charging HYUNDAI TUCSON HYBRID 2023 Owner's Manual

01
1-29
Information
To control the temperature of the high
voltage battery while charging or when
the battery temperature is high, the air
conditioner is used to cool down the
battery. It may generate noise or vibration
from operation of the air conditioner
compressor and cooling fan, but it is a
normal condition when charging the high
voltage battery. Also, the air conditioner’s
performance may be degraded due to
operation of the cooling system to charge
the high voltage battery. This is a normal
condition.
Information
Even though charging is possible with
the Start/Stop button in the ON/START
position, for you safety, start charging
when the Start/Stop button is in the
OFF position and the vehicle shifted to P
(Park). After charging has started, you
can use electrical components such as the
radio by pressing the Start/Stop button to
the START or ON position.
During charging, the gear cannot be
shifted from P (Park) to any other gear.
OAEPHQ049818LOAEPHQ049818L
10. After charging has started, the estimated charging time is displayed
on the instrument cluster for about 1
minute.
If you open the driver seat door while
charging, the estimated charging time
is also displayed on the instrument
cluster for about 1 minute.
When scheduled charging is set, the
estimated charging time is displayed
as “--” .
Information
Depending on the condition and durability
of the high voltage battery, charger
specifications, and ambient temperature,
the time required for charging the battery
may vary.

Foreword/Starting your Hybrid/Plug-in hybrid vehicle1-30
Checking Charging Status
ONX4EPHQ011020LONX4EPHQ011020L
When charging the high voltage battery,
the charge level can be checked from
outside the vehicle.
Classification DetailsOperation of charging
indicator lamp
Mode Status Charging
inlet Charging
button
A READY N
on-charging
state 0 ~ 65 % On (Yellow) Off
65 ~ 100 % On (Green) Off
B Aux. Battery
Saver / High
voltage warning Charging the 12V auxiliary
battery / High voltage warning state On (Red) Off
C Charging Charging 0 ~ 65 %
Blinking
(Yellow) Off
65 ~ 100 % Blinking
(Green) Off
D Charging
complete Charging
completed (turns off in 5 seconds) 100 %
On (Green)
Ÿ
OFF Off
E Charging failed Error while charging Blinking
(Red) Off
F Scheduled
charging standby Reserved charging is operating
(turns OFF after 3 minutes) Off
ON
G Error CAN communication error
status On (Green)
Ÿ
On (Orange)
Ÿ On (Red) Off

01
1-31
Charging Status Indicator Lamp for Portable Charger
Control BoxIndicator Details
PLUG
(Green)
On : Power on
Blink : Plug temperature sensor failure
(Red)
On : Plug high temperature protection
Blink : Plug high temperature warning
POWEROn : Power on
CHARGEBlink : Charging in power saving mode, only the CHARGE indicator is illuminated.
FAULTBlink : Charging interrupted
CHARGE LEVELCharging current 12 A The charging current
changes (3 level) whenever
the button (1) is pressed
for 1 sec with the charger
plugged into an electrical
outlet but not the vehicle.
à Back of the control box
Charging current 10 ACharging current 18 A
VEHICLE
(Green)
Charging connector plugged
(Blue)
Charging
(Red)
Blink : Charging impossible

Foreword/Starting your Hybrid/Plug-in hybrid vehicle1-32
Charging Status Indicator Lamp for Portable ChargerNO Control Box Status / Diagnosis / Countermeasure NO Control Box Status / Diagnosis / Countermeasure1
• Charging connector plugged into vehicle (Green ON)
• Plug temperature sensor failure (Green blink)
• Plug high temperature protection (Red blink)
• Plug high temperature warning (Red ON)
Contact an authorized HYUNDAI dealer. 2

- Charging connector plugged into
vehicle (Green ON)
3
- While charging • Charge indicator (Green blink)
• Vehicle indicator (Blue ON) 4
- Before plugging charging connector
into vehicle (Red blink)
• Abnormal temperature
• ICCB (In-Cable Control Box) failure
Contact an authorized HYUNDAI dealer.

01
1-33
NO Control Box Status / Diagnosis / Countermeasure NO Control Box Status / Diagnosis / Countermeasure5

- Plugged into vehicle (Red blink)
• Diagnostic device failure
• Current leakage
• Abnormal temperature
Contact an authorized HYUNDAI dealer. 6

- After plugging charging connector into
vehicle (Red blink)
• Communication failure
Contact an authorized HYUNDAI dealer.
7
• Plug temperature sensor failure (Green blink)
• Plug high temperature protection (Red blink)
• Plug high temperature warning (Red ON)
Contact an authorized HYUNDAI dealer. 8
- Power saving mode
• 3 minutes after charging starts (Green blink)
Charging Status Indicator Lamp for Portable Charger

Foreword/Starting your Hybrid/Plug-in hybrid vehicle1-34
How to Disconnect Portable Charger
(ICCB: In-Cable Control Box)
1. Hold the charging connector handle and pull it out.
Information
To prevent charging cable theft,
the charging connector cannot be
disconnected from the inlet when the
doors are locked or the charging connector
is in the LOCK mode. Unlock all doors to
disconnect the charging connector from
the inlet.
However, if the vehicle is in the charging
connector AUTO mode, the charging
connector automatically unlocks from the
inlet when charging is completed.
If the charging connector is disconnected
while the release button is not pressed, the
connector and the inlet may be damaged.
For more details, refer to “Charging
Connector AUTO/ LOCK Mode” in this
chapter.
ONX4PHQ011030NONX4PHQ011030N
2. Make sure to completely close the charging door.
* The charging door dose not have a locking system.
OAEE046507NOAEE046507N
3. Disconnect the plug from the household electric outlet. Do not pull
the cable when disconnecting the
plug.
4. Close the protection caps of the charging connector and the charging
plug to protect them from foreign
substances.
5. If the personal charging connector is used, store the connector in the cable
compartment.
Unlock Charging Connector in
Emergency
ONX4EPHQ011004LONX4EPHQ011004L
If the charging connector does not
disconnect due to battery discharge and
failure of the electric wires, open the
liftgate and slightly pull the emergency
cable. The charging connector will then
disconnect.

01
1-35
Precautions When Using the
Portable Charger
• Use the portable charger that is certified by HYUNDAI.
• Do not try to repair, disassemble, or adjust the portable charger.
• If an extension cord is used it must be rated for heavy duty of at least 15A. Keep
as short as possible.
• Stop using immediately when failure occurs.
• Do not touch the plug and charging connector with wet hands.
• Do not touch the terminal part of the AC charging connector and the AC charging
port on the vehicle.
• Do not connect the charging connector to voltage that does not comply with
regulations.
• Do not use the portable charger if it is worn, if any of the wiring is exposed, or
if there are any signs of damage to the
cable or connector.
• Do not let children operate or touch the portable charger.
• Do not let the controller to be in contact with water.
• Keep the normal charging connector or plug terminal free of foreign substances.
• Do not step on the cable or cord. Do not pull the cable or cord and do not twist or
bend it.
• Do not attempt to charge the vehicle outside during inclement weather when
there is the possibility of lightning.
• Do not drop the controller or place heavy objects on the equipment.
• Do not place an object that can generate high temperatures near the charger when
charging. • Before plugging into any electrical outlet,
have a qualified electrician inspect and
verify the household electrical system for
heavy duty service at a 12 amp continuous
load.
• Stop using the portable charger immediately if the household electric
outlet or any components becomes
overheated or has a burning smell.

Foreword/Starting your Hybrid/Plug-in hybrid vehicle1-36
Trickle Charge (Type B)
„„Portable ChargerPortable Charger
ONE1Q011087LONE1Q011087L
(1) Code and Plug (Code set)
(2) Control Box
(3) Charging Cable and Charging Connector
Trickle charge can be used when
AC charge is not available by using
household electricity.
How to set the charge level of the
portable charger
OAEE046506NOAEE046506N
PlugPlugElectric OutletElectric Outlet
1. Check the rated current of the electric outlet prior to connecting the plug to
the outlet.
2. Connect the plug to a household electric outlet.
3. Check the display window on the control box.

01
1-37
„„Ready stateReady state
ONX4EPHQ011005LONX4EPHQ011005L

„„Charging stateCharging state
ONX4EPHQ011006LONX4EPHQ011006L
ONX4EPHQ011024LONX4EPHQ011024L
4. In ready or charging state where the
Fault indicator does not blink, press the
button (1) on the control box for more
than 2 seconds to adjust the charge
level. (Refer to charging cable type and
example for setting the charge level.)
5. The display window on the control box changes From 6A and 8A and 10A to
12A every time you press the button (1).
6. When the charge level you want is displayed in the display window, press
the button (1) on the control box for
more than 1 second to apply the desired
charge level. If you do not press the
button within 10 seconds, it will return
to the previously set charge level.
7. When setting the charge level is complete, start charging according to
the trickle charge procedure.

à Example for setting the ICCB charge level (The example is only for reference and
may vary according to the surrounding environment.)
Outlet current ICCB charge level Control box display window
14-16A 12A
ONX4EPHQ011007LONX4EPHQ011007L
13-12A10A
11-10A 8A
9-8A 6A

Foreword/Starting your Hybrid/Plug-in hybrid vehicle1-38
How to Connect Portable Charger
(ICCB: In-Cable Control Box)
OAEE046506NOAEE046506N
PlugPlugElectric OutletElectric Outlet
1. Connect the plug to a household electric outlet.
ONX4EPHQ011005LONX4EPHQ011005L
2. Check if the power lamp (green) illuminates on the control box.
3. Depress the brake pedal and apply the parking brake.
4. Turn OFF all switches, shift to P (Park), and turn OFF the vehicle.
ONX4EPHQ011022LONX4EPHQ011022L
5. Press center edge of the charging door to open the charging door.
Information
If the charging door does not open because
ice has formed around it, tap lightly or
push on the door to break the ice and
release the door. Do not pry on the door. If
necessary, spray around the door with an
approved deicer fluid (do not use radiator
antifreeze) or move the vehicle to a warm
place and allow the ice to melt.
6. Check if there is dust on the charging connector and charging inlet.
ONX4PHQ011028NONX4PHQ011028N
7. Hold the charging connector handle and connect it to the vehicle AC
charging inlet. Push the connector
until you hear a “clicking” sound. If
the charging connector and charging
terminal are not connected properly,
this may cause a fire.