set clock HONDA S2000 2000 1.G Owners Manual

Remove the old battery and note the
polarity. Make sure the polarity of
the new battery is the same (
+ side
facing up), then insert it
in the
transmitter.
Align the
v mark on the cover
with the
0 mark on the
transmitter, then set the cover
in
place and turn it clockwise.
Transmitter Care
Avoid severe shock to the trans­
mitter, such as dropping or throwing
it. Also, protect it from extreme hot
or cold temperatures.
Clean the transmitter case with a
soft cloth.
Do not use strong
cleaners or solvents that could harm
the case. Immersing the transmitter
in any liquid will harm the trans­
mitter and cause it to not function
properly.
If you lose a transmitter, you will
need to have the replacement
programmed to your vehicle's
system by your Honda dealer. Any
other transmitters you have
will also
need to be reprogrammed.
Keys and Locks
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions:
(1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that
may cause undesired
operation.
Changes
or modifications not expressly
approved
by the party responsible for
compliance could void
the user's
authority to operate
the equipment.
111is device complies with Industry
Canada Standard RSS-210.
Operation is subject
to the following two
conditions:
(1) this device may not cause
interference,
and (2) this device must
accept any interference that may cause
undesired operation
of the device.
Instruments and Controls 65

7. Install the new bulb in the socket.
8. Push the socket into the light
assembly and turn it clockwise
until it locks.
9. Test the lights to make sure the
new bulb is working.
lO.Install the trunk lining and secure
it with the fasteners. To reinstall a
fastener, reset the fastener by
pushing on the pointed end until it
pops back almost flush with the
fingers on the housing.
Put the
fastener
in the hole of the trunk
lining and push on the center until
it locks (the center is flush with
the head).
Lights
Maintenance 199