brake light FORD ESCORT 1997 7.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: ESCORT, Model: FORD ESCORT 1997 7.GPages: 191, PDF Size: 2.02 MB
Page 6 of 191
INSTRUMENT CLUSTERS
Instrument cluster lights
Base cluster lights
Sport cluster lights
Base cluster lights
0000
000000
MPH
km/h
10 2030405060
70
80
90
10 0
12 011 020 4060
8010 0
12 0
16 0
18 0 140
200
CHECK
COOLANT
THEFT
FUEL FILLEF1/2CH
SERVICE
ENGINE
SOONABSP!BRAKE
0000
000000
MPH
km/h
10 2030405060
70
80
90
10 0
12 011 020 4060
8010 0
12 0
16 0
18 0 140
200
FUEL FILLCHEF1/22
134
5
6
7
8RPM x 1000
CHECK
COOLANTSERVICE
ENGINE
SOON
LOW
FUEL
THEFTABSPBRAKE
0000
000000
MPH
km/h
10 2030405060
70
80
90
10 0
12 011 020 4060
8010 0
12 0
16 0
18 0 140
200
FUEL FILLCHEF1/2
CHECK
COOLANTSERVICE
ENGINE
SOON
LOW
FUEL
THEFTABS!PBRAKE
CH
Instrumentation
6
Page 7 of 191
Sport cluster lights
Low fuel
Illuminates when the fuel tank is
almost empty (approximately 8
liters [2 gallons] remain). The
lights will also briefly illuminate
when the ignition key is turned to
ON and the engine is off.
Service engine soon
Illuminates when the engine's
emissions control system requires
service. The light will also
illuminate, and will remain
illuminated, when the ignition key
is turned to ON and the engine is
off.
Air bag readiness
Illuminates when the air bag
system requires servicing. The
light will also briefly illuminate
when the ignition key is turned to
ON.
0000
000000
MPH
km/h
10 2030405060
70
80
90
10 0
12 011 020 4060
8010 0
12 0
16 0
18 0 140
200
FUEL FILLCHEF1/22
134
5
6
7
8RPM x 1000
SERVICE
ENGINE
SOON
LOW
FUEL
THEFTABS!PBRAKECHECK
COOLANT
LOW
FUEL
SERVICE
ENGINE
SOON
Instrumentation
7
Page 8 of 191
Safety belt
The safety warning light/chime is a
reminder to fasten your safety belt.
One of the following will take
place:
²If the lap/shoulder belt is not
buckled before the key is turned
to the ON position, the
will
illuminate for approximately one
minute or until the safety belt is
buckled.
²If the lap/shoulder belt is
buckled while
is illuminated
and the chime is sounding, both
will turn off.
²If the lap/shoulder belt is
buckled before the key is turned
to the ON position, neither light
or chime will activate.
Upshift (if equipped)
Illuminates when it is best to shift
to the next highest manual
transaxle gear for the maximum
fuel economy.
Brake
Illuminates when the parking brake
is activated and the ignition is
keyed to ON or the brake fluid
level is low. In addition, with the
parking brake off, the light will
illuminate when the engine is
cranked.
!P
BRAKE
Instrumentation
8
Page 9 of 191
Anti-lock brake system (ABS)
Illuminates when the ABS needs
service. The light will also briefly
illuminate when the ignition key is
turned to ON and the engine is off.
Turn signal
Illuminates when the left hand or
right hand turn signal or the
hazard lamps are illuminated.
High beams
Illuminates when the headlamp
high beams are on.
Anti-theft (if equipped)
Illuminates when the anti-theft
system is arming and flashes when
the anti-theft system is armed.
Charging
Illuminates when there is a
problem with the alternator or
charging system and the electrical
system requires service. The light
will also briefly illuminate when
the ignition key is turned to ON
and the engine is off.
Oil pressure
Illuminates when the oil pressure
is low, not the low oil level.
However, if your engine's oil level
is low, it could affect the oil
pressure. Stop the vehicle and
check the oil level as soon as
possible. Do not drive the vehicle if
the light remains on. The light will
also briefly illuminate when the
ignition key is turned to ON and
the engine is off.
ABS
THEFT
Instrumentation
9
Page 26 of 191
ACC allows operation of some
accessories without starting the
engine.
ON allows testing of the vehicle's
warning lights.
START cranks the engine. The key
returns to the ON position after it
is released.
For more information on the
vehicle ignition and starting the
vehicle, refer toPreparing to start
the vehiclein theStarting
chapter.
Headlamp switch
Rotate the headlamp switch to the
desired position.
Headlamps on
Parking lamps, side marker
lamps, instrument panel lamps,
license lamps, and tail lamps on
OFF Lamps off
Daytime running light (DRL)
system (if equipped)
The DRL system turns on the high
beam headlamps, with a reduced
light output, when:
²the vehicle is running
²the vehicle has a fully released
parking brake
²the headlamp system is in the
OFF position
OFF
Controls and features
26
Page 88 of 191
4. Turn the key to the ON position
(without turning the key to
START). Make sure the following
lights illuminate briefly. If a light
fails to illuminate, have the vehicle
serviced.
If the driver's safety belt is
fastened, the
light does not
illuminate.
STARTING THE VEHICLE
After completing the steps under
Preparing to start the vehicle:
1. Turn the key to START and
release.Do notpress the
accelerator.
²The key will return to the ON
position.
2. After idling for a few seconds,
apply the brake and release the
parking brake.
ON
II
ACC
I
LOCK
0
START
III
MP
km/10 203040520 4060
80
SERVICE
ENGINE
SOON
LOW
FUELABS
0
80
90
10 0
12 011 012 0
16 0
18 0 140
200
CHECK
COOLANTTHEFT
ON
II
ACC
I
LOCK
0
START
III
Starting
88
Page 93 of 191
BRAKES
Power-assisted brakes
Apply the brake pedal gradually to
avoid locking up the wheels. The
brakes will adjust automatically as
the brake pads or linings wear
down.
Utilize these strategies for
maximum braking performance:
²If driving down a long or steep
hill, shift to a lower gear and do
not apply the brakes
continuously. Continuously
applying the brakes on a hill
could overheat them and make
them less effective.
²Occasional brake squeal during
light to moderate stops is
normal. Significantly increased
squeal is an indicator that brake
service is needed.
²Apply the brakes gently several
times after driving through
standing water or washing your
vehicle to dry them.
Anti-lock brake system (ABS)
Apply ABS brakes steadily.Do not
pump the brakes in a panic stop.
The brake system will prevent
wheel lockup by automatically
releasing and reapplying the
brakes.
Even with ABS, the brakes could
lock up on roads with alternating
slippery and dry patches or with
loose surfaces such as snow or
gravel. Be careful when braking.
Driving
93
Page 94 of 191
The ABS brake system conducts a
self-test each time the vehicle is
driven. A mechanical noise may be
heard while the system conducts
its self-test.
ABS warning light
TheABSlight in the instrument
cluster illuminates and remains
illuminated if an ABS fault is
detected. Have your vehicle
serviced by a qualified service
technician as soon as possible.
Normal braking operation is still
effective unless the
P!BRAKElight is
also illuminated.
Parking brake
The parking brake should be used
whenever the vehicle is parked.
To set the parking brake:
The parking brake is not designed
to stop a moving vehicle. However,
if the normal brakes fail, the
parking brake can be set to stop
the vehicle. The vehicle's stopping
distance will increase greatly and
vehicle steering response will be
limited.
When the ignition is turned to ON,
the
P!BRAKElight in the instrument
cluster illuminates and remains
illuminated until the parking brake
is released.
Driving
94
Page 95 of 191
If the parking brake is fully
released but the
P!BRAKEwarning light remains on,
have the brakes checked
immediately. They may not be
working properly.
Always set the parking
brake fully and make sure
that the gearshift is securely
latched in P (automatic
transaxle) or first gear (manual
transaxle).
To release the parking brake:
²While pressing the release
button, pull the handle upward
to release the brake.
²Push handle downward to the
off position.
Driving
95
Page 98 of 191
3. Push and hold the thumb
button.
4. Move the gearshift.
If it is necessary to use the above
procedure to move the gearshift, it
is possible that a fuse has blown
and the vehicle's brakelamps may
not be operating properly. For
more information on fuses and fuse
replacement, refer toFuses and
relaysin theRoadside
emergencieschapter.
Do not drive your vehicle
until you verify that the
brakelamps are working.
If an automatic transaxle vehicle
gets stuck in mud or snow it may
be rocked out of the spot. To rock
the vehicle out, shift between
forward and reverse gears in a
steady rhythm. Press lightly on the
accelerator in each gear. Do not
rock the vehicle for more than a
few minutes; this could damage
the vehicle.
Do not spin the wheels at
over 55 km/h (35 mph).
The tires may fail and injure a
passenger or bystander.
P
R
N
D
D
L
Driving
98