check engine Hyundai Matrix 2007 Owner's Manual

6
OWNER MAINTENANCE
17
The level of windscreen washer fluid available should be checked on a daily basis. The level of fluid will be visible through the side of the reservoir.When the fluid is to be replenished, only a proprietary screen wash addi- tive should be used and in the concen- tration recommended by the manufac- turer. The windscreen washer reser- voir has a total capacity of 3 litres.
WINDSCREEN WASHER RESERVOIR REPLENISH- MENT
SG090A2-E
HFC5010
!CAUTION:
Engine coolant anti freeze must not be used in the windscreen washer system since damage to thepaintwork may result.
Undiluted windscreen washer addi-tive must not be allowed to comeinto contact with the paintwork. If spillage occurs, flush the affected area immediately with water. Do notoperate the windscreen washer for more than 15 seconds continuously or when the reservoir is empty since damage to the washer pump will result.
HHR5051
2. Pull up the wiper blade until you hear an audible "click" to engage in the end of the wiper arm.
NOTE: Do not allow the wiper arm to fall
against the windscreen.
fcuk-6.p65 12/27/2006, 10:16 AM
17

6 OWNER MAINTENANCE
18
!
CHECKING THE TRANSAXLE OIL
SG100A2-E
MANUAL TRANSAXLE LUBRI-CANT
The manual transaxle lubricant must be checked and or changed at the intervals specified in the maintenanceschedule. Only those lubricants speci- fied should be used in order to prevent gear shifting difficulties or transaxledamage. WARNING:
The transaxle lubricant level should
only be checked when the engine iscold to preclude the possibility ofpersonal injury by contact with hot components. NOTE: It is recommended that the manual transaxle lubricant should be checked by Hyundai authorised re- pairer. Recommended Oil Use only HYUNDAI GENUINE PARTS MTF 75W/85 (API GL-4) in the manualtransaxle.
G100A01A
Drain plug
Filler plug
!WARNING:
o Windscreen washer fluid agents contain some amounts of alcohol and can be flammable under cer-tain circumstances. Do not allow sparks of flame to contact the washer fluid or the washer fluidreservoir. Damage to the vehicle or its occupants could occur.
o Windscreen washer fluid is poi- sonous to humans and animals.Do not drink windscreen washer fluid. Serious injury or death could occur.
fcuk-6.p65 12/27/2006, 10:16 AM
18

6
OWNER MAINTENANCE
19
G110A02E-EAT
AUTOMATIC TRANSAXLE FLUID
The automatic transaxle fluid level should be checked and changed at those intervals prescribed in the main- tenance schedule. It is of paramountimportance that only the specified fluid is used when replenishing or changing the fluid. The use of other fluids mayirreparably damage the transaxle and invalidate the manufacturers warranty. In addition the ingress of dirt or lintmay prevent correct functioning of the transaxle and care must be exercised to prevent the ingress of such matter. NOTE: Automatic transaxle fluid is a red in color. As driving distance increases, the fluid color turns darkish red gradually. It is a normal conditionand you should not judge the need to replace based upon the changing color.You must replace the automatictransaxle fluid in accordance withintervals specified in the vehicle maintenance schedule in section 5. CAUTION:
The transaxle on fluid level must be
checked with the engine running and at normal operating tempera-ture and therefore care must be ex- ercised to prevent injury occurring through contact with rotating or hotparts of the engine.
! G110B04A-AAT Recommended Fluid Your Hyundai automatic transaxle is specially designed to operate with HYUNDAI GENUINE ATF SP III, DIA- MOND ATF SP-III, SK ATF SP III orother brands approved by Hundai Mo- tor Co,. Damage caused by a nonspecified fluid is not covered byyour new vehicle limited warranty.
CAUTION:
Use of aftermarket ATF additives may cause damage to the automatic transaxle. Only use HYUNDAI GENU-INE ATF SP III, DIAMOND ATF SP III, SK ATF SP III or other brands approved by Hyundai Motor Co., Ifyou are having your vehicle ser- viced at a facility other than a Hyundai authorised repairer, verifythat the correct ATF is used for your vehicle.
!
fcuk-6.p65 12/27/2006, 10:16 AM
19

6 OWNER MAINTENANCE
20
G100B03A-GAT
Checking the automatic transaxle fluid level
The automatic transaxle fluid level
should be checked regularly.
Keep the vehicle on the level ground
with the parking brake applied and check the fluid level according to thefollowing procedure. HFC5008
G110C01FC-EAT
Fluid Capacity
The total fluid capacity of the trans-mission unit is 6.1 litres (1.6 DOHC)/ 6.7 litres(1.8 DOHC).
! CAUTION:
The transaxle fluid level should be checked when the engine is at nor-mal operating temperature. This means that the engine, radia- tor, exhaust system etc., are very hot so you should exercise great care not to burn yourself during thisprocedure. 1. Place the selector lever in N (Neu-
tral) position and confirm the engineis running at normal idle speed.
2. After the transaxle is warmed up
sufficiently (fluid temperature70~80°C (158~176°F)), for example by 10 minutes usual driving, shift the selector lever through all posi-tions then place the selector lever in N (Neutral) or P (Park) position.
fcuk-6.p65 12/27/2006, 10:16 AM
20

6
OWNER MAINTENANCE
21
!
3. Confirm that the fluid level is in
“HOT” range on the level gauge. If the fluid level is lower, add the specified fluid from the fill hole. If the fluid level is higher, drain thefluid from the drain hole.
4. If the fluid level is checked in cold condition (fluid temperature 20~30°C (68~86°F)) add the fluid to “COLD” line and then recheck the fluid levelaccording to the above step 2. WARNING:
The cooling fan is controlled by engine coolant temperature and may sometimes operate even when theengine is not running. Use extreme caution when working near the blades of the cooling fan so thatyou are not injured by a rotating fan blade. As the engine coolant tem- perature decreases, the fan will au-tomatically shut off. This is a nor- mal condition.
!
Fluid level should be within this range
C090A03FCWARNING (Diesel only):
Never work on injection system with engine running or within 30 sec- onds after shutting off engine. Highpressure pump, rail, injectors and high pressure pipes are subject to high pressure even after the enginestopped. The fuel jet produced by fuel leaks may cause serious injury, if it contacts the body. People using pacemakers should ensure that they keep a distance of 30cm from the ECU or wiring har-ness within the engine room whilst engine is running, since the high currents in the Common Rail sys-tem produce considerable magnetic fields.
fcuk-6.p65 12/27/2006, 10:16 AM
21

6 OWNER MAINTENANCE
22
SG120D1-E
Brake Fluid Level
HFC5005
Petrol engine
G120D02FC
Diesel engine
The fluid level in the brake fluid reser-
voir should be checked periodically. The level should be between the "MIN" and "MAX" marks on the side of thereservoir. If the level is at or below the "MIN" mark, fluid should be added having carefully cleaned the area sur-rounding the reservoir cap to ensure that dirt is not allowed to enter the system. It should be noted that thebrake fluid level will decrease slightly as the friction linings of the pads and shoes become worn and that this is anormal condition.
BRAKE SYSTEM CHECKING
SG120A1-E
CAUTION:
Correct operation of the braking
system is essential to the safe op- eration of the vehicle and therefore, any maintenance operations other than those listed below should beentrusted to a Hyundai authorised repairer.
!
SG120C2-E
Brake Fluid Recommendations
Only brake fluid conforming to DOT 3
or DOT 4 specifications or higher may be used in the braking system. Care should be taken to observe the in- structions and precautions printed uponthe container.
fcuk-6.p65 12/27/2006, 10:16 AM
22

6
OWNER MAINTENANCE
23
!WARNING:
Brake fluid is hygroscopic and should never be stored in an un- sealed container. The presence ofwater in the braking system will cause vapour locks and increase the possibility of brake fade alongwith promoting corrosion within the braking system. The brake fluid must be changed at the specifiedtime or mileage interval to ensure continued safe operation of the sys- tem. Brake fluid will cause rapidand serious damage to paintwork. If accidental spillage occurs, the af- fected area must be rinsed withwater immediately. Do not allow brake fluid to come into contact with the eyes or to be ingested andensure that fluid is safely stored away form the reach of children.
CHECKING THE CLUTCH FLUID
The system should be checked for leakage at the same time.Ensure that the clutch fluid level is
always between the "MAX" and "MIN"level markings on the fluid reservoir.Fill as required. Fluid loss indicates a leak in the clutch system which should be inspected and repaired immediately.
SG130A1-C To Check the Clutch Fluid
Petol engine
Diesel engine HFC5005
G120D02FC
The clutch fluid level in the master
cylinder should be checked when per- forming other under bonnet checks.
fcuk-6.p65 12/27/2006, 10:16 AM
23

6 OWNER MAINTENANCE
24AIR CONDITIONING SYSTEM MAINTENANCE
SG140A1-E
Condenser
Ensure that the condenser is periodi- cally inspected and that accumula- tions of dirt, dead insects and leaves etc, are removed to ensure that theefficiency of the system is not im- paired. Care must be exercised to ensure that the condenser fins are notdamaged during cleaning.
SG140C2-E
Checking the Refrigerant
1. Start the engine and run at idle for
several minutes with the refrigera- tion system running at the coldest setting.
2. If the air coming out of the in-dash
vents is not cold, have the air con-ditioning system inspected by your Hyundai authorised repairer.
CAUTION:
Running the air conditioning sys- tem with a low refrigerant level maydamage the compressor.
! SG140D1-E
Off Season Maintenance
The air conditioning must be run for
ten minutes or so weekly during peri- ods when the system would not nor- mally be used to ensure that the com-pressor and seals are lubricated. If this precaution is not observed the compressor seals may become stuckto the compressor shaft and damaged when the system is next used result- ing in a loss of refrigerant and damageto the compressor.
!
SG130B2-E
Adding Fluid
Recommended brake fluid conforming
to DOT 3 or DOT 4 should be used. The reservoir cap must be fully tight- ened to avoid contamination from for-eign matter or moisture.
CAUTION:
Brake fluid is hygroscopic and
should never be stored in an un- sealed container. Do not allow pe- troleum base fluid to contaminatethe brake fluid since damage to the rubber seals of the system may re- sult.
!
WARNING:
Brake fluid will cause rapid and serious damage to paintwork. If ac- cidental spillage occurs, the affected area must be rinsed with water im-mediately. Do not allow brake fluid to come into contact with the eyes or to be ingested and ensure thatfluid is safely stored away form the reach of children.
fcuk-6.p65 12/27/2006, 10:16 AM
24

6
OWNER MAINTENANCE
27
SG170A1-E
Brake Pedal
The brake pedal freeplay should be checked with the engine turned off.The pedal to floor clearance should be checked with the engine running and a load of 490 N applied to the pedal. Ifeither value is incorrect, the neces- sary adjustment should be performed by a Hyundai authorised repairer. Pedalto floor clearance: 1.97 in. (50 mm)
HXGS508
0.12 ~ 0.31 in. (3 ~ 8 mm)
SG190A1-E Petrol Engine The various engine drive belts must be checked for condition, tension and free-dom from damage and excessive wear. The tension of a new belt must be checked after thirty minutes runningfollowing fitment of the new belt to allow for the initial belt stretch. CHECKING DRIVE BELTS
Water Pump Pulley
Alternator Pulley
Crankshaft Pulley 0.2~0.24 in.(5.1~6 mm)
HTB186
G180A01A-GAT
CHECKING BRAKE PEDAL CLEARANCE
45.1 mm (1.78 in.)G180A01L
You need a helper to check the brake
pedal clearance. With the engine run- ning, have your helper press down on the brake pedal several times and then hold it down with a force of about 490N(50 kg, 110 lbs). The brake pedal clearance is the distance from the top surface of the brake pedal to the as-phalt sheeting under the floor mat. If the brake pedal clearance is not within the limits specified in the illustration,have it inspected by your Hyundai dealer and adjusted or repaired if nec- essary.
fcuk-6.p65 12/27/2006, 10:16 AM
27

6 OWNER MAINTENANCE
28
!
CHECKING AND REPLACING FUSES
SG200A1-E
Fusible Links
The fusible link prevents damage to
the wiring harness in the event of an electrical system malfunction. Failure of a fusiblelink is indicative of a seri- ous overload condition having occurredand therefore the electrical system should be checked by a Hyundai authorised repairer before a replace-ment link is fitted. WARNING:
Under no circumstances should a fusible link be replaced with any- thing other than a new link of thesame rating. The use of higher rated links or other means of connecting the circuit will create a potential firehazard.
Good
Bad
G200A01FC
G190B01TB-GAT Diesel Engine
At the scheduled maintenance inspec-
tion, belts should be examined for cracks, wear, fraying or other evi- dence of deterioration and replaced if necessary.
Belt routing should also be checked to
be sure there is no interference be-tween the belts and other parts of theengine.
G190B01A
Power steeringpump
A/C comp.
Auto tentioner fully
Alternator
fcuk-6.p65
12/27/2006, 10:16 AM
28