washer fluid FORD F150 1997 10.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: F150, Model: FORD F150 1997 10.GPages: 219, PDF Size: 2.21 MB
Page 158 of 219
12. Windshield washer fluid
reservoir
4.6/5.4L engine
1. Battery
2. Automatic transmission dipstick
(if equipped)
3. Engine oil filler
4. Engine oil dipstick
5. Clutch fluid reservoir (if
equipped)
6. Brake master cylinder
7. Power distribution box
8. Engine coolant recovery
reservoir
9. Air cleaner
10. Radiator cap
10118129
1245673
f12_4.6L_5.4L_engine
Maintenance and care
159
Page 159 of 219
11. Power steering fluid reservoir
12. Windshield washer fluid
reservoir
ENGINE OIL
Oil specifications
Use WSS-M2C153±F motor oil
CERTIFIED FOR GASOLINE
ENGINES by the American
Petroleum Institute.
Engine oils with an SAE 5W-30
viscosity and displaying the
American Petroleum Institute
certification mark are preferred for
your vehicle. They provide the best
engine performance, fuel economy
and engine protection for all
climates down to ±25ÉC (-15ÉF).
Do not use:
²ªnon-detergentº oils
²oils labeled API SA, SB, SC, SD,
SE, SF or SG
²additional engine oil additives,
oil treatments or engine
treatments
Additional engine oil additives, oil
treatments, or engine treatments
are never needed and could, under
certain conditions, lead to engine
damage which is not covered by
your Ford warranty.
Synthetic engine oils which are
CERTIFIED and of the preferred
viscosity may be used in your
engine. The engine oil and oil filter
must still be changed according to
the ªService Guide.º
f12_engine_oil
f12_oil_specs
Maintenance and care
160
Page 164 of 219
Do not let the reservoir for
the master cylinder run
dry. This may cause the brakes
to fail.
CHECKING AND ADDING
CLUTCH FLUID (IF EQUIPPED)
During normal operation, the fluid
level in the clutch reservoir will
slowly rise. If the fluid level drops,
maintain the fluid level at the step
in the reservoir.
Use only a DOT 3 brake fluid
designed to meet Ford
specifications. Refer toCapacities
and specifications.
1. Clean the reservoir cap before
removal to prevent dirt and water
from entering the reservoir.
2. Remove cap.
3. Add fluid until the level reaches
the FULL line.
f12_clutch_fluid
f12_washer_fluid
Maintenance and care
165
Page 165 of 219
CHECKING AND ADDING
WINDSHIELD WASHER FLUID
1. Lift the washer fluid reservoir
cover.
2. Add washer fluid intil the level
reaches the FULL line.
Use only fluid that meets Ford
Specifications. Refer toCapacities
and specifications.
The addition of a bug shield to the
front of the vehicle may adversely
affect the washer system from
delivering fluid to the windshield.
Devices such as bug shields are
not recommended.
Windshield washer fluid
contains methanol and it is
poisonous. Follow all instructions
on the bottle of washer fluid.
What you should know about
washer fluid
In freezing weather [temperatures
below 0ÉC (32ÉF)], use washer
fluid containing a small amount of
antifreeze, such as methanol. State
or local regulations on volatile
organic compounds (VOCs) may
restrict the use of methanol, a
common type of antifreeze.
Use a non-methanol antifreeze in
freezing weather only if the fluid
does not damage the paint finish,
wiper blades and washer system.
WASHER FLUID
ONLY
f12_wysk_washer_fluid
f12_coolant
Maintenance and care
166
Page 166 of 219
CHECKING AND ADDING
ENGINE COOLANT
Adding engine coolant
Do not put engine coolant
in the container for the
windshield washer fluid.
If sprayed on the windshield,
engine coolant could make it
difficult to see through the
windshield.
When the engine is cool, add a
50/50 mixture of engine coolant
and water to the engine coolant
recovery reservoir ± DO NOT ADD
DIRECTLY TO THE RADIATOR.
Add straight water only in an
emergency, but you should replace
it with a 50/50 mixture of coolant
and distilled water as soon as
possible.
Check the coolant level in the
coolant recovery reservoir the next
few times you drive the vehicle. If
necessary, add enough of a 50/50
mixture of coolant and water to
bring the liquid level to the fill line
on the reservoir.
Never remove the coolant
recovery cap while the
engine is running or hot.
COOLANT FILL
LEVEL
f12_adding_coolant
Maintenance and care
167
Page 208 of 219
dirt buildup act as insulators and
keep the engine warmer than
normal. Follow these guidelines to
clean your engine:
²Take care when using a power
washer to clean the engine. The
high pressure fluid could
penetrate the sealed parts and
cause damage.
²Do not spray with cold water to
avoid cracking the engine block.
²Cover the highlighted areas to
prevent water damage when
cleaning the engine.
²Never wash or rinse the engine
while it is running; water in the
running engine may cause
internal damage.
Cleaning plastic exterior parts
Use a vinyl cleaner for routine
cleaning of plastic. Clean with a tar
remover if necessary. Do not clean
com_plastic_exterior.01
Maintenance and care
209
Page 214 of 219
FluidFord part
nameVehicle type Capacity
Transmission
fluid;
manual
2
Motorcraft
MERCONT
Multi-purpose
AT F5-speed manual 3.5L (3.75 qts.)
Windshield
washer fluidUltra-clear
windshield
washer fluid
concentrateAll 4.0L (4.25 qts.)
(1) Add 118 ml (4 oz.) of additive friction modifier C8AZ-19B546-A,
Ford specification EST-M2C118±A, for complete fill of 22.35 cm (8.8
in.) and 24.76 cm (9.75 in) ring gear Traction-Lok axles.
(2) Add 236 ml (8 oz.) of additive Friction Modifier C8AZ-19B546-A,
Ford Specification EST-M2C118-A, for complete fill of 26.03 cm
(10.25 in) Ring Gear Traction-Lok axles.
1Includes filter replacement.
2Fill to 6 mm (3/8 in) below
bottom of filler hole.
3Fill to bottom of filler hole.
LUBRICANT SPECIFICATIONS
FluidFord part name
or equivalentFord part
numberFord
specification
Axle lubricant;
frontSAE 75W90 XY-75W90-QL
(Thermally
Stable)WSP-M2C201-A
Axle lubricant;
rearHigh
Performance
Rear Axle
LubricantF1TZ-19580-B WSL-M2C192-A
f12_lube
Capacities and specifications
215
Page 215 of 219
FluidFord part name
or equivalentFord part
numberFord
specification
Brake fluid and
clutch fluidHigh
Performance
DOT 3 brake
fluidC6AZ-19542-AB ESA-M6C25-A
and DOT 3
Engine coolantPremium engine
coolantE2FZ-19549-AA
or BESE-M97B44-A
Engine oilSuper Premium
Motorcraft Motor
Oil 5W30XO-5W30-BSP
or QSPWSS-M2C153-F
Grease; body
hinges, latches
and seat tracks.Multi-Purpose
GreaseD0AZ-19584-AA
or
D7AZ-19584-AAESB-M1C93-A
or
ESB-M1C106-B
Grease;
transmission
/steering/parking
brake linkages
and pivots.
Brake and
clutch pedal
shaft.Premium
Long-Life
GreaseXG-1-C ESA-M1C75-B
Parking brake
cableSpeedometer
cable lubricantE6TZ-19581-A ESF-M1C60-A
Power steering
fluid, transfer
case fluid and
transmission
fluid (manual
and automatic)Motorcraft
MERCONT
Multi-purpose
AT FXT-2-BDX or
QDXMERCONT
Windshield
washer fluidUltra-clear
windshield
washer
concentrateC9AZ-19550-AC
or BCESR-M17P5-A
Capacities and specifications
216