key fob INFINITI QX80 2014 Quick Reference Guide

8
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent Key system allows you to lock
or unlock your vehicle, open your liftgate and start the
engine. It is important to make sure the Intelligent Key
is with you (that is, in your pocket or purse).
REMOTE ENGINE START*
The remote engine start system must be enabled in
the vehicle settings within the vehicle information display.
The remote engine start operating range is approximately
200 ft (60 m) from the vehicle. The effective operating range
may be shorter due to environmental conditions or obstacles
between you and the vehicle.
For the remote engine start to function, the vehicle must be
in the P (PARK) position with the ignition off, and all the doors
closed and locked.
To start your vehicle remotely:



1.

Press the button
02
2. Within 5 seconds press and hold the remote engine start

button
06 for at least 2 seconds.

The engine will start and the parking lights will turn on.
Automatic climate control will begin heating or cooling the vehicle depe\
nding on the
last used mode.
The engine will run for 10 minutes and then turn off.
Repeat steps 1 and 2 to extend the time for an additional 10 minute peri\
od.
•


After two remote starts the ignition switch must be cycled before the re\
mote start can


be used again.
To start driving depress the brake pedal and push the ignition switch START/STOP button.
To lock the vehicle, push either door handle request switch 01 once or press the button
02 on the key fob.
To unlock the vehicle, perform one of the following procedures:



•

Push either door handle request switch 01 once; the corresponding door will unlock. Push
the door handle request switch
01 again within 1 minute; all other doors will unlock, or



•


Press the button 03 on the key fob to unlock the driver’s side door. Press the button
again; all other doors will unlock.
To open the liftgate, press the button 04 for more than 1 second.
The Intelligent Key can also be used to activate the panic alarm by pres\
sing and holding
the
button 05 for more than 1 second. Once activated, the panic alarm and headlights
will stay on for a period of time.
01
06
02
03
04
05
1591592_14b_Infiniti_QX80_QRG_093013.indd 89/30/13 9:35 AM

10
first drive features
Front Seat Adjustments
To slide the seat forward or backward, push the
control switch
01 forward or backward.
To recline the seatback, push the switch 02
forward or backward.
SEAT LIFTER
To raise or lower the front portion or height of
the seat, push the front or back end of the switch
01 up or down.
LUMBAR SUPPORT

To adjust the seat lumbar support, push the front or back end of the swi\
tch 03.
For more information, refer to the “Safety —— seats, seat belts and supplemental restraint system (section 1)”\
of your
Owner’s Manual.
010203
Automatic Drive Positioner
Two positions for the driver’s seat, steering column
and outside mirrors can be stored in the automatic
drive positioner memory.
Follow these procedures to set the memory positions:



•

Confirm the shift lever is in the
P (PARK) position.



•

Push the ignition switch to the
ON position.



•

Adjust the driver’s seat, steering column and outside mirrors to the \
desired positions
using the adjusting switches for each feature.



•
Push the SET switch and within 5 seconds, push the memory switch (1 or 2) for at
least 1 second.



•

The indicator light on the memory switch you select will illuminate for \
approximately
5 seconds.



•

The driver’s seat, steering column and outside mirror positions are n\
ow set to
your preference.
These memorized positions can also be linked to your INFINITI Intelligen\
t Key. To link a
memorized position to your INFINITI Intelligent Key, press the unlock bu\
tton on the key fob
after completing the previous step.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
1591592_14b_Infiniti_QX80_QRG_093013.indd 109/30/13 9:35 AM