light Hyundai Elantra 2006 Owner's Guide
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2006, Model line: Elantra, Model: Hyundai Elantra 2006Pages: 277, PDF Size: 10.18 MB
Page 76 of 277

1FEATURES OF YOUR HYUNDAI
62
B360A01Y-GAT (If installed) To turn on the rear fog lights, push the switch. They will come on when the headlight switch is in the second posi-tion and the key is in the "ON" position. B360A02EB345G01E-GAT (If installed)
B345H01E
Do not operate the washer continu- ously for more than 15 seconds orwhen the fluid reservoir is empty; this could damage the system. Do not op- erate the wiper when the window isdry; this can result in scratching as well as premature wiper blade wear. For the reason stated above,do notoperate the washer when the washer fluid reservoir is empty.
B345G01E
REAR FOG LIGHT SWITCH HEADLIGHT WASHER
SWITCH
Page 77 of 277

1
FEATURES OF YOUR HYUNDAI
63REAR WINDOW DEFROSTER SWITCH
B380A02A-AAT The rear window defroster and heated outside rearview mirrors are turned onby pushing in the switch. To turn the defroster off, push the switch a second time. The rear window defroster auto-matically turns itself off after about 15 minutes. To restart the defroster cycle, push in the switch again after it hasturned itself off. B380B01E
The headlight washer switch can beoperated with the ignition switch at the"ON" position and the light switch at
the "ON" position. Push the button and the washer fluid will be sprayed on tothe headlights for about 0.7 second. NOTE: Check the headlight washers peri- odically to confirm that the washerfluid is being sprayed properly onto the headlight lenses.
NOTE: The ignition must be in the "ON" position for the rear window defroster to operate.
!
CAUTION:
Do not clean the inner side of the rear window glass with an abrasive type of glass cleaner or use a scraper to remove foreign deposits from theinner surface of the glass as this may cause damage to the defroster ele- ments.
Page 78 of 277

1FEATURES OF YOUR HYUNDAI
64TICKET HOLDER
B590A01E-AAT For your convenience, it may be used for holding a tollgate ticket. HXDFL240
B400A01E-AAT There are three control buttons for the digital clock. Their functions are: HOUR
-Push "H" to advance the hour
indicated.
MIN -Push "M" to advance the
minute indicated.
RESET - Push "R" to reset minutes to
":00" to facilitate resetting the clock to the correct time. When this is done:
Pressing "R" between 10 : 30 and 11 :29 changes the readout to 11 : 00.Pressing "R" between 11 : 30 and 12 : 29 changes the readout to 12 : 00. Push the "R" buttion for 5 seconds to display a 12- or 24-hour clock (If in- stalled).
HAZARD WARNING SYSTEM
B370A01A-AAT The hazard warning system should be used whenever you find it necessaryto stop the car in a hazardous location. When you must make such an emer- gency stop, always pull off the road asfar as possible. The hazard warning lights are turned on by pushing in the hazard switch.This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not inthe ignition. To turn the hazard warning lights off, push the switch a second time. HXDFL371
DIGITAL CLOCK
HXDFL400-1
Page 79 of 277

1
FEATURES OF YOUR HYUNDAI
65INSTRUMENT PANEL LIGHT CONTROL (RHEOSTAT)
B410A01A-AAT (If installed) The instrument panel lights can be made brighter or dimmer by turning the instrument panel light control knob. B420A02A-AAT For the cigarette lighter to work, the key must be in the "ACC" position or the "ON" position.To use the cigarette lighter, push it all the way into its socket. When the element has heated, the lighter willpop out to the "ready" position. Do not hold the cigarette lighter pressed in. This can damage the heating ele-ment and create a fire hazard. If it is necessary to replace the ciga- rette lighter, use only a genuine Hyundaireplacement or its approved equiva- lent.
B410A01E
HXDFL420
CIGARETTE LIGHTER
CAUTION:
Do not use electric accessories or equipment other than the Hyundai genuine parts in the socket.
!
Page 80 of 277

1FEATURES OF YOUR HYUNDAI
66POWER OUTLETASHTRAY
B430A01B-AAT Front Ashtray
The front ashtray may be opened by pushing and releasing the ashtray lid. To remove the ashtray to empty orclean it, lift the metal ash receptacle upward and pull it out. The ashtray light will only illuminate when the exter-nal lights are on (If installed).
!
B500D08O-AAT
These supply 12V electric power to operate electric accessories or equip-ment only when the key is in the "ON" or "ACC" position. CAUTION:
o Use the power outlet only when the engine is running and removethe plug from the power outlet after using the electric device.Using when the engine stops or keeping the electric device with plugged in for many hours maycause the battery to discharge.
o Do not use the power outlet to
connect electric accessories orequipment that are not designed to operate on 12 volts.
o Some electronic devices can cause electronic interference whenplugged into the power outlet. These devices may cause exces-sive audio noise and malfunctions in other electronic systems or de- vices in your vehicle. HXDFL440
HXDFL421
Page 81 of 277

1
FEATURES OF YOUR HYUNDAI
67PARKING BRAKEDRINK HOLDER
B450A01E-AAT Front Drink Holder The front drink holder for holding cups is located on the right side of the parking brake.
B530A01A-AAT Always engage the parking brake be- fore leaving the car. This also turns onthe parking brake indicator light when the key is in the "ON" or "START" position. Before driving away, be surethat the parking brake is fully released and the indicator light is off.
o To engage the parking brake, pull
the lever up as far as possible.
o To release the parking brake, pull up the lever and press the thumb button. Then, while holding the but- ton in, lower the brake lever. B530A01E
B440A01E-AAT Rear Ashtray The rear ashtray may be opened by pulling the lid out by its top edge. To remove the ashtray to empty or clean it, press down on the spring-loaded tabinside the ashtray and lift the ashtray upward and pull it all the way out.
B430A01E
HXDOM120
Page 83 of 277

1
FEATURES OF YOUR HYUNDAI
69HEADLIGHT LEVELING DEVICE SYSTEMSEATBACK
B340G01S-GAT (If installed) To adjust the headlight beam level according to the number of the pas- sengers and the loading weight in theluggage area, turn the beam leveling switch. The higher the number of the switchposition, the lower the headlight beam level. Always keep the headlight beam at the proper leveling position, or head-lights may dazzle other road users.B340G02E
B540B01E-GAT POCKET (If installed)
HXDFL536
There is a front passenger seatback holder to hang a shopping bag.
HXDFL1034
B540A02TB-GAT HOLDER (If installed)
!
CAUTION
o Do not hang a bag beyond 3 kg. It may cause damage to the seatback holder.
o Return it to the original position after using the seatback holder.
The seatback pockets for holding pa- pers are located on the backside of the front seats.
!WARNING:
Do not use when the passenger (especially the child) is in the rear seat, as the seatback holder could result in serious injury to the pas-senger in the event of an accident or sudden stop.
Page 84 of 277

1FEATURES OF YOUR HYUNDAI
70
B460B03E-AAT OPERATING THE SUNROOF SYSTEMOpening or Closing the Sunroof
B460B02E
The sunroof can be electrically opened or closed with the ignition key in the "ON" position. The sunroof is moved to its fully open position by pushing andholding the "OPEN" button. Release the button when the sunroof reaches the desired position. To close, pressand hold the "CLOSE" button.
SUNROOF
Listed below are the examples of proper switch settings. For loading conditionsother than those listed below, adjust the switch position so that the beam level may be the nearest as the condi-tion obtained according to the list. B470A02S-AAT SUNSHADE The sunshade can be opened and closed by sliding it forward or rearwardwhen the sunroof is closed. The sun- shade will be opened automatically when the sunroof is opened, but itmust be closed manually.
B460A01S-AAT (If installed) The sunroof can be operated with the ignition key in the "ON" position
Switch position 0 0 1 2
3
Loading condition Driver only Driver + front passengerFull passengers (including driver) Full passengers (includ-ing driver) + full trunk loading (or light trailer loading)
Driver + full trunk load- ing (or maximum trailer
loading)
B470A01E
!WARNING:
Never adjust the sunshade while driving.
Page 85 of 277

1
FEATURES OF YOUR HYUNDAI
71
!
B460C02E-AAT Tilting the Sunroof
The sunroof can be tilted by pushing the "UP" button with the sunroof closed. Release the button when the sunroofreaches the desired position. To close the sunroof, press the "DOWN" but- ton. NOTE: After washing the car or after there is rain, be sure to wipe off any waterthat is on the sunroof before oper- ating it.
! CAUTION:
o Do not open the sunroof in se- verely cold temperature or when it is covered with ice or snow.
o Periodically remove any dirt that may have accumulated on theguide rails.
o Do not press any sunroof control button longer than necessary.Damage to the motor or systemcomponents could occur. B460C02EB460D03E-AAT Manual Operation of Sunroof If the sunroof does not operate electri- cally:
1. Remove the rectangular plastic inte-
rior light lenses in the front overhead console by using a flat blade screw- driver as shown. B460D02E
WARNING:
o Do not close a sunroof if anyone's hands, arms or body are between the sliding glass and the sunroofsash, as this could result in injury.
o Do not place your head or arms
out of the sunroof opening at anytime.
Page 86 of 277

1FEATURES OF YOUR HYUNDAI
72
B480A01E-AAT FRONT INTERIOR LIGHT Map Light (If installed) The two map light buttons are located on both sides of the front overheadconsole. Push in the map light button to turn the light on or off. This light produces a spot beam for convenientuse as a map light at night or as a personal light for the driver and the passenger.With Sunroof
B480A02E
Without Sunroof
INTERIOR LIGHT
2. Remove the mounting screws of the
front overhead console with a flat blade screwdriver. B460E02E
B460F02E
3. Insert the hexagonal head wrench provided with the vehicle into thesocket. This wrench can be found in the vehicle's trunk or glove box.
4. Turn the wrench clockwise to open
or counterclockwise to close.