brake pads FORD SIERRA 1988 2.G Braking System Workshop Manual

FORD SIERRA 1988 2.G Braking System Workshop Manual SIERRA 1988 2.G FORD FORD https://www.carmanualsonline.info/img/11/5452/w960_5452-0.png FORD SIERRA 1988 2.G Braking System Workshop Manual

Page 1 of 22

FORD SIERRA 1988 2.G Braking System Workshop Manual System type
Conventional braking system (except P100 models)  . . . . . . . . . . . . . . . Front discs and rear drums with vacuum servo assistance, dual
hydraulic circuit split front/rear, decelerati

Page 3 of 22

FORD SIERRA 1988 2.G Braking System Workshop Manual 8Open the bleed screw half a turn and have
your assistant depress the brake pedal slowly
to the floor and then, after the bleed screw is
retightened, quickly remove his foot to allow
the pedal to retu

Page 4 of 22

FORD SIERRA 1988 2.G Braking System Workshop Manual the caliper, free it using a screwdriver with the
guide pin bolt fitted, as shown (see
illustration). Do not use a screwdriver to free
the inboard pad, as this may damage the
piston dust seal. The inb

Page 5 of 22

FORD SIERRA 1988 2.G Braking System Workshop Manual the caliper, and the caliper body is modified
accordingly. Also, plastic covers are fitted to
the caliper guide bolts (see illustrations).
22Procedures are unchanged from those
given above.
Rear disc

Page 9 of 22

FORD SIERRA 1988 2.G Braking System Workshop Manual neck with a rubber band, or by refitting the
cap. This will reduce the loss of fluid during
the following procedure.
3Disconnect the flexible fluid hose from the
rigid brake pipe under the wing of the