charging ISUZU TROOPER 1998 Service Service Manual

ISUZU TROOPER 1998 Service Service Manual TROOPER 1998 ISUZU ISUZU https://www.carmanualsonline.info/img/61/57184/w960_57184-0.png ISUZU TROOPER 1998 Service Service Manual

Page 1109 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±18STARTING AND CHARGING SYSTEM
Charging System
General Description
The IC integral regulator charging system and its main
components are connected as shown in the illustration.
The regulator is a

Page 1110 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±19 STARTING AND CHARGING SYSTEM
Generator
Removal
1. Disconnect battery ground cable.
2. Move drive belt tensioner to loose side using wrench
then remove drive belt (1).
3. Disconnect the wire fr

Page 1111 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±20STARTING AND CHARGING SYSTEM
Disassembled View
066RW007
Legend
(1) Pulley Nut
(2) Pulley
(3) Front Cover Assembly
(4) Rotor Assembly
(5) Rear End Cover(6) Rectifier
(7) Terminal Insulator and N

Page 1112 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±21 STARTING AND CHARGING SYSTEM
Disassembly
1. Terminal insulator and nut(2).
2. Remove three nuts(1) on the rear cover and a nut on
terminal B and insulator, then remove the rear
cover(3).
060RW

Page 1113 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±22STARTING AND CHARGING SYSTEM
6. Secure the pulley directly in the vise between two
copper plates, and remove the nut and pulley.
066RS010
7. Remove four nuts(8) that secure the front cover
asse

Page 1114 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±23 STARTING AND CHARGING SYSTEM
Inspection and Repair
Repair or replace necessary parts if extreme wear or
damage is found during inspection.
Rotor Assembly
1. Check the rotor slip ring surfaces

Page 1115 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±24STARTING AND CHARGING SYSTEM
Stator Coil
1. Measure resistance between respective phases.
2. Measure insulation resistance between stator coil
and core with a mega±ohmmeter.
If less than stand

Page 1116 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±25 STARTING AND CHARGING SYSTEM
1. Using a press with a socket wrench attached,
reassemble rotor and rear end cover assembly in the
front cover.
066RS022
2. Install pulley on the rotor.
Secure th

Page 1117 of 3573

ISUZU TROOPER 1998  Service Service Manual 6D3±26STARTING AND CHARGING SYSTEM
Main Data and Specifications
General Specifications
Parts Number (Nippon denso)102211Ð5030
ModelACHD04
Rated voltage12 V
Rated output75 A
Rotating direction (As vi

Page 1415 of 3573

ISUZU TROOPER 1998  Service Service Manual 6E±298
ENGINE DRIVEABILITY AND EMISSIONS
4. Remove the MAP sensor from the mounting bracket.
055RW002
Installation Procedure
1. Install the MAP sensor in the mounting bracket.
055RW002
2. Install the