Tire JAGUAR XJ 2004 X350 / 3.G Owners Manual

Before Driving 3 - 13
Inertia reel mechanism check
Static test: Whilst seated, fasten the seat
belt and grip the shoulder belt at
approximately shoulder level with the
opposite hand. Pull the belt sharply
downwards, the belt should lock.
Road test: The following road test must
be carried out only under maximum safe
road conditions.
With the seat belt correctly fitted to the
driver and passenger(s), drive the vehicle
at 5 mph (8 km/h) and, ensuring that it is
safe to do so, brake sharply.
The seat belt(s) should lock automatically,
holding both driver and passenger(s)
securely in position.
It is important when braking that the
reactions of both driver and passenger(s)
are normal, that is, the body must not be
thrown forward in anticipation, thus
causing a snatching action of the belt
which would operate the locking
mechanism.
If the belt fails to lock on either test,
consult a Jaguar Retailer.
!WARNING:
1. Seat belts are designed to bear upon the bony structure of the
body. The lap section of the belt
must be worn low across the front
of the pelvis and NOT across the
abdominal area. Always ensure
that the webbing is midway
between the neck and the edge of
the shoulder.
2. Care should be taken to avoid contamination of the webbing
with polishes, oils and chemicals,
and particularly battery acid.
Cleaning may safely be carried out
using mild soap and water.
If webbing becomes frayed,
contaminated or damaged,
discard it and fit a new seat belt.
3. It is essential to renew the entire assembly after it has been worn in
a severe impact even if damage to
the assembly is not obvious. 4. Belts should not be worn with the
webbing twisted.
5. Each seat belt assembly must only be used by one occupant; it is
dangerous to put a seat belt
around a child being carried on
the occupant’s lap.
6. No modifications or additions s h o u l d b e m a d e b y t h e u s e r w h i c h
will prevent the seat belt adjusting
devices from operating.
7. Should the seat belt not retract and remain at its static length,
consult your nearest Jaguar
Retailer immediately.

Before Driving 3 - 33
Luggage Compartment
!WARNING:
1. Locate heavy loads in the luggage compartment towards the front of
the vehicle and secure them to
stop them sliding. Loose items can
be a hazard.
2. Do not drive wi th the luggage
compartment lid open as exhaust
fumes can be drawn into the
passenger compartment.
Luggage Tie-down Loops
Four loops are positioned in the luggage
compartment for attaching straps to
secure loads and prevent them from
sliding over the luggage floor.
These loops are not to be used for
securing passengers or animals nor as
anchorages for child restraints.
It is advisable to distribute luggage weight
evenly over the entire luggage floor area.
A range of Jaguar storage accessories,
including a luggag e retaining net,
are available from your Retailer.

Maintenance 7 - 19
Wear
All tyres fitted as original equipment
include tread wear indicators (TWI) in
their tread pattern. When the tread has
worn to a remaining depth of 1.6 mm the
indicators appear at the surface as bars
which connect the tread pattern across
the full width of the tyre.
It is illegal, in certain countries,
to continue to use tyres after the tread
has worn to less than 1.6 mm over three
quarters of the width and the entire
circumference of the tyre.It should be noted that the properties of
many tyres alter progressively with wear.
In particular the ‘wet grip’ and
aquaplaning resistance are gradually but
substantially reduce
d. Extra care and
speed restriction should therefore be
exercised on wet roads as the effective
tread depth diminishes.
Incorrect wheel alignm ent will accelerate
tyre wear. Fins on the inner or outer
edges of the tread pattern are caused by
excessive toe-in or toe-out respectively.
As fins may also be caused by high
cornering speeds or road camber, it is
advantageous to have the cause detected
by having the wheel alignment checked.
Tyre repair
It is recommended that damaged tyres
are discarded and new tyres fitted.
They must not be repaired in view of the
high performance capability of the
vehicle. Damage
Excessive local distortion can cause the
casing of a tyre to
fracture and may lead
to premature failure. Tyres should be
examined especially for cracked walls,
exposed cords, etc. Flints and other sharp
objects must be removed from the tyre
tread; if left in they may work through the
cover. Clean off any oil or grease
contamination by using a suitable
cleaner.
Caution: Do not use paraffin
(kerosene), because this has a
detrimental effect on rubber.
Tyre use after vehicle storage
After a long period of a vehicle standing,
tyres may become locally distorted with a
flat area. This will cause an uneven ride
for a few miles until the tyres have
warmed up and the ‘flat’ rounds off.
However, to reduce the effects of
flat-spots, the tyres of a stored vehicle
may be inflated to pressures not
exceeding 60 lbf/in² (4.2 bar, 420 kPa,
4.3 kg/cm²).