HYUNDAI I10 2023 Owners Manual
I10 2023
HYUNDAI
HYUNDAI
https://www.carmanualsonline.info/img/35/56218/w960_56218-0.png
HYUNDAI I10 2023 Owners Manual
Trending: airbag off, relay, change language, driver seat adjustment, open gas tank, service interval reset, adjusting time
Page 371 of 486
7-19
07
& K D Q J L Q J W \ U H V
WARNING
$ Y H K L F O H F D Q V O L S R U U R O O R I I R I D
M D F N F D X V L Q J V H U L R X V L Q M X U \ R U
G H D W K W R \ R X R U W K R V H Q H D U E \ 7 D N H
W K H I R O O R Z L Q J V D I H W \ S U H F D X W L R Q V
Page 372 of 486
7-20
Emergency situations
OAC3079008TU
7. Place the jack at the designated
jacking position under the frame
closest to the tyre you are chang-
ing. The jacking positions are
plates welded to the frame with two
notches. Never jack any other
position or part of the vehicle.
Doing so may damage the side
seal molding or other parts of the
vehicle.
OAC3079009TU
8. Insert the jack handle into the jack
and turn it clockwise, raising the
vehicle until the tyre clears the
ground. Make sure the vehicle is
stable on the jack.9. Loosen the lug nuts with the wheel
lug nut wrench and remove them
with your fingers. Remove the
wheel from the studs and lay it flat
on the ground out of the way.
Remove any dirt or debris from the
studs, mounting surfaces, and
wheel.
10. Install the spare tyre onto the
studs of the hub.
11 . Tighten the lug nuts with your fin-
gers onto the studs with the small-
er end of the lug nuts closest to
the wheel.
12. Lower the vehicle to the ground
by turning the jack handle coun-
terclockwise.
OAC3079027TU
13. Use the wheel lug nut wrench to
tighten the lug nuts in the order
shown. Double-check each lug
nut until they are tight. After
changing tyres, we recommend
that a HYUNDAI authorised
repairer tighten the lug nuts to
their proper torque as soon as
possible. 7 K H Z K H H O O X J Q X W
V K R X O G E H W L J K W H Q H G W R a
N J I P a O E I I W
Page 373 of 486
7-21
07
If you have a tyre gauge, check the
tyre pressure (see “Tyres and
Wheels” in chapter 2 for tyre pressure
instructions.). If the pressure is lower
or higher than recommended, drive
slowly to the nearest service station
and adjust it to the recommended
pressure. Always reinstall the valve
cap after checking or adjusting tyre
pressure. If the cap is not replaced,
air may leak from the tyre. If you lose
a valve cap, buy another and install it
as soon as possible. After changing
tyres, secure the flat tyre and return
the jack and tools to their proper stor-
age locations.
NOTICE
Page 374 of 486
7-22
Emergency situations
When driving with the compact spare
tyre mounted to your vehicle:
Page 375 of 486
7-23
07
- D F N O D E H O
The actual Jack label in the vehicle
may differ from the illustration.
For more detailed specifications,
refer to the label attached to the jack.
1. Model Name
2. Maximum allowable load
3. When using the jack, set your park-
ing brake.
4. When using the jack, stop the
engine.
5. Do not get under a vehicle that is
supported by a jack.
6. The designated locations under
the frame7. When supporting the vehicle, the
base plate of jack must be vertical
under the lifting point.
8. Shift into R (Reverse) gear on vehi-
cles with Manual transmission or
move the shift lever to the N
(Neutral) position on vehicles with
Automated manual transmission.
9. The jack should be used on firm
level ground.
10. Jack manufacture
11. Production date
12. Representative company and
address
OHYK065011
Page 376 of 486
7-24
Emergency situations
( & ' H F O D U D W L R Q R I F R Q I R U P L W \ I R U - D F N
JACKDOC14S
Page 377 of 486
7-25
07
OAC3079010TU
For safe operation, carefully read and
follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tyre Mobility Kit is a temporary
fix to the tyre and we recommend that
the system be inspected by a
HYUNDAI authorised repairer.
CAUTION
: K H Q W Z R R U P R U H W \ U H V D U H I O D W G R
Q R W X V H W K H W \ U H P R E L O L W \ N L W
E H F D X V H W K H V X S S R U W H G R Q H V H D O-
D Q W R I 7 \ U H 0 R E L O L W \ . L W L V R Q O \ X V H G
I R U R Q H I O D W W \ U H
WARNING
' R Q R W X V H W K H 7 \ U H 0 R E L O L W \ . L W W R
U H S D L U S X Q F W X U H V L Q W K H W \ U H Z D O O V
7 K L V F D Q U H V X O W L Q D Q D F F L G H Q W G X H
W R W \ U H I D L O X U H
WARNING
+ D Y H \ R X U W \ U H U H S D L U H G D V V R R Q D V
S R V V L E O H 7 K H W \ U H P D \ O R V H D L U
S U H V V X U H D W D Q \ W L P H D I W H U L Q I O D W L Q J
Z L W K W K H 7 \ U H 0 R E L O L W \ . L W
, Q W U R G X F W L R Q
With the Tyre Mobility Kit you stay
mobile even after experiencing a tyre
puncture.
The system of compressor and seal-
ing compound effectively and com-
fortably seals most punctures in a
passenger car tyre caused by nails or
similar objects and reinflates the tyre.
After you ensured that the tyre is
properly sealed you can drive cau-
tiously on the tyre (distance up to 120
miles (200 km)) at a max. speed 50
mph (80 km/h) in order to reach a ser-
vice station or tyre dealer to have the
tyre replaced.
It is possible that some tyres, espe-
cially with larger punctures or dam-
age to the sidewall, cannot be sealed
completely.
Air pressure loss in the tyre may
adversely affect tyre performance.
For this reason, you should avoid
abrupt steering or other driving
manoeuvres, especially if the vehicle
is heavily loaded or if a trailer is in
use.
The Tyre Mobility Kit is not designed
or intended as a permanent tyre
repair method and is to be used for
one tyre only. This instruction shows
you step by step how to temporarily
seal the puncture simply and reliably.
Read the section “Notes on the safe
use of the Tyre Mobility Kit”.
IF YOU HAVE A FLAT TYRE ãWITH TYRE MOBILITY KIT
IF EQUIPPEDä
Page 378 of 486
7-26
Emergency situations
WARNING
' R Q R W X V H W K H 7 0 . L I D W \ U H L V
V H Y H U H O \ G D P D J H G E \ G U L Y L Q J U X Q
I O D W R U Z L W K L Q V X I I L F L H Q W D L U S U H V-
V X U H
2 Q O \ S X Q F W X U H G D U H D V O R F D W H G Z L W K-
L Q W K H W U H D G U H J L R Q R I W K H W \ U H F D Q
E H V H D O H G X V L Q J W K H 7 0 .
1 R W H V R Q W K H V D I H X V H R I W K H
W \ U H 0 R E L O L W \ . L W
Page 379 of 486
7-27
07
& R P S R Q H Q W V R I W K H 7 \ U H 0 R E L O L W \ . L W
1. Speed-restriction label
2. Sealant bottle and label with speed
restriction
3. Filling hose from sealant bottle to
wheel
4. Connectors and cable for the
power outlet direct connection
5. Holder for the sealant bottle
6. Compressor
7. ON/OFF switch8. Pressure gauge for displaying the
tyre inflation pressure
9. Button for reducing the tyre infla-
tion pressure
Connectors, cable and connection
hose are stored in the compressor
housing.
Strictly follow the specified sequence,
otherwise the sealant may escape
under high pressure.
ODE067044
Page 380 of 486
7-28
Emergency situations
WARNING
( [ S L U H G V H D O D Q W
' R Q R W X V H W K H 7 \ U H V H D O D Q W D I W H U
W K H V H D O D Q W K D V H [ S L U H G L H S D V W
W K H H [ S L U D W L R Q G D W H R Q W K H V H D O D Q W
F R Q W D L Q H U 7 K L V F D Q L Q F U H D V H W K H
U L V N R I W \ U H I D L O X U H
WARNING
6 H D O D Q W
Trending: coolant capacity, trip computer, warning lights, fuel fill door release, air conditioning, wiper blades, belt
