bulb FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual POLICE INTERCEPTOR SEDAN 2014 1.G FORD FORD https://www.carmanualsonline.info/img/11/5316/w960_5316-0.png FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual

Page 6 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual Roadside Emergencies 193
Getting roadside assistance..............................193
Hazard warning flashers................................194
Fuel cut-off switch....................................

Page 101 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual High beams
Illuminates when the high-beam headlamps are on.
Low fuel (RTT)
Illuminates when the fuel level in the fuel tank is at or near
empty.
Low tire pressure warning
Illuminates when your tire pr

Page 102 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual Service engine soon
Theservice engine soonindicator light illuminates when the
ignition is first turned to the on position to check the bulb and to
indicate whether the vehicle is ready for Inspection

Page 143 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual Readiness for Inspection/Maintenance (I/M) Testing
Some state, provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle

Page 243 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual ADJUSTING THE HEADLAMPS
The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident, an authorized dealer should
check the alignment of your headlam

Page 245 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual CHANGING A BULB
Lamp Assembly Condensation
Exterior lamps are vented to accommodate normal changes in pressure.
Condensation can be a natural by-product of this design. When moist air
enters the lamp

Page 246 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual Headlamp (Sedan):
A. Front parking lamp/turn signal
bulb
B. Low/High beam headlamp bulb
C. Sidemarker bulb
Low/High beam bulbs (Sedan)
1. Make sure the headlamp switch is
in the off position, then ope

Page 247 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual Low/High beam bulbs (Utility)
1. Make sure the headlamp switch is
in the off position, then open the
hood.
2. Reach in behind the headlamp
assembly to access the bulbs and
connectors.
3. Remove servic

Page 248 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual Front parking lamp/turn signal and sidemarker bulbs without
wig-wags (Utility)
1. Make sure that the headlamp control is
in the off position.
2. Open the hood.
3. Remove the hood overslam bumper
tower

Page 249 of 406

FORD POLICE INTERCEPTOR SEDAN 2014 1.G Owners Manual Replacing sidemarker bulbs (Utility)
1. Rotate the bulb socket
counterclockwise and remove it from
the lamp assembly.
2. Pull the bulb straight out of the
socket.
Reverse steps to reinstall bulb(s).
F
Page:   1-10 11-20 next >