instrument cluster JEEP CHEROKEE 1988 Service Repair Manual

[x] Cancel search | Manufacturer: JEEP, Model Year: 1988, Model line: CHEROKEE, Model: JEEP CHEROKEE 1988
Pages: 1378, PDF Size: 19.9 MB

Page 94 of 1378

$JEEP CHEROKEE 1988 Service Repair Manual \ \b\ \ \ \ \ \ g grams$

\
\b\
\
\
\
\
\

g grams

GND or GRND Ground

GRN Green

GRY Gray

Ga. Gauge

Gals. gallons

Gov. Governor

\
\
\
\
\
\
\
\f

"H" ABBREVIATION TABLE
"H" ABBREVIATION TABLE\
\
\
\
\
\
\

ABBREVIATION DEFINITION

\
\b\
\
\
\
\
\

H/D Heavy Duty

HAC High Altitude Compensation

HC Hydrocarbons

HEDF High Speed Electro Drive Fan relay or circuit

HEGO Heated Exhaust Gas Oxygen Sensor

HEGOG HEGO Ground circuit

HEI High Energy Ignition

HLDT Headlight

HO High Output

HP High Performance

HSC High Swirl Combustion

HSO High Specific Output

HTR Heater

HVAC Heating

Headlt. Headlight

Hg Mercury

Hgt. Height

Htr. Heater

Hz Hertz (Cycles Per Second)

\
\
\
\
\
\
\
\f

"I" ABBREVIATION TABLE
"I" ABBREVIATION TABLE\
\
\
\
\
\
\

ABBREVIATION DEFINITION

\
\b\
\
\
\
\
\

I.D. Inside Diameter

IAC Idle Air Control

IACV Idle Air Control Valve

IC Integrated Circuit

ID Identification

IDM Ignition Diagnostic Monitor

IGN Ignition system or circuit

ILC Idle Load Compensator

In. Hg Inches of Mercury

INCH Lbs. Inch Pounds

INFL REST Inflatable Restraint

INJ Injector or Injection

IP Instrument Panel

IPC Instrument Panel Cluster

ISA Idle Speed Actuator

ISC Idle Speed Control

ISS Idle Stop Solenoid

ITS Idle Tracking Switch

IVSV Idle Vacuum Switching Valve

Page 505 of 1378

JEEP CHEROKEE 1988 Service Repair Manual Oxygen Sensor (Graphic 1) In exhaust manifold, near
exhaust pipe flange.
Oxygen Sensor (Graphic 2) In exhaust manifold, near

Page 829 of 1378

JEEP CHEROKEE 1988 Service Repair Manual 1 - 25 Amp
Rear Washer/Wiper.
2 - 15 Amp
Radio, Cigarette Lighter.
3 - 25 Amp
Blower Motor.
4 - 20 Amp
Turn Signal, Back-Up L

Page 895 of 1378

$JEEP CHEROKEE 1988 Service Repair Manual \003 IN STR UM EN T P A N EL - S TA N DAR D 1988 J e ep C hero ke e 1988 Switches & Instrument Panels JEEP DESCRIPTION & OPERATION Instrument panel is compose$

\003
IN STR UM EN T P A N EL - S TA N DAR D

1988 J e ep C hero ke e
1988 Switches & Instrument Panels
JEEP
DESCRIPTION & OPERATION
Instrument panel is composed of speedometer housing,
tachometer and instrument cluster gauges.
FUEL GAUGE
System consists of a fuel gauge, an in-tank sending unit, and
appropriate wiring. Fuel gauge is grounded through variable resistor
of sending unit. A float attached to a slide rheostat follows fuel
level and varying resistance increases or decreases indicator reading.
TEMPERATURE GAUGE
System consists of gauge and sending unit and appropriate
wiring. The gauge is grounded through variable resistor of sending
unit. Changes in coolant temperature vary resistance in sending unit,
increasing or decreasing indication on gauge.
VOLTMETER
The voltmeter indicates regulated voltage to provide an
indication of charging system's ability to maintain battery charge.
OIL PRESSURE GAUGE
The oil pressure gauge system consists of gauge and a
variable resistance sending unit. Gauge needle, attached to bi-
metallic strip, responds to temperature changes.
REMOVAL & INSTALLATION
INSTRUMENT CLUSTER
Removal & Installation
1) Disconnect negative battery cable. On models with cruise
control, reach behind instrument cluster and disconnect speedometer
cable from speed switch. See Fig. 1.
2) On models without cruise control, raise vehicle on hoist.
Disconnect speedometer cable from transfer case (or transmission) and
at frame rail bracket. Move speedometer cable forward and upward to
provide slack. Lower vehicle.
3) On all models, remove instrument panel bezel screws and
bezel. Remove screws attaching cigarette lighter and switch housings
to instrument panel. Move housings aside.
4) Remove screws attaching cluster to instrument panel and
carefully pull cluster and speedometer toward rear of vehicle.
Disconnect wiring harness connectors.
5) Squeeze speedometer cable locking tabs and disconnect
cable from speedometer. See Fig. 1. Remove instrument cluster. To
install, reverse removal procedure.

Page 897 of 1378

JEEP CHEROKEE 1988 Service Repair Manual Removal & Installation
Remove and disassemble instrument cluster. Remove
speedometer, tachometer, or gauge being serviced. To install, reverse
removal procedure.

Page 920 of 1378

Page 921 of 1378

JEEP CHEROKEE 1988 Service Repair Manual MAIN TE N AN CE R EM IN DER L IG HT R ESET P R O CED URES

1988 J e ep C hero ke e
1988-92 MAINTENANCE
Chrysler Motors Maintenance Reminder Lights
Jeep; Cherokee, Com

MAIN TE N AN CE R EM IN DER L IG HT R ESET P R O CED URES

1988 J e ep C hero ke e
1988-92 MAINTENANCE
Chrysler Motors Maintenance Reminder Lights
Jeep; Cherokee, Comanche, Wagoneer (1988-90), Wrangler
EMISSION MAINTENANCE INDICATOR LIGHT (1988-90)
Vehicles are equipped with an emission maintenance indicator
light on instrument cluster. This light will come on one time at 82,
500 miles to alert driver that emission service is required. At this
time, oxygen sensor and PCV valve must be replaced and all other
emission components should be inspected and serviced or replaced as
necessary.
Indicator timer is located under dash, near accelerator pedal
or to right of steering column. Timer cannot be reset. To turn off
light, timer must be replaced or disconnected. Since timer and sensor
are interdependent, if timer should fail prematurely, oxygen sensor
should be replaced at same time to preserve correct replacement
interval.
To replace timer on Cherokee, Comanche and Wagoneer models,
remove cruise control module (if equipped). Remove timer mounting
screws. Disconnect electrical connector. On Wrangler models, remove
timer mounting screws. Disconnect electrical connector. On all models,
install remaining components.
EMISSION MAINTENANCE INDICATOR LIGHT (1991-92)
Vehicles are equipped with an emission maintenance indicator
light on instrument cluster. This light will come on one time at 82,
500 miles to alert driver that emission service is required. At this
time, oxygen sensor must be replaced and all other emission components
should be inspected and serviced or replaced as necessary. Chrysler's
Diagnostic Readout Box (DRB-II) tester is required to reset the
emission maintenance indicator light.
Reset Procedure
Using DRB-II tester, access SELECT SYSTEMS. Select
appropriate engine. Select with or without A/C. Select FUEL &
IGNITION. Select ADJUSTMENTS. Select RESET EMR LIGHT. Reset EMR light.
When DRB-II is finished resetting light, DRB-II display will read EMR
LIGHT IS RESET.

Page 1369 of 1378

JEEP CHEROKEE 1988 Service Repair Manual WIR IN G D IA G RAM S

1988 J e ep C hero ke e
1988 Wiring Diagrams
Jeep
Cherokee & Wagoneer
IDENTIFICATION
COMPONENT LOCATION MENU
COMPONENT LOCATI

WIR IN G D IA G RAM S

1988 J e ep C hero ke e
1988 Wiring Diagrams
Jeep
Cherokee & Wagoneer
IDENTIFICATION
COMPONENT LOCATION MENU
COMPONENT LOCATIONS TABLE\
\
\
\
\
\
\

Component Figure No. (Location)
A/C & Htr Systems ............................... 5 (A-D 16-19)
Alternator ............................................ 1 (C 3)
Audio Alarm Module ................................... 7 (D 27)
Back-Up Lt Sw (M/T) .................................. 4 (D 12)
Battery ............................................... 1 (A 2)
Beam Sel Sw .......................................... 6 (E 23)
Brake Warning Sw ..................................... 6 (C 20)
Clock ................................................ 7 (E 27)
Clutch Switch ........................................ 4 (E 15)
Courtesy Lights ................................... 7 (C 24-26)
Cruise Ctrl Sys ................................... 4 (E 12-15)
Diag Conn D1 (2.5L) ................................... 3 (B 9)
Diag Conn D1 (4.0L) ................................... 2 (B 4)
Diag Conn D2 (2.5L) .................................. 3 (B 11)
Diag Conn D2 (4.0L) ................................... 2 (B 7)
DIR Hazard Sw ................................... 6 (D-E 20-21)
Door Switches ........................................ 7 (C 27)
Elect Ctrl Unit (2.5L) ............................. 3 (A 9-10)
Elect Ctrl Unit (4.0L) .............................. 2 (A 4-7)
Engine Compartment Lt ................................. 1 (C 1)
Fog Light Relay ....................................... 1 (D 2)
Fog Light Sw ...................................... 6 (E 21-22)
Fuel Pump Rly (2.5L) .................................. 3 (C 9)
Fuel Pump Rly (4.0L) ................................ 2 (E 5-6)
Fuel Tank Unit ....................................... 6 (B 20)
Fus Links ........................................... 1 (B 2-3)
Fuse Block ...................................... 4 (B-D 12-15)
4WD Switch ..................................... 6 (C 20, D 21)
Gear Sel Sw .......................................... 5 (C 16)
Glove Box Light ...................................... 7 (C 25)
Headlight Delay Module ............................... 6 (E 23)
Headlight Switch .................................. 6 (D 22-23)
Horn Relay ............................................ 1 (C 2)
Ignition Ctrl Mod (2.5L) ............................ 3 (B-C 8)
Ignition Ctrl Module (4.0L) ........................... 2 (E 4)
Ignition Key Warn Sw ................................. 7 (D 26)
Ignition Switch ................................... 4 (A 12-15)
Illum Lights .................................... 7 (C-D 24-25)
Instrument Cluster .............................. 6 (A-C 22-23)
Keyless Entry Module .............................. 7 (B 24-25)
Latch Rly (B+) (4.0L) ............................... 2 (B-C 4)
Power Antenna Rly .................................. 7 (D-E 27)
Power/Comfort Sw ..................................... 5 (D 19)
Power Door Lock Sys ............................. 7 (A-C 24-27)
Power Mirror Sw ................................. 7 (D-E 24-25)
Power Seat Sw ................................... 8 (A-B 28-29)