oil level FORD AEROSTAR 1997 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: AEROSTAR, Model: FORD AEROSTAR 1997 1.GPages: 347, PDF Size: 1.79 MB
Page 19 of 347
16 %
*
[IS07500(ALL)04/96]
Engine Oil Pressure Gauge
*
[IS07601(ALL)01/96]
This gauge indicates the engine's oil pressure,
not the oil level. However, if your engine's oil
level is low, it could affect the oil pressure. With
the engine running, the pointer should move
into the NORMAL band. If the pointer drops
below the NORMAL band while the engine is
running, you have lost oil pressure and
continued operation will cause severe engine
damage.
*
[IS07701(ALL)05/96]
If you lose engine oil pressure:
*
[IS07801(ALL)04/96]
1. Pull off the road as soon as safely possible.
*
[IS07901(ALL)04/96]
2. Shut off the engine immediately or severe
engine damage could result.
*
[IS08001(ALL)01/96]
3. Check the engine's oil level, following the
instructions on checking and adding engine
oil. Refer toEngine oilin the Index. If you
do not follow these instructions, you or
others could be injured. To assure an
accurate reading, your vehicle should be on
level ground.
*
[IS08051(ALL)01/96]
4. If the level is low, add only as much oil as
necessary before you start the engine again.
Do not overfill. Do not operate the engine if
the pointer is below the NORMAL band,
regardless of the oil level. Contact your
nearest dealer for further service actions.
*
[IS08200(ALL)03/96]
quarter page art:0020057-D
Engine oil pressure gauge
File:03cpisa.ex
Update:Fri Jun 7 14:23:36 1996
Page 233 of 347
234
*
[MC06085(ALL)05/96]
NOTE: Ford production and aftermarket
(Motorcraft) oil filters are designed for
added engine protection and long life.
If a replacement oil filter is used that
does not meet Ford material and design
specifications, startup engine noises or
knock may be experienced. It is
recommended you use the appropriate
Motorcraft oil filter (or another brand
meeting Ford specifications) for your
engine application.
%*
[MC06090(ALL)01/96]
Checking and Adding Engine Oil
*
[MC06095(ALL)01/96]
Since the proper amount of engine oil is
important for safe engine operation, check the oil
using the dipstick each time you put fuel in
your vehicle. Remember the engine must be off,
the oil must be warm and the vehicle must be
parked on level ground.
%*
[MC06100(ALL)01/96]
Checking the engine oil level:
*
[MC06110(ALL)01/96]
1. Turn the engine off after it has warmed up
and allow a few minutes for the engine oil
to drain back into the oil pan.
*
[MC06120(ALL)01/96]
2. Set the parking brake, making sure the
gearshift is securely latched in P (Park).
*
[MC06130(ALL)01/96]
3. Open the hood. Protect yourself from engine
heat.
*
[MC06140(ALL)01/96]
4. Locate the engine oil dipstick (highlighted in
yellow) and carefully pull it out of the
engine.
*
[MC06150(ALL)01/96]
5. Wipe the dipstick clean and put it back into
position, making sure it is fully seated.
File:11cpmca.ex
Update:Fri Jun 7 14:30:56 1996
Page 234 of 347
235 [MC06160(ALL)01/96]
quarter page art:0095016-A
Engine oil dipstick
*
[MC06170(ALL)03/96]
6. Carefully pull the dipstick out again. If the
oil level is below the ªADD 1 QTº line, add
engine oil as necessary. If the oil level is
beyond the letter ªFº in Full, engine damage
or high oil consumption may occur and
some oil must be removed from the engine.
*
[MC06180(ALL)01/96]
7. Put the dipstick back in and make sure it is
fully seated.
%*
[MC06190(ALL)01/96]
Adding engine oil
*
[MC06200(ALL)01/96]
It may be necessary to add some oil between oil
changes. Make sure you use a CERTIFIED
engine oil of the preferred viscosity. Your
vehicle's warranty coverage may not apply if
engine damage is caused by the use of improper
engine oil.
*
[MC06210(ALL)01/96]
Add engine oil through the oil filler cap
highlighted in yellow. To add oil, remove the
filler cap and use a funnel to pour oil into the
opening. Be careful not to overfill the engine.
Recheck the oil level after you finish adding oil.
[MC07000(ALL)05/96]
Engine Oil and Filter Changes
*
[MC07100(ALL)05/96]
Change your engine oil and oil filter according
to these mileage and time requirements,
whichever occurs first.
File:11cpmca.ex
Update:Fri Jun 7 14:30:56 1996
Page 235 of 347
236
*
[MC07200(ALL)05/96]
one third page art:0060618-C
Oil change intervals
*
[MC07300(ALL)05/96]
Refer to theMaintenance Schedulebooklet for
additional information.
%
*
[MC08000(ALL)05/96]
Brake Fluid
*
[MC08025(ALL)01/96]
Your vehicle is equipped with a brake fluid level
indicator in the master cylinder which lights the
BRAKE warning light on the instrument panel
when the brake fluid level is low.
*
[MC08050(ALL)01/96]
Under normal circumstances, your vehicle
should not use up brake fluid rapidly. However,
expect the level of the brake fluid to slowly fall
as you put more mileage on your vehicle and
the brake pads wear.
*
[MC08075(ALL)01/96]
Check the brake fluid at least once a year. You
can do this by looking at the fluid level in the
plastic brake fluid reservoir on the master
cylinder. The fluid level should be at or near the
MAX mark.
*
[MC08090(ALL)01/96]
RWARNING
Brake fluid is toxic.
File:11cpmca.ex
Update:Fri Jun 7 14:30:56 1996