clutch ISUZU AXIOM 2002 Service Repair Manual

10A±2
CRUISE CONTROL SYSTEM
2 . RESUME/ACCEL Switch Function
1.Resume Function: When the RESUME, ACCEL
switch is turned on/off after the system is temporarily
deactivated by pressing the brake or clutch pedal
while the vehicle is running, the vehicle resumes, the
speed stored before the system was released.
2.Accelerate Function: When the RESUME/ACCEL
switch is kept on after the system is released
completely, the vehicle accelerates its speed during
that time. The vehicle speed at which the vehicle was
running when the switch was turned off is stored in the
memory, and the vehicle automatically returns to this
speed.
3.Tap±Up Function: When the RESUME/ACCEL
switch is turned on and off instantaneously while the
vehicle is running, the vehicle accelerates a mile for
each on/off operation. The vehicle speed at which the
vehicle was running when the switch was turned off
last is stored in the memory, and the vehicle
automatically returns to this stored speed.
3 . CANCEL Function
1.Temporary Cancellation:

When the cancel switch is turned on.

When the brake pedal is pressed.

When the clutch pedal is pressed. (M/T)

When the select lever is shifted to any position other
than ªDº, ª3º, ª2º or ªLº. (A/T)

When the vehicle speed has decreased about 12.5
mph (20 km/h) or more than the stored speed.

When the vehicle speed gets lower than 22.5 mph
(36 km/h).
2.Complete Cancellation:

When the starter switch or the main switch is turned
off.

When the failsafe function is activated.
Brake Switch
Removal and Installation
Refer to the Brake Pedal Replacement in Brake section.
Adjustment
1. Check that the brake pedal (3) is fully returned by
pedal return spring.
2. Disconnect the switch connector.
3. Loosen the lock nut (2).
4. Rotate the brake switch (1) by hand until push rod
disappears from brake switch tip (4).
5. Return the brake switch by a half turn.
6. Tighten the lock nut.
7. Connect the switch connector.
310RS028