heater GMC CANYON 2009 Get To Know Guide

9
The heated seat controls are located on
the outboard sides of the front seats.
(The ignition must be on for this feature
to work.)
Activate the heated seats
• Press the lower part of the switch to
turn on the heater to the LO setting.
• Press the upper part of the switch to
turn on the heater to the HI setting.
• Place the switch in the center position
to turn the heater off.
See Section 1 of your Owner Manual.
Note:In order for the passenger heated
seat to operate, the passenger safety
belt must be buckled.
Manual/Power Lumbar
(if equipped)
The manual lumbar control knob is
located on the outboard side of the driv-
er’s seat. Turn the knob counterclock-
wise to increase lumbar support and
clockwise to decrease lumbar support.
The power lumbar control switches for
the driver and passenger seats are
located on the outboard side of the
seats.
See Section 1 of your Owner Manual.
Preventing Window Fogging
ENTERTAINMENT
Audio Systems
AM/FM Stereo (if equipped)
Set the clock on the AM/FM stereo
radio
• Press and hold the HR button until
the correct hour appears.
• Press and hold MIN until the correct
minute appears.
Display the time with the ignition off
• Press RCL, HR or MIN. To clear fog or frost from the windshield
or side windows, turn the airflow control
knob to one of the following modes:
(Floor/Defog):Use to clear the
windows of moisture and to warm
passengers. This mode splits the air
delivery between the windshield and
the floor outlets.
(Defrost):Use to remove fog or
frost from the windshield more quickly.
This mode directs most of the air to
the windshield.
When you select the floor/defog or
defrost mode, the system automatically
turns off the recirculation mode and
runs the air conditioning compressor.
The recirculation mode cannot be
selected because outside air is needed
to remove interior moisture from the
vehicle.
See Section 3 of your Owner Manual.
Heated Seats (if equipped)