)04/96]
1. Start the engine and let it run until the
power steering fluid reaches normal
operating temperature. The power steering
fluid will be at the right temperature when
the engine coolant temperature gauge in the
instrument cluster is near the center of the
NORMAL operating temperature range.
*
[MC09040(ALL)01/96]
2. While the engine idles, turn the steering
wheel back and forth several times. Make
sure that the cap assembly is installed at this
time.
*
[MC09045(ALL)01/96]
3. Turn the engine off.
%*
[MC09050(ALL)01/96]
4. Check the fluid level on the dipstick (which
is highlighted in yellow in your vehicle). The
fluid level should be between the arrows in
the FULL HOT range, which is marked on
the side of the dipstick, opposite the side
marked FULL COLD. Do not add fluid if the
level is within the FULL HOT range.
File:11cpmca.ex
Update:Fri Jun 7 14:30:56 1996

333 [QI05600(ALL)08/95]
full page art:0095087-B
Instrument cluster
File:16cpqia.ex
Update:Fri Jun 14 10:21:06 1996

Index 345
H
Hazard flashers............ 78,199
Headlamps
aiming................ 272
checking alignment.......... 272
cleaning............... 281
daytime running lights......... 72
replacing bulbs............ 272
turning on and off........... 71
warning chime............. 14
Heating
heating and air conditioning system . . . 62
rear seat controls............ 67
standard heater system......... 65
High beams
indicator light............. 14
operation............... 71
High-mount brakelamp, description..... 72
High-mount brakelamp:location...... 72
Hitch................. 194
Hood
latch location............. 231
lubrication specifications........ 296
release lever............. 231
working under the hood....... 230
Hoses, checking............. 243
I
Identification Number, Vehicle (VIN) . . . 300
Idle
relearning..........226, 230, 250
speed................ 156
Ignition
chime................. 14
positions of the ignition......... 74
Indicator lights and chimes (see Lights) . . . 7
Infant seats (see Safety seats).....128, 130
Instrument cluster............. 9
File:cpixa.ex
Update:Fri Jun 7 14:33:41 1996